非均勻流入 的英文怎麼說

中文拼音 [fēijūnyúnliúrù]
非均勻流入 英文
non-uniform inflow
  • 非 : Ⅰ名詞1 （錯誤） mistake; wrong; errors 2 （指非洲） short for africa 3 （姓氏） a surname Ⅱ動詞1 ...
  • 均 : Ⅰ形容詞（均勻） equal; even Ⅱ副詞（都; 全） without exception; all
  • 勻 : Ⅰ形容詞（均勻） even Ⅱ動詞1. （使均勻） even up; divide evenly 2. （分出一部分） spare
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
  • 流入 : inflow; influx; indraught流入角 fluid inlet angle; influx angle; 流入量 influx; inflow
  1. The deviation value was used to characterize the inhomogeneous degree of concentration fields, and the attenuation rate with time was used to characterize the injection dispersion performance of flow field

    以此方差近似表徵了示蹤劑濃度場的非均勻度，其衰減規律可用於定量描述振蕩流場的注入分散特性。
  2. A mathematical model of flows in the substrate was established using the equivalent continuum approach, and multi - dimensional numerical simulation of the steady flows in the catalytic converters was performed. simulation results show that the separation and vortex, which cause the pressure loss and the velocity non - uniformity at the front of the first substrate, are generated near the wall of the conical pipe. in addition, the larger the inlet cones angle the more the pressure loss and maldistribution in converters, however, when the angle enlarges enough the pressure loss would be decrease

    結果顯示氣流在擴張圓錐管壁附近出現分離產生較強的擾動，造成局部流動損失和載體前氣流速度沿徑向分佈不均勻；入口擴張管結構對催化器的流動特性有很大影響，但並非擴張角越大，催化器流速武漢理工大學碩士學位論文分佈的不均勻性和壓力損失也增大，而是存在著一個最佳角度，但當擴張角增大到一定程度以後，擴張角對流速分佈和壓力損失的影響變小。
  3. Considering the unsymmetrical distribution of interface states induced by hot - carrier effects along the channel, the quasi - two - dimensional analysis methods are used to deduced the drain current, threshold voltage and electrical field in channel after hot - carrier degradation and the theoretical results are fully verified with the experimental data and m1ntmos6. 0 simulation output. the degradations of device output conductance, subthreshold conduction and rf characteristics are also analyzed

    針對mos器件熱載流子退化所引入的界面態，根據其沿溝道非均勻分佈的模型，採用準二維分析方法對退化后器件的漏源電流、閾值電壓和飽和區溝道電場作了詳細的理論推導，並與實驗結果和器件二維數值模擬軟體minimos6 . 0的計算結果進行了驗證比較。
  4. In this paper, several typical roics, roic noise and processing techniques are analyzed systematically in theory, and the computer simulated experiments are done. in the third chapter, many performances are analyzed on typical cmos roic theoretically in detail, such as the non - uniformity, injection efficiency, bias steadiness, frequency characteristic and threshold - voltage non - uniformity

    本文第三章首先對典型致冷型cmos讀出電路的非均勻性、注入效率、偏置穩定性、注入電流的頻率特性以及閾值電壓非均勻性等問題進行了較為全面的理論分析和計算機模擬實驗研究。
分享友人
分享到 Line

分享到臉書