面積缺陷試驗 的英文怎麼說

中文拼音 [miànquēxiànshìyàn]
面積缺陷試驗 英文
area defect test
  • : Ⅰ名詞1 (頭的前部; 臉) face 2 (物體的表面) surface; top 3 (外露的一層或正面) outside; the ri...
  • : Ⅰ動詞(積累) amass; store up; accumulate Ⅱ形容詞(長時間積累下來的) long standing; long pending...
  • : Ⅰ動詞1 (缺乏; 短少) be short of; lack 2 (殘缺) be missing; be incomplete 3 (該到而未到) be ...
  • : Ⅰ名詞1 (陷阱) pitfall; trap2 (缺點) defect; deficiency Ⅱ動詞1 (掉進) get stuck or bogged do...
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • 面積 : [數學] area
  • 缺陷 : defect; fault; faultiness; vitium; lesion; flaw; disorder; imperfection; drawback; blemish
  • 試驗 : trial; experiment; test
  1. Through the bonding tests and the theory analysis between the advanced composite glass sheets and the concrete under the general load - carrying condition, the iterative load - carrying condition, the freeze - thaw action, and the defective bonding, the calculative model has been established, and the numerical value of fibre sheet strain under different load - carrying has been confirmed. the bond strength calculative expressions for the concrete bonded with glass fibre sheet under the pull - shear and the bend load - carrying conditions have been established. the author put forward the decreasing coefficient and the calculative expressions for the influence of reinforce effect by the non - effective area and the calculative expressions for the influence of the freeze - thaw action on the carrying capacity of the concrete beams

    本文採用美國泰扶高強復合玻璃纖維布以及與之性能相當、由南京玻璃纖維研究院自行研製開發的egfw430型玻璃纖維布兩種材料,通過在靜載、重復荷載、凍融及有粘結條件下的高強玻璃纖維布與混凝土粘結性能的研究與理論分析,建立了玻璃纖維布-混凝土的粘結計算模型,明確了不同受力狀態下纖維布應變的設計取值,提出了玻璃纖維布-混凝土抗剪粘結強度的計算公式;確定了考慮非有效粘貼對加固效果影響的折減系數;給出了凍融循環次數引起承載力下降的插值計算方法;並證了重復荷載作用下玻璃纖維布與混凝土良好的粘結性能。
  2. Main research contents and achievements of this thesis is as follows : l. this paper carries through particular test and analysis to the basic physical - chemical properties of gaojiawang palygorskite, an environmental mineral fibre, by xay, ir, tem, sem etc. this paper has also discoursed upon the development appliance research status in quo and directions of palygorskite. 2. according to the preceding surface modification research achievements to nonmetal mineral materials, the author combines the self characteristics of palygorskite such as the ratio of length and diameter, typical nano - rank particle diameter, big ratio surface area, well - developed crystal growth imperfection and lattice defect etc. the author also designs organising modification ortho - experimentation of palygorskite by adopting iso - propyl alcohol as thinner of wd - 51 and ndz - 401, and acquires the best craft parameters and craft conditions for gaojiawang palygorskite original ore organising modification, namely : wd - 51 concentration 1. 6 % ( wt % ), modification temperature 120 ?, and modification time 60 mins ; ndz - 401 concentration 2. 0 % ( wt % ), c modification temperature 120, modification time 80 mins

    在前人對非金屬礦物材料表改性的基礎上,結合環境礦物纖維?坡縷石自身的特點(如:長徑比、典型的納米粒徑、大比表、發育的晶體生長和晶格等) ,通過對坡縷石有機化改性設計正交,採用( ch _ 3 ) _ 2choh作為稀釋劑,獲得了採用wd - 51和ndz - 401對高家窪坡縷石原礦進行有機化改性的最佳工藝參數和工藝條件,分別為: wd - 51的濃度為1 . 6 ( wt ) ,改性溫度為120 ,改性時間為60min ; ndz - 401的濃度為2 . 0 ( wt ) ,改性溫度為120 ,改性時間為80min 。
  3. In the research, the system captures real - time images based on the sdk, and saves the image data into buffers which are created by the system. the important and primary parts are got using the programs which are designed to process and analyze the image data in the buffers, and the geometrical features such as area, perimeter, moment invariants and fourier descriptor, are measured. the parts are classified according to the threshold of each geometrical feature with the image database

    課題研究中,在設計的平臺上,通過攝像頭和sdk開發包對零件進行實時圖像採集,並將其存入開辟的數據緩沖區內;由設計的圖形處理模塊對緩沖區內的數據採用各種演算法進行分析處理,形成研究中感興趣的重要圖像;調用圖像識別判斷模塊,主要提取了零件的周長,,慣性矩,傅立葉描繪子等形狀特徵參數,根據定義的識別函數,並結合圖像數據庫,進行零件識別或檢測。
分享友人