非均勻電路 的英文怎麼說

中文拼音 [fēijūnyúndiànlù]
非均勻電路 英文
non uniform circuit
  • 非 : Ⅰ名詞1 （錯誤） mistake; wrong; errors 2 （指非洲） short for africa 3 （姓氏） a surname Ⅱ動詞1 ...
  • 均 : Ⅰ形容詞（均勻） equal; even Ⅱ副詞（都; 全） without exception; all
  • 勻 : Ⅰ形容詞（均勻） even Ⅱ動詞1. （使均勻） even up; divide evenly 2. （分出一部分） spare
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. As umbirfpa is a new type of infrared detecting device, its work principle is complex and its performance is affected by many factors. in the initial stage of developing, the design experiment and theoretical understanding are little interiorly. furthermore, the problems such as sensitivity reduced, dynamic range shortened, nonuniformity increased come forth if umbirfpa is not designed properly

    Umbirfpa是一種新型的紅外探測器件，微測輻射熱計的工作原理復雜，其性能受到很多因素的影響，目前國內尚處于發展初期，缺少實際的設計經驗和理論認識，同時umbirfpa又是在集成電路工藝線上生產的，投資大、周期長，如果設計不當，不僅可能導致靈敏< wp = 13 >度降低、動態范圍縮小、噪聲增大、非均勻性增大等問題，更可能的是根本就不能用於成像，從而造成很大損失。
  2. The system can simulate the transfer process of photo - thermal and thermal - electric at a given parameter setting of structure, environment and circuit. on the basis of circuit structure, the calibration, parameter adjusting and signal readout can be simulated, the vary process of readout circuit, readout voltage, optical gain, optical gain rate, and uniformity can be given. in addition, all kinds of character parameters of device can be forecasted

    本論文根據umbirfpa的原理，建立它的軟體模擬系統，它可以根據給定的結構、環境、電路設置等參數首先模擬光熱、熱電轉換過程，並可根據電路結構，模擬校準、參數調節並讀出信號，給出讀出電流和電壓、光學增益、光學增益比、非均勻性等各特徵量的定量變化過程，預測製成后器件的各種性能參數。
  3. Using the microwave selective heating property for materials, by setup equivalent equation, and first time inducing the electromagnetic field perturbation theory to the design of heating materials for substrate in mpcvd, three temperature distribution modes were established, including temperature distribution comprehensive mode of inhomogeneous plasma, temperature distribution composite mode of composite substrate materials, temperature distribution perturbation mode of composite materials, which ii provided an whole new technology route to the design of substrate heating system in mpcvd and guided the preparation of heating materials for substrate. and then the heating materials for substrate were designed and optimized to obtain large area homogeneous temperature distribution even larger than substrate holder ' s diameter. as an important part, this thesis researched the nucleation and growth of diamond films in mpcvd, systematically researched the effects of substrate pretreatment, methane concentration, deposition pressure and substrate temperature etc experimental technologic parameters on diamond films " quality on ( 100 ) single crystal silicon substrate in the process of mpcvd, characterized the films qualities in laser raman spectra ( raman ), x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), infrared transmission spectra ( ir ), atomic force microscopy ( afm ), determined the optimum parameters for mpcvd high quality diamond in the mpcvd - 4 mode system

    該系統可通過沉積參數的精確控制，以控制沉積過程，減少金剛石膜生長過程中的缺陷，並採用光纖光譜儀檢測分析等離子體的可見光光譜以監測微波等離體化學氣相沉積過程；利用微波對材料的選擇加熱特性，通過構造等效方程，並首次將電磁場攝動理論引入到mpcvd的基片加熱材料的設計中，建立了非均勻等離子體溫度場綜合模型、復合介質基片材料的復合溫度場模型及復合介質材料溫度場攝動模型，為mpcvd的基片加熱系統設計提供了一條全新的技術路線以指導基片加熱材料的制備，並對基片加熱材料進行了設計和優選，以獲取大面積均勻的溫度場區，甚至獲得大於基片臺尺寸的均勻溫度區；作為研究重點之一，開展了微波等離體化學氣相沉積金剛石的成核與生長研究，系統地研究了在（ 100 ）單晶硅基片上mpcvd沉積金剛石膜的實驗過程中，基片預處理、甲烷濃度、沉積氣壓、基體溫度等不同實驗工藝參數對金剛石薄膜質量的影響，分別用raman光譜、 x射線衍射（ xrd ） 、掃描電鏡（ sem ） 、紅外透射光譜（ ir ） 、原子力顯微鏡（ afm ）對薄膜進行了表徵，確立了該系統上mpcvd金剛石膜的最佳的實驗工藝參數。
  4. The last effort in this paper is concentrated on the readout circuitry of microbolometer arrays, which is connected to the detector array on chip to form a monolithic chip, and the non - uniformity correction

    這一模擬軟體對微測輻射熱計的設計研製具有指導意義。研究了微測輻射熱計陣列讀出電路並進行了非均勻性校正。
  5. According to the structure of a electro - magnetic gear couple, this research paper analyzed the main magnetic circuit as well as derived the calculation formulas for its uneven working and assembling air - gap magnetic conduction

    摘要根據電磁齒輪的結構特點，分析了電磁齒輪傳動的主磁路，並推導出非均勻的工作氣隙磁場與裝配氣隙磁場磁導的計算公式。
  6. The fipwa based on electric integral equation ( efie ) is presented firstly, the green ’ s function expansion with sommerfeld identity ( based on bessel kernel ) is studied and the msdp for two cases is formulated. in order to improve the iteration property and avoid inner resonance, the combined field integral equation ( cfie ) fipwa is then constructed successfully

    首先研究了基於電場積分方程的快速非均勻平面波演算法，對索末菲恆等式（基於貝塞爾積分核）展開的格林函數進行了深入研究，分兩種情形解決了修正最陡下降路徑的設計問題。
  7. Based on kuroda ' s identities, parabolic lossless nonuniform transmission line ( ntl ) can be represented by the equivalent circuit consisting of lossless uniform transmission line and lumped elements

    科羅達等效方法可將拋物線型無損非均勻傳輸線用均勻傳輸線及若干集中參數元件組成的等效電路表示。
  8. Abstract : the nommiformity of solid state image sensor which degrades performance severely, even no signal can be detected must be corrected in the condition of present technology. in this paper, the cause of nonuniformity generation is analyzed. based on principle of ratio of performance to price and real time, one point and two point correction are used and their correction range are discussed. the hardware circuit sketch and result are presented

    文摘:分析了非均勻性產生的主要原因，基於性能價格比和實時快速的原則，採用一點和兩點法對固體圖像傳感器的非均勻性進行了校正並討論了系統的校正范圍，給出了用於實時校正的硬體電路框圖和實驗結果，取得了較滿意的校正效果。
  9. The paper studies the the flux uniformity of the outlet when ventilates at one end of vault in the main workshop of xiluodu underground hydropower station via the method of numerical simulation cfd, puts forward means which can achieve symmetrical ventilation, validates the cfd results credibility by the way of model experiment afterward

    本文採用cfd數值模擬的方法對溪洛渡地下電站主廠房拱頂一端送風的均勻性進行了研究，提出了實現均勻送風的手段，然後用相似模型實驗進行了驗證，並據此提出了均勻送風拱頂與非均勻送風拱頂的網路基元模型。
  10. For there are few good analytical methods in ntls ' sensitivity, in this paper, we uesd kuroda ' s equivalent circuit and adjoint network method to derive the sensitivity formulas of parabolic lossless ntl. and then we proposed the way of lumped loss, like the method of dealing with the loss in emtp, to deal with the loss of parabolic lossy ntl. and on the base of the way of lumped loss, we got the sensitivity formulas of parabolic lossy ntl

    對于非均勻線的靈敏度分析，目前尚未提出很好的方法。本文首先利用基於科羅達等效的等效電路，使用伴隨網路法推導出了無損拋物線型非均勻線的時、頻域靈敏度公式。其次，為了解決有損拋物線型非均勻線的靈敏度計算，提出了一種類似emtp的集中處理損耗的有損拋物線型非均勻線的方法。
  11. In this paper, several typical roics, roic noise and processing techniques are analyzed systematically in theory, and the computer simulated experiments are done. in the third chapter, many performances are analyzed on typical cmos roic theoretically in detail, such as the non - uniformity, injection efficiency, bias steadiness, frequency characteristic and threshold - voltage non - uniformity

    本文第三章首先對典型致冷型cmos讀出電路的非均勻性、注入效率、偏置穩定性、注入電流的頻率特性以及閾值電壓非均勻性等問題進行了較為全面的理論分析和計算機模擬實驗研究。
分享友人
分享到 Line

分享到臉書