饋電設備 的英文怎麼說

中文拼音 [kuìdiànshèbèi]
饋電設備 英文
feed equipment
  • 饋 : 動詞（饋贈） make a present of
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 設 : Ⅰ動詞1 （設立; 布置） set up; establish; found 2 （籌劃） work out : 設計陷害 plot a frame up; fr...
  • 備 : Ⅰ動詞1 （具備; 具有） have; be equipped with 2 （準備） prepare; provide with; get ready 3 （防備...
  • 設備 : equipment; device; facility; implementor; apparatus; installation; appointment; furnishing; setou...
  1. At first, according to the concrete requirement of the servo control system, a collective scheme, which provide guarantee to meet the requirements of the global performance, is established. in this scheme, the structure of gimbal and the torque motor driven mode are adopted, and angle measurement is accomplished by inductosyn and velocity measurement is accomplished by dynamically tuned gyro respectively

    首先，根據目標真值測量設備伺服系統的具體要求，確定了地平式常平架結構，力矩電機驅動，分別採用動力調諧式速率陀螺儀及圓盤式感應同步器作為速率及位置反饋元件這一總體方案，為伺服系統滿足整體性能指標要求提供了保證。
  2. In the hardware design, the paper completes modules ’ design like outside memory, patulous a / d, patulous d / a, rs232 communication, ecan communication, led control, keyboard control, distant control, emulation, reset, logic voltage switch, dsp supply power regulate and ac - dc power circuit, as well as room layout design like anterior panel, back panel etc. and dsp transfers data with peripheral equipments except outside memory using serial ports. besides, the whole circuit is configured in interrupt response. thus, it can meet system demand as well as take full advantage of tms320f2812 ’ s hardware resource. in the software design, the paper finishs programs like the interface programms intercommunicates with people, the distant control program, ad and da modules ’ control program, in addition, the paper select the velocity and acceleration state - feedback algorithm and is written in the program. the software design uses dsp integrate exploiting environment named ccs2. 2 of ti inc. as software instrument, and programs with the combination of c language and assembly language. moreover, in order to maintenance or modify the software expediently and shorten software ’ s exploitation time, the design adopt software modularization technique. finally, some air cylinder experiments are carried out to proved that the pneumatic controller is very practical

    在硬體設計中，本文完成了片外存儲器擴展、 a / d擴展、 d / a擴展、 rs232通信介面、 ecan通信總線介面、液晶顯示控制、鍵盤控制、遠程控制、模擬、復位、邏輯電平轉換、 dsp工作電源校正電路和ac - dc電源等模塊設計以及控制器前面板、後面板等的空間布局設計。其中dsp與除外部存儲器的外圍設備之間的數據傳送全部採用串口通信，同時系統電路配置成中斷響應方式，這樣既滿足了系統要求，又充分利用了tms320f2812的硬體資源。在軟體設計中，本文完成了人機界面功能模塊、遠程控制模塊、 ad擴展模塊、 da擴展模塊、速度和加速度狀態反饋的控制演算法的程序設計。
  3. Electrical equipment for aircraft. feeder protection housing for direct current generator

    飛機電氣設備.直流發電機饋線保護箱
  4. Hand crimping tools - tools for the crimp termination of electric cables and wires for low frequency and radio frequency applications - part 2 - 5 : particular requirements for the termination of twin - ax cable for databus applications

    手工壓接工具.低頻和射頻設備用電纜和電線的壓接終端工具.第2 - 5部分:數據總線設備用屏蔽雙導線饋電線電纜的終端的特殊要求
  5. This machine adopt the auto - weighting feed back system, combined with the computer handling. it exceeds the traditional upright filler in both the theory of the machine and teh effect. it is the real computer intelligentize filler

    該機採用自動稱重反饋系統，結合微機操作，從機理效果等方面完全超脫于傳統意義上的直列式灌裝機，是真正的電腦智能化灌裝設備。
  6. As the main automation contractor, emerson will leverage its significant engineering expertise to design, install and commission the digital automation system and also perform various specialized services on the units ' electrical subsystems, such as the generator, transformers, feeder ducts and switchgear

    作為主自動化承包商，艾默生將派出其最具經驗的工程專家來設計，安裝和調試數字自動化系統，以及為機組的電氣子系統，例如發電機，變壓器，饋電管道和開關設備等，提供多種專業服務。
  7. Sequential control devices, feed back control, computer control, interlock circuit, star - delta starting, contactors, etc

    控制設備系列、反饋控制、電腦控制、連鎖性線路、量角起動及接觸器等控制設備
  8. Insulated cables and flexible cords for installations - cables for supply leads for heating equipment by means of heating cable for embedding in walls of building

    裝置用絕緣電纜和軟線.採用嵌入建築物墻壁內的電熱電纜加熱設備用饋電線電纜
  9. Communication networks and systems in substations - basic communication structure for substation and feeder equipment - common data classes

    變電所的通信網路和系統.變電所和饋電設備用基本通信結構.公用數據種類
  10. Communication networks and systems in substations - basic communication structure for substation and feeder equipment - principles and models

    變電所的通信網路和系統.變電所和饋電設備用基本通信結構.原理和模型
  11. Communication networks and systems in substations - part 7 - 1 : basic communication structure for substation and feeder equipment ; principles and models

    變電所的通信網路和系統.第7 - 1部分:變電所和饋電設備用基本通信結構.原理和模型
  12. Communication networks and systems in substations - part 7 - 3 : basic communication structure for substation and feeder equipment ; common data classes

    變電所的通信網路和系統.第7 - 3部分:變電所和饋電設備用基本通信結構.公用數據種類
  13. Communication networks and systems in substations - part 7 - 1 : basic communication structure for substations and feeder equipment - principles and models

    變電所通信網路和系統.第7 - 1部分:變電所和饋電設備用基本通信結構.原則和模型
  14. Communication networks and systems in substations - partie 7 - 3 : basic communication structure for substations and feeder equipment - common data classes

    變電站的通信網路和系統.第7 - 3部分:變電站和饋電設備用基本通信結構.通用數據分級
  15. Acsi communication networks and systems in substations - part 7 - 2 : basic communication structure for substation and feeder equipment - abstract communication service interface

    變電站的通信網路和系統.第7 - 2部分:變電站和饋電設備用基本通信結構.抽象通信服務介面
  16. Acsi communication networks and systems in substations - part 7 - 2 : basic communication structure for substation and feeder equipment ; abstract communication service interface acsi

    變電所的通信網路和系統.第7 - 2部分:變電所和饋電設備用基本通信結構.抽象通信服務介面
  17. Communication networks and systems in substations - part 7 - 4 : basic communication structure for substation and feeder equipment ; compatible logical node classes and data classes

    變電所的通信網路和系統.第7 - 4部分:變電所和饋電設備用基本通信結構.兼容邏輯節點種類和數據種類
  18. Communication networks and systems in substations - part 7 - 4 : basic communication structure for substation and feeder equipment - compatible logical node classes and data classes

    變電站的通信網路和系統.第7 - 4部分:變電站和饋電設備用基本通信結構.兼容邏輯節點分級和數據分級
  19. The monitoring system can monitor not only equipment in substation but also reclosers in the feeder line. this project combines the functions of integrated automation and feeder automation. this system has been running safely for 7 month, and achieved desired result

    此方案中站內監控系統不僅可以實現站內設備的數據採集、運行監控；還可以通過can總線，監視變電站出線上分段環網重合器的運行，將饋線設備運行數據作為rtu數據的一部分，傳送給調度中心，而無需附加的ftu ，實現綜合自動化和饋線自動化功能。
  20. Communication networks and systems in substations part 7 - 3 : basic communication structure for substation and feeder equipment common data classes

    變電站通信網路和系統.第7 - 3部分:變電站和饋線設備的基本通信結構.公用數據類
分享友人
分享到 Line

分享到臉書