顯微流態的 的英文怎麼說

中文拼音 [xiǎnwéiliútàide]
顯微流態的 英文
microfluidal
  • 顯 : Ⅰ形容詞1 （明顯） apparent; obvious; noticeable; evident 2 （有名聲有權勢的） illustrious and inf...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 的 : 4次方是 The fourth power of 2 is direction
  • 顯微 : microadiography
  1. In this paper, the flow pattern defects ( fpds ) were revealed by secco etchant and their shape, distribution on wafer and tip structure were studied in details by optical microscope and atomic force microscope ( afm ). the relationship between etching time and the tip structure of fpds was also discussed. furthermore, by studying the effect of rapid thermal annealing ( rta ) on the density of fpds in ar, the annihilation mechanism of fpds was discussed in this paper

    本文將cz硅單晶片在secco腐蝕液中擇優腐蝕后，用光學顯微鏡和原子力顯微鏡對流動圖形缺陷（ flowpatterndefects ， fpds ）在矽片中的形態、分佈及其端部的微觀結構進行了仔細地觀察和研究，並討論了腐蝕時間對fpds缺陷端部結構的影響；本文還通過研究ar氣氛下快速退火（ rapidthermalannealing ， rta ）對fpds缺陷密度的影響，初步探討了fpds的消除機理。
  2. Electric - controller is nubbin in developping. we are based on designing to structure of circuit, we are dead against in time and stabilization for controlling and communications, precision and rapidity for transformation etc. we have completed to select on microprocessor, clock - frequency and a / d transfer. it carry out transformation for valve position signal, and select on solid - switch ac

    在控制器的電路結構設計的基礎上，考慮到通訊、控制的及時、穩定、轉換的精度和速度等幾方面，主要完成對微處理器的選擇、時鐘頻率和a d轉換器的選用，閥位變送功能的實現，固態交流開關和顯示器的選擇等。
  3. On the backgrounds of researches inside and outside country, and cooperating experiments with theories analyses, the influence of different processing technology parameters and different sbs modifier sorts on the sbs modified asphalts " properties has been studied. at the same time, their microstructure are observed through fluorescence optical microscopy and scanning electronic microscopy, thus to direct modified asphalt production. on the above conclusion ' s basement, analysing some disadvantages of the storage stability test of sbs modified asphalt in the current specification, a new storage stability test apparatus is developed

    本文在參考國內外研究的基礎上，採用理論、試驗相結合的方法，研究加工工藝參數以及改性劑種類等對sbs改性瀝青性能的影響，並通過熒光顯微鏡、掃描電鏡分析其微觀形態，從而指導sbs改性瀝青的生產；在此基礎上，分析我國現行規范用來評價sbs改性瀝青儲存穩定性方面的不足，開發了新的試驗儀，根據動態剪切流變試驗結果和微觀狀態分析，提出一個新的指標? ?離析率r _ s來評價sbs改性瀝青的儲存穩定性；最後，針對不穩定的改性瀝青提出改善措施，研究證明摻加增容劑和穩定劑是行之有效的方法。
  4. Results : it was showed that the vessel loop deformity was increased, with prolonged vessel loop, narrowed vessel, slowed blood flow and increased erythrocyte aggregation in the patieats compared with the control

    結果：中風組血流變的還原粘度、全血粘度的低切變率，中風組甲襞微循環管袢形態與對照組比較，差異顯著。
  5. Usually, hpm devices working in the high current and large field amplitude state, after the field reaches saturation, the nonlinear effects will become extremely strong so that the intrinsic nonlinear phenomena ( for example limit cycle oscillation and chaotic behavior ) of the system occur. these nonlinear behaviors directly influence the output characteristic of the devices

    在通常情況下，高功率微波源器件都工作在大電流和強場工作狀態，尤其在場達到飽和以後，系統的非線性效應將變得非常明顯，非線性系統所特有的一些現象（如，極限環型振蕩和混沌行為）將出現，這些非線性現象直接影響器件的各種輸出特性。
  6. Plc is widely used in automatic control for its strong function, high reliability, wide applicability, modular structure and etc. many customer services, such as showing process - flow charts, displaying dynamic - data - base interfaces, editing tables, generating charts, managing production and etc, can be provided by connecting personal computers ( pcs ) to a plc network. in a plc - pc system, plcs, which serves as the low - level units, are used to collect and control the data, ( for example, the on / off quantities and analog input / output quantities )

    把個人計算機連入plc網路可以向用戶提供諸如工藝流程圖顯示、動態數據畫面顯示、報表編制、趨勢圖生成、窗口技術以及生產管理等多種功能，作為底層單元的plc完成對現場開關量、模擬輸入輸出量的控制處理，而利用微型計算機良好的人機對話界面和數據處理功能，實現對一臺或多臺plc進行監控，充分發揮plc可靠、靈活的控制性能和計算機在管理、監控等方面的優勢，提高控制系統的整體自動化程度。
  7. Two percent of hpmc appeared to be a satisfying suspending agent by evaluating the sedimentation rate and the redispersion of nabumetone

    通過對其沉降體積比、再分散性指標的考察，篩選了2 % hpmc助懸劑，並從流變學、混懸劑黏度及顯微形態等方面對其穩定性進行了研究。
  8. Plastic deformation happened in the worn surface where fe element was found, so pam micro - fiber supported part of the load and prevented the further deformation. on the condition of high speed and high load, the worn surface of pam1 / nylon 6 composites was nearly melted and formed comparative uniform transfer on the surface of steel, which accounted for the rather low wear mass loss. the infrared analysis showed that the a small quantity of transition of crystal form from into of nylon and its composites happened during the friction because of the high temperature and strong sheering strength

    通過對復合材料耐磨性能研究表明：復合材料的摩擦系數隨載荷的增加而逐步下降，且磨損表面有明顯的塑性變形；從能譜分析結果來看，復合材料表面有fe的存在，表明pam微纖承受了部分載荷，並阻止了基體的進一步塑性變形及粘著轉移；在高速高載時， pam1 /尼龍6磨損表面處于粘流態，並在鋼環表面形成了連續的轉移膜，表現出較好的耐磨損性能，且在高溫和強剪切力的作用下，材料基體發生了少量的晶體向晶體的轉移。
  9. A very much different fluxes model was suggested for remote sensing estimation, which takes account of the effects of advections in vertically or horizontally anisothermal vegetations. the inter - exchange of heat can result in lower total sensible heat flux and higher total latent heat flux of the considered areas. this method is designed technically for the simulations of pixel, is a try of new generation effluxes model

    針對遙感基於像元計算的特點，提出一種全新的通量計算方法，模型的結構和思路專為遙感像元面上計算的特點而設計，主要考慮由地表非均勻和不連續性引起的像元內部熱量交換? ?局地微平流對顯熱和潛熱通量的影響，驗證表明，這種考慮平流的非均勻模型可以較好地模擬地表非均勻狀態下的熱量通量。
  10. The result shows that a new kind of flow will be produced instead of the microjet when frequencies exceed a critical value, suppose the characteristic velocity of the micro - actuator remains constant

    結果顯示：在作動器出口最大速度一定的情況下，當頻率超過一臨界值后將無法產生微射流，而產生另外一種形態的流動。
  11. Microfluidics is the minitiarization of fluid - based biochemistry to very small volumes such that a large series of chemical reactions can be performed in parallel in a microarray format ( see microarray )

    顯微流是將液相生化反應縮小至非常小的量，這樣大系列的化學反應可以在相同的微點陣狀態下進行。
  12. Examples of microfluidics - based applications include screening of biological targets, synthesis of combinatorial libraries, synthesis of dna oligomers, and analysis of polymorphic proteins, all of which can be performed in large high - throughput parallel arrays because of microfluidics

    顯微射流技術應用的例子包括生物靶子的篩選、組合文庫的形成、 dna寡聚體的合成，蛋白質多態性研究所有這些都因為顯微射流技術而可以大規模進行。
分享友人
分享到 Line

分享到臉書