顯式數值積分 的英文怎麼說

中文拼音 [xiǎnshìshǔzhíjīfēn]
顯式數值積分 英文
explicit numerical integration
  • 顯 : Ⅰ形容詞1 （明顯） apparent; obvious; noticeable; evident 2 （有名聲有權勢的） illustrious and inf...
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 積 : Ⅰ動詞（積累） amass; store up; accumulate Ⅱ形容詞（長時間積累下來的） long standing; long pending...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 數值 : numerical value; numerial number; figure; magnitude; value數值表 numerical tabular; 數值天氣預報 ...
  • 積分 : 1. [數學] integral; integrate; integration 2. [體育] （積累的分數） accumulate points
  1. The theoretic calculating method of the maximum and the minimum water level in the differential surge tank has been derived firstly. also the explicit method of calculating surges in the differential surge tank has been deduced firstly by use of thaler series expansion. the calculating method of section of the well and the effective impedance hole in the surge tank has been gived

    根據差動式調壓室的基本微分方程，首次推導出了差動式調壓室涌浪幅值的理論計算公式；並同樣利用泰勒級數展開方法推導出了差動式調壓室水位波動的顯式計算式；導出了差動式調壓室大井面積和有效阻抗孔面積的計算方法。
  2. In this paper, the upwind scheme and the central scheme are presented for solving 3 - d n - s equations using the cell - center finite volume spatial discretization and four - stage runge - kutta time stepping scheme, with standard convergence acceleration techniques such as local time stepping and implicit residual smoothing

    在n - s方程的數值計算上，採用了中心差分格式和迎風格式，用格心格式的有限體積法進行了空間離散，用四步龍格?庫塔法作顯式時間推進，並採用了當地時間步長和隱式殘差光順等加速收斂措施。
  3. A simply and analytical formula of the axial light intensity distribution behind a circular aperture is derived by using the helmhotz - kirchhoff integral theorem and the kirchhoff ' s boundary conditions. it is studied the nonparaxial on - axis intensity distribution throughout the whole space behind a circular aperture. an accurate formula to calculate the fresnel number of circular aperture is presented and the validity of usual fresnel number formula is reexamined. by using the analytical formula and diffraction integral formula, some numerical simulation comparisons are done, and it is shown that the results of the two methods are completely coincident

    用亥姆霍茲-基爾霍夫積分定理和基爾霍夫邊界條件，推導出了平面波經小圓孔非傍軸衍射時軸上強度的簡單解析表達式，研究了平面波經小圓孔后整個衍射空間非傍軸的軸上光強分佈.給出了計算圓孔菲涅爾數的精確公式，重新檢查了通常的菲涅爾數公式的有效性.數值計算顯示，應用解析表達式所得的結果與應用衍射積分公式所得的結果完全一致
  4. The explicit finite element method ( fem ) based on the varying time - step was selected to analyse the dynamic roll - pass process ; the nodes on the leading face of the steady - state elements set was extracted and projected onto a plane to give the required mesh, also called the origin mesh ; the implicit fem was selected to analyses the inter - pass transient thermal process ; a geometric part from the mesh was generated and meshed by using the quadrilateral elements, a heat transfer analysis was selected to transfer the node temperature data ; a new model was created by using hexahedral elements, mapping the node temperature and the equivalent plastic strain on the integration points

    利用基於變步長中心差分格式的顯式積分方法分析瞬態軋制過程；提取穩態單元集節點形成截面網格；利用隱式積分方法分析軋制道次間隙瞬態溫度場；對型鋼斷面進行平面四邊形網格劃分並映射節點溫度數據；利用六面體單元構建有限元分析模型，映射單元節點的溫度、積分點的等效塑性應變，進行數值分析。
  5. After that in chapter four, a axisymmetric hybrid stress finite element for piezoelectric media is presented on the optimization condition for the coupling of electrical and elasticity. it ' s practicable and rational in the numerical example. in the fifth chapter, we study the p - version hybrid stress fem

    本文還研究了基於升階譜的雜交應力元方法，建立了一系列p 5的高階雜交應力單元列式，數值計算結果顯示採用正確的高斯積分，將使得本方法切實可行，同時兼有升階譜和雜交元的優勢。
  6. A parametric analysis of the inviscid effects of leading edge sweep, sidewall compression, width - height ratio, cowl position and inflow mach number on spillage is finished. numerical simulations are completed for a series of inlets at various flight height and velocity. the research indicates that the area of spillage window, which is mainly determined by the position of the cowl, significantly influences the spillage characteristic of the scramjet inlet

    闡明了側板后掠的側壓進氣道設計參數對構型溢流影響;對不同側板配置方式的側壓式進氣道進行了數值模擬，通過對比分析，發現由唇口板的位置所決定的溢流窗面積的大小對進氣道溢流特性的影響顯著。
  7. By means of the precise integration method with lagrangian interpolation the trajectory of the shaft center, the poincare mapping and the bifurcation graphs are numerically given. the results predicted by the floquet theory are checked and the long - term dynamic behavior of the system is predicted. it is shown that the system has rich nonlinear behaviors at some m combination of the four parameters, for examples, multi - frequency subharmonic resonance, as well as chaos phenomenon from doubling bifurcation and twice hopf bifurcation

    通過lagrange插值精細積分法數值給出系統的軸心軌跡圖、 poincar映射圖、分叉圖，檢驗floquet理論預測結果並預測系統的長期性態，顯示系統在四個參數組合的某些范圍內具有豐富的非線性特性，還存在多形式次諧波解，以及由倍周期分叉、二次hopf分叉通往混沌的現象。
  8. The main contributions of this work are included as follows : ( 1 ) numerical tests of the outside axial and helical flows were carried out respectively. the velocities and pressure profiles and shear distributions have been obtained and they were compared due to the different flow field. it is concluded that when no particles are deposited, the helical flow would lower the pressure on membrane surface to some little extent but not markedly

    （ 1 ）對外軸向流和外切向流兩種方式下膜器環隙內流場進行變參數數值實驗，作出流場及切應力的分佈規律，分析無顆粒沉積時層流條件下流動結構對過濾通量的影響，認為：採用外旋流的方式將對膜面壓力有削弱作用，但並不明顯。
  9. In this thesis a numerical model to solve the planear 2 - d depth - integrated flow ( dif ) has been established with irregular body - fitted mesh finite volume method and explicit maccormack predictor - corrector method and applied to the study of damming caused by a bridge pier under 14 working conditions varied with the combination of different pier shape. flow rate and contraction ratio

    本論文採用非規則貼體網格有限體積法和顯式maccormack預測-校正法求解平面二維水深積分方程，對明渠水流運動的數值模擬方法進行了研究，並且應用該數值模型計算了14種不同的橋墩體型、來流、收縮比的組合工況下的橋墩壅水問題。
  10. By driving expressions and using the method in numerical integration, the results of numerical calculations are analyzed, discussed and contrasted with different conditions, and they showed that there are evident differences in the mean attenuation, scattering, and back scattering cross sections of oblate spheroid particles when the variance is so small that it is near to zero namely it is the same as the rotatory axes are parallel with one direction and when h - polarized and v - polarized incident waves happened. these differences are depended on the relative differences in the average orientation of rotatory axes and the polarized directions of incident wave

    通過公式推導和數值積分計算並對結果做了討論和分析，對比各種情況表明：扁橢球粒子群在方差很小接近為0時，與粒子群旋轉軸一致取向的情況相同，入射波水平極化和垂直極化時的平均衰減截面、平均散射截面、平均後向散射截面有明顯的不同，這決定於旋轉軸平均取向和入射波極化方向的相對差異。
分享友人
分享到 Line

分享到臉書