額定分接 的英文怎麼說

中文拼音 [édìngfēnjiē]
額定分接 英文
principal tapping
  • 額 : 名詞1 （額頭） forehead:寬額 a broad forehead2 （牌匾） a horizontal tablet 3 （規定的數目） a sp...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  1. Elements of electrical and optical connection - test methods - current temperature derating

    電氣和光學連接元器件.試驗方法.第209部分:降低電流溫度額定值
  2. The products is of high water hydrophobe device usedin suitable and has the characteristics of aging resistance, resistance, tracking resistance, and corrosive resistance. it can withstand high bent load, strong impact force fn12 - 12 series indoor use high voltage load switch fn12 - 12 and fn12 - 12r is of three phases indoor use ac high voltage load switch for breaking and making the circuit of 50hz, 12kv system under rated loading

    Fn12 - 12和fn12 - 12r組合電器是額定電壓12kv額定頻率50hz的三相高壓開關設備用於分合負荷電流閉環電流空載變壓器和電纜充電電流關合短路電流配裝接地開關的負荷開關，可以承受短路電流
  3. Polyvinyl chloride insulated cables of rated voltages up to and including 450 750v. part 6 : lift cables and cables for flexible connection

    額定電壓450 750v及以下聚氯乙烯絕緣電纜第6部分:電梯電纜和撓性連接用電纜
  4. Polyvinyl chloride insulated cables of rated voltages up to and including 450 750 v - part 6 : lift cables and cables for flexible connections

    額定電壓450 750v及以下的聚氯乙烯絕緣電纜.第6部分:電梯電纜和軟連接用電纜
  5. Octagon connectors for terminal studs, rated over 10000 a, for transformer - bushings

    第5部分:變壓器套管的額定為1000 a的終端接線柱用
  6. Electromagnetic compatibility - part 3 - 3 : limits - limitation of voltage changes, voltage fluctuations and flicker in public low - voltage supply systems for equipment with rated current inferior or egal to 16 a per phase and not subject to conditional connection

    電磁兼容性.第3 - 3部分:限值.額定電流小於或等於16a相併且在無條件連接情況下的設備用公共低壓供電系統的電壓變化電壓波動和電壓閃動的限值
  7. Elements of electrical and optical connection - test methods - contact resistance at rated current

    電氣和光學連接元器件.試驗方法.第202部分:在額定電流時的接觸電阻
  8. Proportional reinsurance, also named as sum insured reinsurance, is one using sum insured to divide the total risk amount into primary insurer ' s retention and reinsurer ' s liability

    比例再保險又稱金額再保險，是以保險金額為責任分配的基礎，確定分出公司自留額和接受公司責任額的一種再保險。
  9. It can be subdivided into quota share reinsurance, surplus reinsurance and quota share & surplus complex reinsurance. non - proportional reinsurance, titled as loss reinsurance as well, is one using loss amount to separate retention from liability ceded

    非比例再保險又稱損失再保險，是以損失賠款為責任分配的基礎，確定分出公司自留額和接受公司責任額的一種再保險。
  10. The products is suitable for power installation fixed wiring or flexible connection for electrical appliances with rated voltage up to and including 450 / 750v respectively

    本產品分別適用於額定電壓450 / 750v及以下的動力裝置、固定布線及撓性連接電器之用。
  11. Theproducts is suitable for use in power instailations, fixed wiring or flexible connections for electrical appliances with rated voltages up to and inciuding 450 / 750v respectively

    本產品分別適用於額定電壓450 / 750v及以下的動力裝置、固定布線及撓性連接電器之用。
  12. Signs and luminous - discharge - tube installations operating from a no - load rated output voltage exceeding 1 kv but not exceeding 10 kv - part 2 : requirements for earth - leakage and open - circuit protective devices

    無荷載額定輸出電壓大於1kv小於10kv的標牌和發光放電管裝置.第2部分:接地漏電和開路防護裝置要求
  13. Direct gas - fired washing machines of nominal heat input not exceeding 20 kw. part 1 : safety

    額定熱輸入不超過20kw的直接燃氣洗衣機.第1部分:安全性
  14. Direct gas - fired washing machines of nominal heat input not exceeding 20 kw. part 2 : rational use of energy

    額定熱輸入不超過20kw的直接燃氣洗衣機.第2部分:能量的分配利用
  15. Road vehicles. electrical disturbance by conduction and coupling. part 2 : commercial vehicles with nominal 24 v supply voltage. electrical transient conduction along supply lines and board network control lines

    道路車輛.連接和耦合產生的電干擾.第2部分:額定24伏供電電壓商用車輛.通過供電線和插件板網路控制線的電瞬變感應
  16. The bottom roller and sub - bottom roller of hcr is calculated about its equivalent stress, contact stress and the distributing of pulling - stress along the inside track of hcr. also, effects of hollowness and pinch fit are analyzed on bearing stress and rated load

    主要計算預負荷空心圓柱滾子軸承的最底部滾子和次底部滾子的等效應力、接觸應力和滾子內圈拉應力的分佈情況，分析滾子空心度和過盈量對軸承應力和額定載荷的影響。
  17. Steel tubes for mining - part 1 : interpose rings rated for pn 10 and pn 40

    礦山用鋼管.第1部分:額定壓力pn10和pn40的插接環
  18. The reinsurance acceptor shall, according to the provisions of the relevant reinsurance contracts, calculate and determine the amount of reinsurance premium income

    再保險接受人應當根據相關再保險合同的約定，計算確定分保費收入金額。
  19. Composite string insulator units for overhead lines with a nominal voltage greater than 1000 v - part 1 : standard strength classes and end fittings

    額定電壓超過1000v的架空線用復合絕緣子串組合件.第1部分:標準強度等級和端接頭
  20. The research paper is based on the the latest softwares of the managing inventory, its research subject is about simulating the most appropriate inventory quantity and ordering quantity by statisticing the probability of the random require quantity. its purpose is to provide the relied basement for determining the most appropriate inventory quantity and ordering quantity, the deterring policy quality will be raised, so the damage caused by unfit inventory quantity and the benefit of the entrerpreneur will be raised. the research method is by building the inventory management information system, the system includes automated management of parts entering and going out the datasbase. requesting the records of parts entering and going out the datasbase and displaying the sygonal when the inventory quantity is short out. computer calculating the fix period remaining, requesting remaining at any time and displaying if goods need ordering, all the partsof certain a product going out of basement and at the same time checking if the storaging quantity is enough. then simulating the most appropriate inventory quantity and ordering quantity simulating method is as follows : statisticing the random required quantity. calculating the probability, standing for the values with data range producing random data by function accordingly calculating the random required quantity. thenext step is simulating all the projects after pressing in the simulating conditions. finally selecting the best

    本文通過分析國內外關于庫存管理軟體的發展情況，提出在線統計貨物出庫情況的基礎上利用模擬方法確定最優存儲方案，其目的是為制定合理的貨物安全庫存量和訂貨量提供可靠的依據，提高企業管理人員的決策質量，從而減小資金的佔用和缺貨損失，提高企業的經濟效益。通過研製庫存管理信息系統使庫存信息管理自動化，也就是實現貨物入出庫管理計算機管理、自動查詢貨物入出庫情況並在缺貨時給予提示、使用計算機貨物余額定期結算、貨物余額實時查詢並顯示是否需要訂貨、裝配出庫管理使得只要輸入需要裝配產品代號和數量，組成它的所有零件就會自動檢庫和出庫。然後對安全庫存量和訂貨量進行模擬，模擬方法是首先自動統計貨物在過去某一段時間內的需求量，計算出概率，用隨機數的范圍表示其概率數值的大小，利用隨機函數產生隨機數、從而間接的產生隨機需求量，給定模擬天數和其他模擬條件模擬各種方案，從眾多的存儲方案中找出最優存儲方案。
分享友人
分享到 Line

分享到臉書