頻分調制 的英文怎麼說

中文拼音 [bīnfēndiàozhì]
頻分調制 英文
fdm frequency division modulation
  • 頻 : Ⅰ形容詞（次數多） frequent Ⅱ副詞（屢次） frequently; repeatedly Ⅲ名詞1 [物理學] （物體每秒鐘振動...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  1. This thesis focuses on the performance of complete complementary keying modulation and multi - carrier cdma architecture based on complete complementary codes ( ccc - cdma )

    本文主要研究了基於互補碼擴頻的cck調制性能和基於完全互補碼擴頻的多載波cdma系統性能，主要工作可以分為以下幾個部分。
  2. In this paper, research on the algorithm of complete digital if and baseband transmission system and the realization of transmitter and receiver. / 4 - dqpsk is chosen as digital modulation scheme. the scheme of demodulation is baseband differential detection. sliding correlator can realize the symbol synchronous acquisition ; early - late gate synchronizer is used to do symbol synchronous tracking

    系統的發射機選定/ 4 - dqpsk為調制方式，接收機採用基帶差分解調的非相干解調方式，滑動相關器捕獲發送的pn序列，早遲門同步器跟蹤符號同步，使用相關器對同步后的符號進行最佳判決，並在這些演算法實現的基礎上，實現了直接序列擴頻和解擴技術。
  3. Secondly, according to the character of this kind of harmonic, the solutions of power filter are deeply analyzed and an optimized topology for series connected hybrid power filter is obtained. by pwm technique, midfrequency transformer and the principle of the magnetomotive force ( mmf ) compensation, the problem to the transfer of the low - frequency harmonic power compensatory signal in the series apf is solved, in technique

    其次，針對acem系統特有的「電源諧波」特性，深入分析了濾波器方案，得到了一種適用於acem系統諧波抑制的串聯混合型有源電力濾波器優化拓撲結構，並採用了pwm調制技術、中頻注入變壓器和磁勢補償原理有效地解決了串聯apf中低頻諧波功率補償信號傳輸的難題。
  4. For micro - cavity semiconductor laser, station model is proposed in this paper and its steady - state and instantaneous characteristics when the coupling efficiency of spontaneous emission into a lasing mode is equal to 1 are analysised. for current noise, sp noise, noise, p noise, as well as current modulation, sp modulation, modulation and p modulation, using small - signal approximation, we derive the laser ' s corresponding transfer functions. and we calculate their signal - to - noise ratio ( snr ) gain in various parameters through frequency domain analysis in the premiss of large input snr

    本文對于微腔半導體激光器，提出站模型，能夠較直觀簡潔地分析微腔半導體激光器的穩態和瞬態特性，利用此模型對具有重要實用價值的= 1的微腔半導體激光器進行了討論；對于電流i噪聲、自發發射壽命_ （ sp ）噪聲、自發發射因子噪聲、光子壽命_ p噪聲，以及電流調制、 _ （ sp ）調制、調制、 _ p調制，在小信號近似下，得到了相應的激光器的傳遞函數；在大信噪比的前提下，對激光器進行了頻域分析，分別計算了它們在不同參數下的信噪比增益，分析了其抗噪聲性能。
  5. Methods of measurement for radio equipment used in satellite earth stations - part 2 : measurements for sub - systems - section seven - frequency modulators - section eight - frequency demodulators

    衛星通信地球站無線電設備測量方法第2部分:分系統測量第7節:頻率調制器第8節:頻率解調器
  6. The temperature range is - 30 ~ 80. the topology of the step - up dc / dc converters and its basic principle is first analyzed in this thesis. then based on the conventional pfm control scheme, a discrete pulse frequency modulation is presented and the state space average model related to the ccm ( continue current mode ) and dcm is established

    然後在傳統的脈沖頻率調制方式的基礎上，分析了一種離散脈沖頻率調制方式，並建立了這種調制方式下升壓型dc / dc變換器在電流連續（ ccm ）工作模式和電流斷續（ dcm ）工作模式的狀態空間平均模型。
  7. The 7 years ' applicable practices indicate that the frequency modulation technology with dc bus voltage ripples is very effective to suppress acoustic resonances

    7年的使用實踐表明，直流脈動電壓頻率調制技術對抑制聲諧振現象十分有效。
  8. Chirp signal is a kind of pulse - compressed signal with large time - bandwidth products achieved through linear frequency modulation. it has high resolution in range because of its great bandwidth

    線性調頻信號是通過線性頻率調制獲得大的時寬帶寬積的一種脈沖壓縮信號，具有大的帶寬，因此有高的距離分辨力。
  9. The present paper deals with the water - filling bit allocation algorithm on the base of discrete multi - tone

    摘要在離散多頻音調制原理的基礎上，研究注水流比特分配演算法。
  10. Via theoretical analyzing, we can find that the step reference waveform modulation strategy is an ideal one when frequency modulation ratio is not very high

    通過理論分析，可以看出階梯波調制pwm的確是在頻率調制比不高時較好的調制方式。
  11. In succession, the theory of chirped - pulse amplifier system is given in detail, firstly, studying from designing experimental light road and optical components to theoretical analysis, we par ' tly finished the system by ourselves. about ultr a - shoft pulse with a pulse - width of 9. 8f s and output power of 650mw and band - width of about l 20nm is output from oscillator source, secondiy, the stretching capacity of single grating four - pass stretcher is measured using abcd matrix combining collins function, and the effect of relativ e parameters to the streching ratio is also simulated. thirdly, a new type of disjunctional frequency moduiating function is provided according to the gain - narrowing and gain - saturation which are appeared in the co urse of amplification, under modulating the two effects are both controlled on some e xtent, fourthiy, the effect of ase that is often ignored by people is analyzed and the resolving methods are also given

    從光路、光學元件的自行設計到理論分析計算，初步建立了一臺實驗系統；採用abcd矩陣法結合collins公式計算了四通式單光柵展寬器的展寬量，並模擬了相關參數對展寬比的影響，對實驗具有指導意義；評價了再生放大器和多通放大器的優缺點，對放大過程中通常忽略的放大自發輻射現象（ ase ）進行了分析，並提出了相應的解決方法；針對放大過程中出現的增益窄化和增益飽和現象，對輸入種子脈沖提出了一種新的分段頻率調制函數，實現了對增益窄化效應和增益飽和效應的共同抑制；提出了系統的材料（包括放大介質和光路中的普通介質）正是融合高階色散的來源。
  12. Some modulation parameters, such as the carrier frequency and the symbol rate, can be estimated prior to the recognition of modulation types. such other parameters as the modulation index, the modulation frequency deviation, and the signal broadband can be further estimated after recognition

    部分調制參數如載波頻率、符號速率在識別之前獲得，在識別完成之後可以進一步估計調制指數、調制頻偏、信號帶寬等其餘參數。
  13. Further, the characteristics such as the response speed, the efficiency and the relationship between load and the modulation factor are counted and analyzed. during the stage of circuit design, the whole chip and the sub - block circuits are well - designed, respectively

    基於此模型，計算並分析了離散脈沖頻率調制下升壓型dc / dc變換器的響應速度、效率和負載與調制度的關系等特性。
  14. As an implementing method of multi - carrier modulation ( mcm ), discrete multi - tone ( dmt ) modulation uses inverse discrete fourier transform ( idft ) vector as its modulating vector, and discrete " fourier transibrm ( dft ) vector as its demodulating vector, and the process of modulating and demodulating can be realized by using their fast calculating method

    作為多載波調制的一種實現形式，離散多音頻（ dmt ）調制分別採用逆傅立葉變換矢量和傅立葉變換矢量作為調制矢量和解調矢量，從而調制和解調過程可以利用這兩種變換的快速演算法實現。
  15. For ac discrete digital signal, the zero - calculating method is applied to calculate the true zero in the periodic signal. for the measurement of ac and dc voltage spectrum, the faster fourier transform ( fft ) is used. to measure dc voltage ripple spectrum and frequency modulation of ac voltage, the digital filter is used

    其中對于交變的離散數字量，採用零點撿出技術計算周波信號的真實過零點；對于交直流電壓頻譜，採用快速傅立葉變換進行頻譜分析；對于直流電壓脈動和頻率調制，採用數字濾波器進行濾波后再做分析處理。
  16. The transmitter unit mainly consisted of the dibit - to - serial conversion, differential encoder, pn code generator and qpsk modulator and so on

    發送部分主要有串並處理、差分編碼、 pn碼擴頻、 qpsk調制等模塊。
  17. Information processing. data interchange on 200 mm flexible disk cartridge using modified frequency modulation recording at 13262 ftprad, 1, 9 tpmm 48 tpi, on both sides. part 2 : track format

    信息處理.在mm in軟磁盤上利用修正的頻率調制以， ，錄制在兩面上的數據交換.第2部分：磁軌示意圖
  18. Technical requirements for uu interface of 2ghz td - scdma digital cellular mobile communication network physical layer technical specification part 4 : spreading and modulation

    2ghz td - scdma數字蜂窩移動通信網uu介面物理層技術要求.第四部分：擴頻和調制
  19. Methods of measurement for radio equipment used in satellite earth sations. part 2 : measurements for sub - systems. section five : frequency modulators

    衛星地面站用無線電設備的測量方法.第2部分:分系統的測量.第5節:頻率調制器
  20. The pfm as the key technology in the pfm optic transmitter is discussed

    分析了pfm光發射機設計中的一項關鍵技術，即脈沖頻率調制。
分享友人
分享到 Line

分享到臉書