驅氣效率 的英文怎麼說

中文拼音 [xiào]
驅氣效率 英文
efficiency,scavenging
  • : 動詞1. (趕) drive (a horse, car, etc. ) 2. (快跑) run quickly 3. (趕走) expel; disperse
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : Ⅰ名詞(效果; 功用) effect; efficiency; result Ⅱ動詞1 (仿效) imitate; follow the example of 2 ...
  • : 率名詞(比值) rate; ratio; proportion
  • 效率 : productiveness; efficiency; productivity; workpiece ratio
  1. It is studied that the formation mechanism of taylor bubble and its control method in gas - liquid two - phase flow, which affects the pressure balance and mechanical driving efficiency in the flow of petroleum engineering. experiments show that the formation of taylor bubble in gas - liquid two - phase flow is due to the intensive congregation and amalgamation of small bubbles driven by void fraction waves and that the highly turbulent flow is able to restrain this formation. thus, the flow regime transition may be checked by increasing the flow turbulence and controlling the disturbed frequency

    對大管徑-液兩相流動中嚴重影響壓力平衡與機械的段塞流生成機制和控制方法進行了研究,實驗證明段塞流的形成是由於空隙波的大幅度增長使泡高度集中,並形成聚並所致。強湍流運動可以抑制taylor泡的形成。因此,通過強化湍流或控制擾動頻可以對泡聚並起明顯的抑制作用。
  2. Principal conclusions were drawn as the following : the non compatibility of pressure or velocity of the gas on both sides of the contact surface is the cause of the formation of shock wave ; the heating effect of reflective shock wave to driving gas during charging or exhausting process is the internal mechanism of peak oscillating effect, and all the factors that influence the formation and the running of the shock wave will influence the peak oscillating frequency, cooling effect

    主要結論如下:熱分離機內激波形成的原因是射瞬間接觸面兩側壓力和速度不相容;峰值振蕩應的內在機制為反射激波對充階段的或低溫排的加熱,凡是影響激波形成及運動的因素都將對峰值振蕩頻、冷應及熱應產生影響;當充、排時間比為0 . 1763時,最佳射流激勵頻出現在高階峰值振蕩頻上。
  3. The hydrocarbon expulsion efficiency of source rockprimary migration is usually high because of its property of natural drive

    因油初次運移為自然替,因此源巖的排烴較高。
  4. According to the requirements of propeller aerocraft model test in wind tunnel, specifications of the driven motor is presented by aerodynamic analysis, and a short - term operated high power density three - phase induction motor is developed with reasonably designing the motor, such as electromagnetism load, heat checkout and high - efficiency heat exchanger

    摘要針對螺旋槳飛機模型帶動力風洞實驗要求,通過動性能分析提出動電機的技術指標,在滿足結構約束的條件下,通過合理設計電機的電磁負荷、校核發熱、採用高冷卻裝置等,研製出短時工作制高功密度三相異步電機。
  5. Reeling is equipped with shaft - less pneumatic cone top device, individual motor drive, double work - place, non - stop high speed automatic picking function, which upgrades the working efficiency

    收、卷採用無軸動錐頂裝置,單獨電機動,雙工位收放料,不停機高速自動接料功能,提高了工作
  6. Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced

    通過分析溫度、氮對原油粘度的影響,對比不同注氮量、不同注入方式等對蒸汽果的影響,弄清了氮輔助蒸汽增產的機理主要表現在:氮輔助后增加攜熱能力,降低殘余油飽和度,氮的壓縮膨脹作用分散和改變了原油流動形態,增強了原油流動性;擴大蒸汽的波及體積,補充地層能量,提高回採水,強化蒸汽蒸餾應。
  7. Portable stored - pressure powder series extinguishers are effective extinguishing appliances, in which extinguishing gaent sodium bicarbonate and ammonium phosphate powder together with the driveng gas - nitrogen are filled in a full - sealed container. during application, nitrogen drives to jetting powder for extinguishing, which is fast and effective in extinguishing, light in weight, convenient and simple in operation, safe and reliable

    手提式乾粉系列滅火器是一種輕便高的滅火器材,它使用磷酸銨鹽和碳酸氫鈉乾粉滅火劑和體氮一起灌裝在全封閉的容器內,滅火時由氮動乾粉滅火劑噴射滅火,具有滅火速度快、重量輕、高、使用方便、靈活、安全、可靠等特點。
  8. It performs a large amount of physical simulation experiment using the multi - function displacement equipment which is imported from american temco company and summarizes the effecting rule of the injected alternating slug size on the displacement efficiency during the alternating injection of gas and liquid. it uses orthogonal method to study the set and type of pre - slug and post - slug and their effect on the displacement efficiency of foam flooding and optimizes the main and sub - slug size so as to decrease the cost while keeping a high displacement efficiency

    通過從美國temco公司引進的多功能替設備,所做的大量的物理模擬試驗,總結出了液交替注入時,注入交替段塞的大小對的影響規律,利用正交設計法研究了前後段塞的設置與否及種類對泡沫復合的影響程度,還對主次段塞的大小進行優化,在保證較高的的前提下降低成本。
分享友人