頻率選擇開關 的英文怎麼說

中文拼音 [bīnlǜxuǎnzháikāiguān]
頻率選擇開關 英文
frequency selective switch
  • 頻 : Ⅰ形容詞（次數多） frequent Ⅱ副詞（屢次） frequently; repeatedly Ⅲ名詞1 [物理學] （物體每秒鐘振動...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 選 : Ⅰ動詞1. （挑選） select; choose; pick 2. （選舉） elect Ⅱ名詞（挑選出來編在一起的作品） selections; anthology
  • 擇 : 擇動詞（挑選） select; pick; choose
  • 關 : Ⅰ動詞1 （使開著的物體合攏） close; shut 2 （圈起來） shut in; lock up 3 （倒閉; 歇業） close down...
  • 頻率 : frequency; rate
  • 選擇 : select; choose; opt; election; choice; culling; alternative
  1. The 1mhz fixed frequency switching allows for tiny external components and the regulation scheme is optimized to ensure low emi and low input ripple. an external resistor sets the full - scale led current, while two digital inputs control on / off and select amongst three levels of brightness. the circuit operates in 1x mode until just above dropout

    工作在1mhz固定頻率，採用線性調制模式使輸入紋波大大減小;利用一個外部電阻可以設置滿量程led電流;外接兩個數字信號控制晶元開關並選擇led三級亮度中的一級;具有過溫、過壓/欠壓等保護功能，工作溫度范圍為- 40 + 85 。
  2. Electric - controller is nubbin in developping. we are based on designing to structure of circuit, we are dead against in time and stabilization for controlling and communications, precision and rapidity for transformation etc. we have completed to select on microprocessor, clock - frequency and a / d transfer. it carry out transformation for valve position signal, and select on solid - switch ac

    在控制器的電路結構設計的基礎上，考慮到通訊、控制的及時、穩定、轉換的精度和速度等幾方面，主要完成對微處理器的選擇、時鐘頻率和a d轉換器的選用，閥位變送功能的實現，固態交流開關和顯示器的選擇等。
  3. High - frequency link power converters are receiving increasing attention. when the input frequency of ac - ac converter is quite high, such as 20khz or above, in order to make sure the converter switching action is restricted to the zero crossing point of the link voltage, the switching cycle becomes discrete pulse spectrums, however, the conventional pwm converters are ruled out because they would fail either to the efficiency or the low - distortion criteria

    當交-交變頻器的輸入頻率非常高，通常為20khz時，為了在零電壓條件下實現逆變器開關管的通斷，變換器的開關時刻必須選擇在高頻交流電壓脈沖為零時，這意味著變換器開關時刻在時間軸上成為不連續的點，而常規的硬開關pwm變換器是將開關時刻選擇在任意時刻。
  4. Adjusting digital potentiometer in controlling circuits of sps and capacitor charging and discharging circuit separately with industry control computer ( icc ), the peak value and repeat frequency of output pulse can be adjusted separately. controlling relays to choose different capacitors with icc, the width of output pulse can be adjusted

    利用工控機分別調節開關式穩壓電源控制電路和電容充放電控制電路中的數字電位器，就能分別調節輸出陡脈沖的幅值和重復頻率；利用工控機控制繼電器選擇不同的充放電電容，就能調節輸出陡脈沖的脈寬。
  5. The paper first reviews the research background and actuality of the filter " s design in china and other country, introduces the meaning of the project and the work of the paper, narrates the theory of the switched - capacitor network and the basic switch building blocks, analyses the related factors of the design of sc filter. such as the selection of the architecture, the trade off of the opamp " s gain, bandwidth, phase margin, slew rate and setting time, the effect of the switch " s on resistor, how to reduce the charge injection and the clock feed - through, the power consumption and the selection of the sampling frequency and so on

    本文首先回顧了濾波器設計的國內外研究背景和現狀，介紹了本課題提出的意義以及本文的主要工作，論述了開關電容網路原理和基本開關模塊，分析了開關電容濾波器設計的相關因素：電路結構的選擇，對運算放大器設計中高增益、寬帶寬、相位裕度、轉換斜率和建立時間等的折中考慮，開關的打開電阻對電路的影響，開關電容電路中怎樣減少電荷注入和時鐘饋通，以及整個電路的功耗問題和采樣頻率的選擇等。
  6. In chapter 2, the nonlinear feature of iron core of transformer in switching power supply was studied. according to the characteristics of switching power supply, the topology structure of resonant converter was selected. the characteristics of out put voltage and current vs. frequency for the three kinds of resonant converter were analyzed and compared

    在第二章中，研究了高壓開關電源中高壓變壓器的非線性特性，選擇了諧振變換器作為高壓大功率開關電源的電路拓撲結構，並對三種形式的諧振變換器的電壓及電流頻率特性進行了分析比較。
  7. In this paper, a new control strategy based on the adaptive deadbeat voltage space vector is presented. this control scheme has a lower sample frequency and a smaller difference between switch frequency and sample frequency. it has many advantages, such as producing zero vectors organically, tracing exactly, non - shaking, etc. and its dynamic response is better

    對于電能質量調節器來講， pwm跟隨指令參考信號的控制性能在很大程度上影響著裝置的補償效果，本文選擇無差拍電壓空間矢量控制為系統控制策略，這種控制方法具有采樣頻率低，開關頻率與采樣頻率的差距小，能有機地產主零矢量、跟蹤精確以及無抖振等優點，動態響應快。
  8. And the selection and design of switch - in module, switch - out module, communication module, clock module, data storage module, keys module and frequency detecting module are also discussed

    論文中還給出了開關量輸入、開關量輸出、通信模塊、時鐘電路、數據存儲器、按鍵電路和頻率跟蹤電路等各功能模塊的選擇方法和設計原理。
  9. By using phase shifting control between right bridge leg and left bridge leg, the output cy cloconverter commutating while the bi - polarity three - state high frequency ac volage from the input cycloconveter is zero, . and commutation overlap of the output cycloconverter and polarity selection of the input voltage, the leakage inductance energy and the output filtering inductance current are naturally commutated, and zvs switching of the output cycloconverter are realized, the surge voltage and surge current of the output cycloconverters are overcome

    通過輸入周波變換器右橋臂相對左橋臂的移相，讓輸出周波變換器功率開關在輸入周波變換器輸出的高頻交流電壓為零期間進行換流，並藉助輸出周波變換器換流重疊和輸入電壓極性選擇，從而實現了變壓器漏感能量和輸出濾波電感電流的自然換流、輸出周波變換器的zvs開關，解決了輸出周波變換器固有的電壓過沖和環流問題。
  10. The switch power will operate at ccm condition when circuit is set to pwm mode. when pfm mode is selected for the operation mode, the switch power will still operate at pwm condition with the high load, the system will cancel the pwm mode and enter the pfm mode only when the load is drop to a certain threshold to boost the operation efficiency at light load, make the ic has high efficiency within wide load range

    選擇pwm模式，開關電源將工作在ccm模式下;選擇pfm模式，在負載較高的情況下，開關電源仍然工作于pwm模式，只有當負載降低到一定程度時，開關電源才退出pwm模式，而按照pfm工作模式操作，跨過一部分時鐘周期，降低頻率相關功耗，以提高輕負載時低效率的問題，使得開關電源在很寬的負載范圍內都具有高效率。
  11. 1. nizn ferrite was developed for using in mini high frequency dc - dc converters and inductors. we measured and analysed the parameters of the nizn ferrite, which we concern about when designing the dc - dc converter. 2. the low loss sample of nizn ferrite were chosen for design - optimization of the high frequency transformer. based on the relevant theoretical researches, the loss properties of the magnetic core material and winding were analyzed in this thesis

    因此，以nizn功率鐵氧體材料為開關電源芯材為基礎，並優化各種開關電源的設計已成為國際上的熱點和技術瓶頸，本論文正是以上述背景為研究目標而開展工作的，主要進行的工作和創新有: 1 .對研製的新型高頻低功耗的功率nizn材料進行參數的測試，並針對dc - dc變換器設計關心的參數對芯材特性進行了分析，選擇在特定頻率下，功耗較小的nizn材料磁芯樣品作為變壓器優化設計的預備磁芯。
  12. Run command / frequency source are easy to select with a dip switch

    通過dip開關，能容易的選擇運行命令/頻率源。
  13. In chapter 3, according to the requirements of high voltage power supply used for charging capacitors with constant current, the series resonant converter ( src ) was chosen as the main circuit frame. the dynamic process of src was discussed by using mathematical analyses and numeric simulation to study the operational characteristics, the effects of parameters of resonant circuit on them and the relationship between switching frequency and out put power, which provided the bases of designing the power supply

    第三章中根據高壓電容恆流充電電源的運行特點，選擇了串聯負載諧振變換器作為主電路結構形式，並對其動態過程進行了數學分析及數值模擬，討論了該電路的運行特點、諧振迴路參數對運行特性的影響以及開關工作頻率與功率輸出的關系，為電源的設計提供了依據。
  14. The simulation results show that with the method, the capacitor voltages in the dc side are balanced effectively and the switch frequency reaches requirement

    模擬結果表明：在合理選擇電壓平衡系數的情況下，該方法不僅能夠有效地平衡直流側兩電容上的電壓，也能夠使開關頻率滿足要求。
分享友人
分享到 Line

分享到臉書