顆粒均勻 的英文怎麼說

中文拼音 [jūnyún]
顆粒均勻 英文
uniform in size
  • : Ⅰ名 (小圓珠形或小碎塊形物) small particles; grain; granule; pellet Ⅱ量詞(用於粒狀物)
  • : Ⅰ形容詞(均勻) equal; even Ⅱ副詞(都; 全) without exception; all
  • : Ⅰ形容詞(均勻) even Ⅱ動詞1. (使均勻) even up; divide evenly 2. (分出一部分) spare
  • 顆粒 : 1 (小而圓的東西) pellet; bead; dust; anything small and roundish (as a bean pearl etc )2 (一...
  1. Powder materials can be made into even granules customer needs without adding any bonding anent when they run througnh the machine. as density of granules are larger, no any afterward process is needed so as to reduce technological process, reduce granulation cost and powder pollution and improve labor environment as well

    粉體物料經本設備,無需添加任何粘結劑即可直接製成用戶所需的產品,密度大,城無需再進行后續加工處理,減少了工藝流程,不僅降低了造成本,並且減少了粉塵污染,改善工人的勞動環境。
  2. The performance of this product is object to the national standard. its appearance is black blocky piece without impurits or granulars. it can be added to the material of tire making

    產品外觀為黑色塊狀物、無異物、無明顯,能大量摻用在汽車、摩托車外胎的製造中。
  3. The performance of this product is beyond the level in this field. its appearance is black blocky piece without impurit 、 granular and it is odorless and touched smoothly

    該產品性能優異,各項性能超過同行業水平,產品外觀為黑色塊狀物、無異物、無、無異味、手感細膩、光滑,深受外資企業地青睞。
  4. The influence of inflow velocity, the baffle body height and the clapboard position on the flow velocity, flow equilibrium between the two sides of the clapboard, particle distribution, rich / lean concentration ratio and flow resistance characteristic are studied numerically

    文章研究了來流速度,撞擊塊高度、隔板位置等因素對氣相速度場、隔板兩側配風性、濃度、濃淡分離比和燃燒器內阻力特性的影響。
  5. Guangxi man ting fang fine chemical co., ltd. applies rich local high quality mine and advanced airflow and classification technologies to produce stone powder delivering outstanding qualities of high purity, high whiteness, and equal concentrated grains distribution

    廣西滿庭芳精細化工有限公司利用當地蘊藏量豐富的高品質礦產資源,採用先進的分流分級技術所生產的石粉具有純度、白度、高顆粒均勻分佈集中的顯著特點。
  6. After a great deal of research and testing, machine - brushing finished by hand - polishing was deemed the best way of achieving a uniform grain

    經過大量的研究和測試后,用手工拋光進行的機械亞光處理被認為是實現顆粒均勻的最佳方式。
  7. When sno2 wt % was controlled for 10 %, the square resistance of sn - in2o3 was minimum. through the characterization of in2o3 / sno2 nano powders, some conclusions were drawn : sno2 nano powder is rutile structure, and in2o3 and sn - in2o3 nano powders are cubic structure. in2o3 / sno2 nano powders were well dispersing with spherical uniform grain, and the mean grain was 4 - 50 nm

    通過對inzo3 / snoz納米粉體表徵,得出inzo3 / snoz納米子多呈球形、顆粒均勻、分散性良好、組分、純度較高、平徑在4一50lun左右、比表面積達67一156mz / g ; snoz納米粉為正四面體金紅石結構, inzo3和sn一inzo3納米粉為體心立方結構。
  8. The microstructure of lamellae pearlite has evolved ultrafine cementite particles throughout the ferrite matrix uniformly after five passes. the ferrite matrix is homogeneous grains, average grain size is - 0. 3 m. 2

    變形五道次后,片層狀的珠光體組織演變成了超細的滲碳體顆粒均勻分佈於鐵素體基體的組織,鐵素體基體為的等軸晶,平大小為0 . 3 m 。
  9. The main results are as the following : ( 1 ) the microstructure of lamellae pearlite has evolved ultrafine cementite particles throughout the ferrite matrix uniformly after four passes. the ferrite matrix is homogeneous grains, and average grain size is - 0. 3um

    主要結果如下: ( 1 ) ecap變形四道次后,片層狀的珠光體組織演變為了超細的滲碳體顆粒均勻分佈於亞微晶鐵素體基體的組織。
  10. The urea - formaldehyde ( uf ) polymer / sio2 composite microspheres were prepared by polymerization - induced colloid aggregation ( pica ) method. the formation mechanism of composite microspheres is attributed to the fact that that urea and formaldehyde firstly undergo acid - catalyzed polymerization to form oligomers, and then the sol particles are adsorbed on the chain of oligomers by wan der walls force and hydrogen bonding. when the oligomers reach the critical chain length, they separate from solution due to phase separation

    對復合微球形成機理的研究表明,尿素和甲醛在酸性條件下自身聚合可以形成高分子微球,在sio _ 2酸性溶膠中發生聚和反應時,隨著反應的進行,齊聚物不斷生成, sio _ 2膠體逐漸吸附在齊聚物分子鏈上,當聚合物鏈達到沉澱臨界鏈長時,由於相分離作用,從前驅物溶液中析出,同時sio _ 2膠體顆粒均勻的分佈在脲醛聚合物網路中,隨之沉澱出來,形成脲醛sio _ 2復合微球。
  11. Coated abrasives incorporate abrasive granules which are coated with a layer of adhesive and affixed to a paper, cloth, fiber or synthetic backing

    -塗敷磨具:其生產過程是使用粘著劑,將磨料顆粒均勻地粘結在各類紙張織物纖維或合成物的表面
  12. And the value drop to the lowest at ph = 0. 8. as the increase of heat treatment temperature, the pore size distribution peak of sio2 microspheres is very narrow, meanwhile the specific surface area is the smallest before 160 c. the polymer template is removed at 350 c, so the pore structure of sio2 particles has a big change which involve the increase of specific surface area and the broaden of pore size distribution peak. with the continuous raise of temperature the sio2 network will shrink little, as a result the average pore size will decrease, but the specific surface area has no obvious change

    結果發現:二氧化硅膠體顆粒均勻分佈於脲醛聚合物網路中,煅燒去除有機模板后微球表面變粗糙,而徑沒有明顯變化; ph值較小時,復合微球中聚合物含量較大,而ph值較大時,得到復合微球結構鬆散,因此熱處理后的二氧化硅微球孔容及平孔徑都較大,而在ph = 0 . 8時,得到最小值;武漢理工大學碩士學位論文隨著熱處理溫度的變化,小於160時,空分佈較窄,而比表面積較小,在350時,由於有機模板的去除,微球孔結構發生突變,比表面積明顯增大,而孔徑分佈變寬,溫度繼續升高時,二氧化硅網路發生收縮,平孔徑變小而比表面積由於有機炭化物的完全去除沒有太大變化;微球中的微孔在熱處理過程中處于平衡狀態,分佈沒有太大變化。
  13. Dry and damp granule will be uniformity and finishing

    乾式、濕式顆粒均勻化、整
  14. This thesis focuses on the study of the layered lithium nickel - based oxides as catho de materials lithium - ion batteries, the main aspects follow : 1 study on the synthesis and properties of linixco1 - xo2 by the sol - gel method compared with solid - state method, sol - gel method enjoys the advantage of lower calcining temperature and small uniform particle size of products. after the xrd measurement, it was shown that the single - phase layered compound can be prepared in sintering temperature of 750 for 6 ~ 8 hours. the sintering temperature, the properties and the amounts of doping materials can all affect the product ' s phase, and its structure ( lattice parameter, crystal phase distance )

    本論文的研究工作主要集中在作為鋰離子電池正極材料的層狀鋰鎳基氧化物上,包括以下幾個方面: 1溶膠凝膠法( sol - gel )合成lini _ xco _ ( 1 - x ) o _ 2的研究與固相合成法相比,溶膠凝膠法合成lini _ xco _ ( 1 - x ) o _ 2煅燒溫度低,產物顆粒均勻一致,經過xrd的測試過后,結果表明750下燒結6 8小時,即可得到單相產物;燒結溫度,摻雜劑的種類及摻雜劑量對產物物相的形成產生影響,並對產物的結構產生影響。
  15. Stability analysis on particle uniform distribution in cocurrent - up gas - solid flow

    氣固併流上行流動中顆粒均勻分佈的穩定性
  16. The spray desiccation equipment and its subsidiary sets was imported from denmark, the characters of equipment is stable performance, high precision and advanced technology, it is the ideal equipment to produce dha powder. our company can produce dha powder 100 tonsyear, additional, our company also can produce many kinds of products with even grains

    Dha粉末製造過程中所用的設備是由丹麥進口的噴霧乾燥配套市設備,其特點是性能穩定,精密度高,技術先進,是生產dha粉末的理想設備,可年產粉末100噸,並可視需要產出顆粒均勻度大小不一的多種產品。
  17. Even granules, nice outlook, stable in chemical

    顆粒均勻,外形一致,化學性能穩定。
  18. Magnesium - hydroxide powder features high purity, well distributed particle size, extremely low in impurity

    氫氧化鎂純度高,顆粒均勻,重金屬等雜質含量低,可在多個領域廣泛應用。
  19. K + is remnant because of uncompleted filtering of kc1 from the precursor solution, and the molar ratio of k + to nb + was found to be 3 : 5

    緩沖層為3層的薄膜與襯底的匹配最好。而且,薄膜的顆粒均勻,表面平整, ra只有4nm 。
  20. The results showed that the nanosize silver particles produced by this method are pure and spherical with uniform and narrow - dispersed size distribution

    結果表明,該法制備的納米銀子雜質含量低,度分佈集中,顆粒均勻一致,形貌呈球形。
分享友人