面板插座 的英文怎麼說

中文拼音 [miànbǎnchāzuò]
面板插座 英文
panel jack
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  • 插 : 動詞1. （把細長或薄的東西放進、擠入、刺進或穿入; 插上; 插進） stick in; insert 2. （中間加進去; 加進中間去） interpose; insert
  • 面板 : [機械工程] face plate; panel; panel board; frontpanel; face ply [veneer]; surface veneer; skin pl...
  • 插座 : jack; receptacle; socket; plug base; plug in; plug receptacle; plug seat; outlet; rosette; shoe; ...
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。
  2. Provisions for standard booth : exhibitor ' s fascia board, three side boards, one business desk, two chairs, basic lighting, one electric outlet, and daily cleaning

    標準展臺配套設施包括：企業楣板、三面圍板、一桌兩椅、基本照明、電源插座一個、每日清潔服務。
  3. Standard booth : usd 2, 250 booth. standard booth includes partition walls, fascia board, socket, information counter, two chairs, two spotlights and carpet

    標準攤位包括：三面或兩面展板企業中英文名稱楣板兩只燈一個插座一張咨詢桌兩把椅子，地毯。
  4. Electronic components. connecting devices. multicontact edge socket and board mounted connectors for double clad printed boards with 2, 54 mm spacing. type he 9. general requirements

    電子元件.連接裝置.間距為2 . 54 mm的雙面印刷電路板用多觸點棱形插座和板上安裝式連接器. he 9型.一般要求
  5. Electronic components. connecting devices. multicontact edge socket and board mounted connectors for single clad printed boards with 2, 54 mm spacing. type he 7. general requirements

    電子元件.連接裝置.間距為2 . 54 mm的單面印刷電路板用多觸點棱形插座和板上安裝式連接器. he 7型.一般要求
  6. Open hole for side power input socket, 6mm thicknes

    ， 6mm鋁板，單側面輸入插座開孔
  7. The requirements for extension units consist of those for plugs, flexible cords and sockets as mentioned above

    拖板方面的要求是由符合上述特定安全規格的插頭、軟電線和插座所組成。
  8. Each booth is provided with one three - sided displaying board, two spot lights, one 5a / 220v electric socket, one negotiation table and two chairs

    展位配置：楣板一塊三面展板/兩只射燈/ 5a / 220v電源插座/洽談桌一張/座椅兩把。
  9. Detail specification for multi - contact edge socket electrical connectors - single or double sided, closed ended, replaceable contacts, through - board solder or wire wrap terminations - full assessment level

    多觸點邊緣插座電氣連接器詳細規范.單面或雙面閉端可替換觸點穿板焊接或線繞終端.全面評估級
  10. Installation of a roof, din socket installation, the installation of pcb sockets or face planting installation

    有頂部安裝din插座安裝pcb插座安裝或面板插座安裝
  11. Installed in a portable socket or adapter equipped with panel installation

    安裝在即插式插座上或配有面板安裝適配器
  12. Face mounting socket

    面板安裝式插座
  13. We provide the original track din socket, fast rotary screw inserted into the faceplate or installing sockets, pc board sockets installed, there are two types of industry - standard pin structure

    我們提供原始的din軌道插座快速插入式或螺絲釘旋入式面板安裝插座pc板安裝式插座，有兩種工業標準的pin結構。
  14. Din - rail installation and direct face - socket

    Din導軌式及面板直接安裝式插座
  15. Engraved in odio logo, open hole for side power input socket, 6mm thicknes

    ，雷射鵰刻odio logo ， 6mm鋁板，單側面輸入插座開孔
  16. Charges a standard booth 9m2 3m x 3m configuration : exhibition venues, three - display panels 2. 5m high, mei licensing production, a negotiating table and two chairs, a 220v power outlet, two searchlights

    收費標準1標準展位9m2 3m3m配置：展出場地三面展板2 . 5m高楣牌製作一張洽談桌二把椅子220v電源插座一個二支射燈。
  17. Detail specification for multi - contact edge socket electrical connectors - single or double sided, open ended, guide key location, replaceable contacts, through - board solder or wire wrap terminations - full assessment level

    多觸點邊緣插座插接器詳細規范.單面或雙面開式端導鍵定位可替換觸點穿板焊接或線繞終端.全面評估級
分享友人
分享到 Line

分享到臉書