顯微處理 的英文怎麼說

中文拼音 [xiǎnwéichǔ]
顯微處理 英文
microprocessing
  • : Ⅰ形容詞1 (明顯) apparent; obvious; noticeable; evident 2 (有名聲有權勢的) illustrious and inf...
  • : 處名詞1 (地方) place 2 (方面; 某一點) part; point 3 (機關或機關里一個部門) department; offi...
  • : Ⅰ名詞1 (物質組織的條紋) texture; grain (in wood skin etc ) 2 (道理;事理) reason; logic; tru...
  • 顯微 : microadiography
  1. Clearly, this is virtually never the case in a microprocessor system.

    然,這種情況在器系統中實際上是永遠不會出現的。
  2. Digital display with microprocessor, input mv v

    器的數字示器,輸入mv v
  3. Electric - controller is nubbin in developping. we are based on designing to structure of circuit, we are dead against in time and stabilization for controlling and communications, precision and rapidity for transformation etc. we have completed to select on microprocessor, clock - frequency and a / d transfer. it carry out transformation for valve position signal, and select on solid - switch ac

    在控制器的電路結構設計的基礎上,考慮到通訊、控制的及時、穩定、轉換的精度和速度等幾方面,主要完成對器的選擇、時鐘頻率和a d轉換器的選用,閥位變送功能的實現,固態交流開關和示器的選擇等。
  4. Adopt advanced microprocessor for smart control, it is suitable for display and control temperature, humidity, pressure, liquid level, instantaneous flow, speed and so on in many physical quantity inspect signal, and can data - logging multi - channel measure signal

    採用先進的器進行智能控制,適用於溫度濕度壓力液位瞬時流量速度等多種物量檢測信號的示控制,可巡迴檢測多路測量信號。
  5. Intelligent multi - channel data - logging display controller adopt advanced microprocessor for smart control, it is suitable for display and control temperature, humidity, pressure, liquid level, instantaneous flow, speed and so on in many physical quantity inspect signal, and can data - logging multi - channel measure signal. it also can carry on high - accuracy linear correction to various non - linear input signals

    雙迴路數字光柱示控制儀採用先進的器進行智能控制,適用於溫度濕度壓力液位瞬時流量速度等多種物量檢測信號的示及控制,並能對各種非線性輸入信號進行高精度的線性校正。
  6. The system uses the embedded microprocessor s3c44b0x to control the sensor to gather water data, then processes, saves and displays them. at the same time it waits to be connected with pc at the control center, receives command - string, then uses modem to send the corresponding data with predefined communication protocol to pc through pstn

    測點通過嵌入式器s3c44box控制傳感器採集水位數據,后保存並示;同時等待與控制中心的pc機建立連接,並根據接收的命令將相應的數據按照預先約定的通信協議,通過modem經公用電話網傳送到控制中心。
  7. The hardware of the monitoring system mainly consists of the dsp controller, nonvolatile memory, led, clock management, keyboard interface, sci communication units and can communication units

    系統的硬體部分主要包括了dsp器的基本外圍電路、非易失性存儲、 led示、時鐘管、鍵盤介面,以及sci通信和can通信等單元電路。
  8. According to the characters of microscopic pathologic image and requirement of clinic and medical scientific research, we implemented various kinds of ootor image processing and parameter measuring approaches, including image movement and adjustment, brightness / contrast adjustment, image edit and length, acreage, amount measurement of ro1

    系統針對圖像的特點,結合臨床應用和醫學科研工作的需求,重點建立了一系列適合醫學應用的彩色圖像方法和特徵參數測量方法。這些方法包括圖像的移動、縮放、亮度對比度調整、圖像編輯以及感興趣區域長度、面積、數量等特徵參數的測量分析功能。
  9. The signal accesses the microprocessor and undergoes internal a / d transformation, data procession and filtration, then directly drives the digital luminescence tubes to display the concentration of the detected methane and send out an acousto - optic alarm and show low potential detection

    此信號進入器經過內部a / d轉換、數據、濾波之後直接驅動發光數碼管示出被測甲烷的濃度,並給出聲光報警、低電位檢測等。
  10. Eddy - current sensor conversion circuit consist amplification circuit, band - pass filter circuit, demodulation circuit, differentiation phase and data sampling circuit. these circuits are used to convert the test signal of eddy - current sensor to discrete signal tend to process. the microprocessor system that formed of dsp chip is used to data fitting of test system, data displaying and data communicating with personal computer, etc. the interference questions of hardware design and the measure of eliminating interference signal in the subject are introduced in the last of this chapter

    硬體電路的設計主要分三大部分來實現:激勵源電路部分,由分頻電路和頻率合成電路組成,產生頻率穩定的激勵信號以確保檢測任務的正常進行;傳感器變換電路部分,由放大電路、濾波電路、檢波電路、鑒相電路和數據採集電路組成,主要將電渦流傳感器檢測線圈檢測到的信號變換成只含有被測信息的離散信號,易於后續電路;由dsp晶元構成的系統,主要完成檢測系統的數據擬合、示及與主機通信等功能。
  11. On the basis of familiar with can bus and gsm communication, considering hev ( hybrid electric vehicle ) battery administrative system ' s demand for the host pc monitoring system, i have designed can - rs232 converter gateway to realize transmission the real - time data from can node to rs232 serial port, which is carried out by the project of at89c52 mcu + sja1000 can controller + 82c250 can controller interface. host monitoring software has accomplished real - time datas display, storage, historical datas graph analysis and storage fashion change from access to excel, at the same time, realized important datas transmission remotely with tc35 short message module. system software programs in assembly and vb

    Can - rs232轉換網關採用at89c52器+ sja1000can控制器+ pca82c250can控制器介面實現對can總線節點通訊的監聽,並將其轉換成rs232串口電平發送到pc機串口,同時用siemens公司的tc35模塊和at指令實現現場採集系統重要數據和錯誤信息的短消息通訊。在上位pc機監控系統中,主要完成的是對串口設置的選擇控制、現場採集數據的實時刷新示、歷史數據的圖表分析及數據的access數據庫存儲和excel電子表格的轉換。系統軟體採用匯編語言和vb實現。
  12. Abstract : based on the electronic focus technology development of state - of - the - art, the paper suggested a complete apparatus s cheme ofauto - focus based on sspd ( self - scanned photodiode array ) and 8098 singl e chipprocessor, giving out a focus criterion algorithm based on image high freq uencystatistics. the function of auto - focus of both reflected and transparent o pticalmicroscope was realized. meanwhile some corresponding problems such as sta bility of lightsource, step motor driving etc. were also discussed, which greatly improved the accuracy andreliability of the system

    文摘:在介紹與分析了國內外電子調焦系統的技術發展與現狀的基礎上,提出了一種基於sspd (自掃描光電二極體列陣)與8098單片器自動調焦的整體技術方案,給出了基於圖像高頻成分統計的聚焦判識演算法,在此基礎上實現了反射式與透射式光學鏡的自動調焦,同時對系統的可靠性有關的其它相關問題如光源穩定性、步進電機驅動等問題也進行了討論。
  13. Digital display with microprocessor, input v ma

    器的數字示器,輸入v ma
  14. Digital indicator with microcontroller, led 5 - digit

    帶有器的數字示器, led 5位數字
  15. Embedded processors dorminate the keyboard, mouse, disk driver, hard disk, display, network card, modem, sound card, printer, scanner, digital camera and usb hub, etc. in the fields of control, communication, instrument, automobile, shipping, aeronautics, military, and consumable, embedded computer is a master

    一臺通用計算機的外部設備上就包含了5 - 10個嵌入式器,鍵盤、鼠標、軟驅、硬盤、示器、示卡、網卡、 modem 、聲卡、印表機、掃描儀、數字相機、 usb集線器等均是由嵌入式器控制的。在工業流水線控制、通訊、儀器儀表、汽車、船舶、航空航天、軍事裝備、消費類產品等領域更是嵌入式計算機的天下。
  16. The video signal processing circuit realizes the primary catching, filtering and signal amplifying. variable threshold binarization processing circuit and two - channel counter are designed to sample to count the output pulse signal, which is processed, deposited and displayed in microprocessor. the communication interface circuit with the computer is also designed

    視頻信號電路完成了原始信號的初級捕捉、濾波、視頻放大等,設計了浮動閾值二值化電路,採用兩路計數器對輸出脈沖信號采樣計數,最後送入器進行運算,可實現測量值的儲存、示等,並設計了與上位機的通訊介面。
  17. With the rapid development of microchip and encryption techniques, the effect of digital signature card, namely smart card supporting rsa algorithm and embedding microcontroller, is increasingly obvious in pki system

    型晶元及加密技術的迅速發展使數字簽名卡,即支持rsa演算法/嵌有器晶元的智能卡在pki體系中的作用日趨明
  18. Based on the theory about singlechip applied in modern control ’ s communications, the thesis is about designed a communicate system which based on the pic18f8260 microprocessors and achieved sms and had been publishing the news on the led ’ s panel via serial port. the thesis is expatiated the process of system design from two parts : hardware and sofeware

    本論文是基於單片機在現代控制中的通信應用這一論,逐步設計以pic18f8260器為核心,通過串列埠實現sms短消息服務並將信息發布至led示屏的通信系統。本論文分別從兩大部分進行闡述系統設計的過程,即硬體部分和軟體部分。
  19. These sensor are increment rotary encoder ~ absolute rotary encoder and resolver transmitter, at the same time, design and make signal disposal ii - 1 circuit for three sensor, the function of signal disposal circuit is not only disposing signal of sensor, but also collecting data from sensor via microprocessor and sending these data to pc via serial communication. the pc receives these data and displays the working status of experiment bench via virtual instrument software

    並製作了三種傳感器的信號電路,信號電路除了完成對傳感器信號的,還通過器採集傳感器的信息,並通過串列通訊將這些信息送于上位監視計算機,上位監視計算機接收這些信息,並通過虛擬儀器軟體示系統的工作狀況。
  20. 8 - loop flash alarm controller adopts advanced microprocessor for smart control, and can match use with our any control instrument or other contact control instrument. it can detect simultaneously 8 - loop signals. inputs and mainframe both adopt photoelectric isolation structure

    智能多路巡檢示控制儀採用先進的器進行智能控制,適用於溫度濕度壓力液位瞬時流量速度等多種物量檢測信號的示控制,可巡迴檢測多路測量信號。
分享友人