額定載荷 的英文怎麼說

中文拼音 [édìngzǎihé]
額定載荷 英文
load rating
  • 額 : 名詞1 （額頭） forehead:寬額 a broad forehead2 （牌匾） a horizontal tablet 3 （規定的數目） a sp...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 荷 : 荷名詞（蓮） lotus
  • 載荷 : load; loading載荷變化 load fluctuation; variation in load; 載荷裝置 load device
  1. The products is of high water hydrophobe device usedin suitable and has the characteristics of aging resistance, resistance, tracking resistance, and corrosive resistance. it can withstand high bent load, strong impact force fn12 - 12 series indoor use high voltage load switch fn12 - 12 and fn12 - 12r is of three phases indoor use ac high voltage load switch for breaking and making the circuit of 50hz, 12kv system under rated loading

    Fn12 - 12和fn12 - 12r組合電器是額定電壓12kv額定頻率50hz的三相高壓開關設備用於分合負荷電流閉環電流空載變壓器和電纜充電電流關合短路電流配裝接地開關的負荷開關，可以承受短路電流
  2. Roller bearings, load ratings and fatigue life for

    滾柱軸承額定載荷和疲勞壽命
  3. In view of this situation this article has conducted research to the design of metallurgy auxiliary biography with the frequency conversion table electrical machinery first multianalysis to the frequency changer and the frequency conversion table electrical machinery movement characteristic is carried out, the voltage waveform harmonious which the frequency changer outputs is big, attacks in a big way, and the voltage climbing rate reaches as high as 6600v / mu s which is 20 times ordinary sine alternating voltage, the rolling mill auxiliary biography table set the extremely strict request to the electrical machinery ; its movement frequency is very low, rate frequency in 8 - 20hz ; the velocity modulation scope is wide, the lowest movement frequency lowers to 1hz, and the starting number of times is quite frequently, each hour reaches as high as 600 - 800 time, the impact shoulders in a big way, the overload capacity request is high

    針對這一情況本文對冶金輔傳用變頻輥道電機的設計進行了系統研究。首先對變頻器和變頻輥道電機的運行特性進行詳細分析，變頻器輸出的電壓波形諧波大，沖擊大，電壓上升率高達6600v / s ，是普通正弦交流電壓的20倍;軋機輔傳輥道對電機提出了十分嚴格的要求:其運行頻率很低，額定頻率在8 - 20hz ;調速范圍寬，最低運行頻率低到0 . 5hz ，起動次數相當頻繁，每小時高達600 - 800次，沖擊負荷大，過載能力要求較高。
  4. Product this company, brush of british, high - handed limit that manufacturing technology produce to flow fuse box, products suitable for family exchenge 50hz, specified voltage 3kv kv, 6kv 7. 2kv, 12kv 15kv system, can cooperate and is used with other protection electric apparatuses such as the on - load switch, vacuum contactor, as high - handed motor, electric power voltage transformer and electric power overload or holding up of equipment, etc. protect the component

    本產品是英國brush公司高壓限流熔斷器製造技術生產的，產品適用於戶內交流50hz ，額定電壓3kv 3 . 6 kv ， 6kv 7 . 2kv ， 12kv ， 15kv系統，並可與其它保護電器如負荷開關，真空接觸器配合使用，作為高壓電動機，電力變壓器及電力設備的過載或短路等保護元件。
  5. Product this company, brush of british, high - handed limit that manufacturing technology produce to flow fuse box, products suitable for family exchenge 50hz, specified voltage 3kv kv, 6kv, 12kv 15kv system, can cooperate and is used with other protection electric apparatuses such as the on - load switch, vacuum contactor, as high - handed motor, electric power voltage transformer and electric power overload or holding up of equipment, etc. protect the component

    本產品是英國brush公司高壓限流熔斷器製造技術生產的，產品適用於戶內交流50hz ，額定電壓3kv 3 . 6 kv ， 6kv 7 . 2kv ， 12kv ， 15kv系統，並可與其它保護電器如負荷開關，真空接觸器配合使用，作為高壓電動機，電力變壓器及電力設備的過載或短路等保護元件。
  6. He finds the pitch range after calculated the three important parameters through the bladed for windows software, then presents an optimized control strategy that regulate the pitch angle in terms of the wind speed. it must control the output power because the variational output power brings the variational loads. he confirms and optimizes the control strategy that the output power is the control target, the output power is divided into three parts

    將功率作為系統控制的目標，將功率分成三段進行控制，在低風速區，載荷是有限的，以功率最大化作為控制目標；在額定風速附近，由於處在升力曲線斜率的變化點，功率變化較大，應盡快調整槳距角進入失速區工作，減少載荷的波動，該額定風速區的上下工作點要通過現場試驗的手段來確定；在額定風速以上，使功率維持在額定輸出，減少功率波動，並通過bladed軟體的模擬計算對控制策略進行了驗證。
  7. The centrifugal pump for oilfield waterflooding and oil transfer worked with low pump efficiency owing to unstable load and its energy loss is fairly large

    油田注水集輸系統離心泵由於載荷經常變化，大多不能在其額定工況點工作，泵效低，且需要用泵出口閥調節流量，產生一定的泵管壓差，造成較大的能量損失。
  8. Abus lis overload protection. lifting is interrupted when 1, 1 times rated load is reached. the electronic measurement method used features extremely short load detection times

    安博lis過載保護裝置。該裝置當載荷超過額定載荷的1 . 1倍時中止葫蘆起升。該裝置檢測時間短。
  9. Over load working of transformers are guided by iec905 loading guide for dry type power transformers

    按照iec905 《乾式電力變壓器負載導則》 ，是指導變壓器過負荷（超銘牌額定值）運行。
  10. The sieries product is suitable for the system with current 50hz - 60hz and the rated voltage of 3. 6kv 40. 5kv. it can be matched with other protective electrical equipment vacuum connection, loading switch etc. it can also be used as the overload or short circuit protection parts for high voltage motor, transformer, voltage mutual inductance attenuator and other power equipment

    本系列產品適用於交流50hz - 60hz ，額定電壓3 . 6kv 40 . 5kv系統，可與其它保護電器如真空接觸器，負荷開關等配合使用，作為高壓電動機電力變壓器電壓互感器及其它電力設備的過載或短路保護等元件。
  11. Signs and luminous - discharge - tube installations operating from a no - load rated output voltage exceeding 1 kv but not exceeding 10 kv - general requirements

    用無荷載額定值的輸出電壓大於1kv小於10kv的電源工作的標志燈和發光放電管裝置.一般要求
  12. Signs and luminous - discharge - tube installations operating from a no - load rated output voltage exceeding 1 kv but not exceeding 10 kv - requirements for earth - leakage and open - circuit protective devices

    無荷載額定輸出電壓大於1kv小於10kv的標志和發光放電管裝置.接地漏電和開路防護裝置要求
  13. Signs and luminous - discharge - tube installations operating from a no - load rated output voltage exceeding 1 kv but not exceeding 10 kv - part 2 : requirements for earth - leakage and open - circuit protective devices

    無荷載額定輸出電壓大於1kv小於10kv的標牌和發光放電管裝置.第2部分:接地漏電和開路防護裝置要求
  14. Safety of earth - moving machinery - specification for rated operating load for crawler and wheel loaders

    運土機械的安全性.第2部分:履帶式和輪式裝載機額定操作負荷規范
  15. The bottom roller and sub - bottom roller of hcr is calculated about its equivalent stress, contact stress and the distributing of pulling - stress along the inside track of hcr. also, effects of hollowness and pinch fit are analyzed on bearing stress and rated load

    主要計算預負荷空心圓柱滾子軸承的最底部滾子和次底部滾子的等效應力、接觸應力和滾子內圈拉應力的分佈情況，分析滾子空心度和過盈量對軸承應力和額定載荷的影響。
  16. Rolling bearings - dynamic load ratings and rating life - life modification factor a ; amendment a2 iso 281 : 1990 amd 2 : 2000

    滾動軸承.動載荷值和額定壽命.修改件2 :壽命改進因子a
  17. These load, speed and mass is reference of choice only

    表中所列基本額定載荷、極限轉速和重量，僅供選擇參考用。
  18. As present, simulation load instead of real load is adopted to measure the errors of transformer. in this way, it can only show whether the transformer is qualified within the range of the specified loads and can not reflect the real errors of the transformer in its practical working conditions

    目前電力系統測量互感器誤差採用的不是實際負荷，而是用負載箱模擬負荷，這種方法只檢測了互感器在額定負荷之內是否合格，反映的不是互感器在實際工作狀態下的誤差。
  19. Unless there are other means to prevent lifting a motor vehicle exceeding the capacity of the platformequipment, an overload device should be installed to prevent any movement of the platform and to give an alarm when the load on the elevating platform is in excess of the rated capacity

    如沒有採取其他措施防止平臺設備提升超逾其負載重量的車輛，便須裝設過重安全裝置，在平臺負荷超逾其額定載重時停止操作，以及發出警報。
  20. For moderate load （ an speeds the correct - selection of a standard bearing ） （ on the basis of load rating ） will usually secure satisfactory performance

    對於一般的載荷，根據額定載荷來對標準軸承速度進行正確的選擇可以保障良好的運行。
分享友人
分享到 Line

分享到臉書