驗濕器的 的英文怎麼說

中文拼音 [yànshīde]
驗濕器的 英文
hygroscopic
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • : Ⅰ形容詞(沾了水的或顯出含水分多的) wet; damp; humid Ⅱ名詞(姓氏) a surname
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • : 4次方是 The fourth power of 2 is direction
  1. An experimental study on humidifying performances in countercurrent humidifier

    逆流式空氣性能研究
  2. Second, the starting and stopping behaviors under disturbed condition are analyzed and calculated by using the dynamic concentrative parameter model, which gives some advice to better prescribe refrigeration system and set theoretic foundation for carrying out automatic control of refrigeration system. third, the normal running process is analyzed and calculated by means of rational matching theory, which gives some advice on how to better understand the parameter change under steady state and the affection of inlet - parameter on evaporator. fourth, the simulation software with dynamic characteristic is designed, which can be applied to calculate thernio - parameter of cryogen, air humidity and frost thickness under different initial and boundary conditions, and to carry out dynamic simulation under conditions of dryness, wetness and frostiness, at the same time, to achieve detection and simulation at any stage from starting to stopping

    本文主要內容如下: 1 )對翅片管蒸發結構特點進行分析,選取適當微元控制體,就干、和霜工況下對每個微元分別進行傳熱傳質分析,基於經關系式確定霜有關參數,對于霜工況下霜生長建立模型,經適當假設,運用質量守恆、能量守恆和動量守恆方程建立適合動態模擬蒸發數學模型,為系統模擬奠定基礎; 2 )對蒸發在大擾動下開、停機過程,運用動態集中參數模型進行分析和計算,為更好地描述製冷系統運行全過程奠定基礎,同時也為製冷系統實現自動控制提供一定理論基礎; 3 )對蒸發正常運行過程,運用動態分佈參數和參數間定量耦合觀點來分析和計算,為更好地了解穩態工況下各點參數變化情況及各入口參數對蒸發動態特性影響即蒸發性能對各參數變化敏感性; 4 )編寫翅片管蒸發動態特性模擬計算程序,可以計算不同邊界條件和初始條件下製冷劑熱力參數、空氣溫度和霜厚度分佈場,實現對翅片管蒸發在干、和霜工況下動態模擬。
  3. Standard test method for determination of oxygen gas transmission rate, permeability and permeance at controlled relative humidity through barrier materials using a coulometric detector

    用庫侖檢測測定氧氣傳輸率滲透率和穿透屏蔽材料受控相對滲透標準試方法
  4. Semiconductor devices - mechanical and climatic test methods - internal moisture content measurement and the analysis of other residual gases

    半導體件.機械和氣候試方法.其他殘余氣體內部氣含量測量和分析
  5. Puts forward an improved method based on the theory in which the enthalpy difference is considered as the driving force in heat transfer under wet cooling conditions and thinks that the method can halve the testing work, require less for the experiment devices and reach higher accuracy

    認為該方法遵循了焓差是工況下換熱推動力規律,試工作量減少一半以上,對試裝置要求降低,由試數據整理出公式用於表冷熱力計算完全可以滿足空調常用范圍內要求。
  6. Testing of ion exchangers - determination of bulk weight density, equilibrium moisture content and solids

    離子交換.散重密度,平衡度和固體顆粒
  7. By adopting the method of saturated aqueous salt solutions, the paper designs the equipment to produce the humidity source and scale pi sensors. based on the design and long period measurement of demarcated equipment, we get the lots of curve and data that shows the linear relation between capacity and moisture and good linearity and resolving power

    採用飽和鹽溶液法得到相應級別度標準,對傳感進行標定試並採用相應數據處理方法,建立了感特徵量與氣相度之間數學關系,最終給出其數學模型和各種指標。
  8. Methods of testing for rating desiccant dehumidifiers utilizing heat for the regeneration process

    用於再生工藝利用熱乾燥劑減評定方法
  9. Dehumidifiers with electrically driven compressors. rating tests, marking, operational requirements and technical data sheet

    帶電動壓縮機.額定性能試標記和操作要求及技術數據單
  10. Dehumidifiers with electrically driven compressors - rating tests, marking, operational requirements and technical data sheet

    帶電動壓縮機.額定性能試標記和操作要求及技術數據表
  11. Thermodynamic performance experimental study and cooling number calculation of counter - flow spray humidifier in hat cycle

    循環逆流式熱力性能實研究及冷卻數計算
  12. Method of permeability test for moisture proof packing case

    防潮包裝容滲透性試方法
  13. Using lithium bromide aqueous solution as liquid desiccant, adopting the total heat transfer rate and enthalpy efficiency to describe the combined heat and mass transfer performance and the moisture removal rate and regenerative efficiency to describe the mass transfer performance of the regenerator, explores the effect of air and desiccant inlet parameters on the regenerator performance by experiment, and compares the result obtained with those of other counter - flow configurations previously published

    以溴化鋰溶液為除劑,採用總換熱量、全熱效率描述再生熱質交換總體效果,採用再生量、再生效率描述傳質效果,實測試了溶液和空氣進口參數對再生性能影響,並與逆流再生結果進行了比較。
  14. Test method for measuring maximum functional wet volume of utility vacuum cleaners

    測量通用真空吸塵最大功能性容量方法
  15. 3. based on theoretical analysis and experimental results, the high relative humidity was diffcult to maintain in the closed tissue culture system when all of the fluorescent lamps were turn on, because of deficiency of the humidifier ' s capacity and air ventilation by top air nozzle outlets and return air in the bottom. 4

    根據對加過程理論計算與試分析,指出本系統中降溫與加共存階段加效果不明顯,同時由於加容量不足,頂部送風和下部兩側回風通風方式造成了室內相對度無法在熒光燈全開時達到控制要求。
  16. The mathematical and physical dynamic models are given based on the adsorbent theory of porous medium. its running and parameters affecting its performance are numerically studied and the method that control the water content in the absorbent bed is recommended. the improvement on system configuration to recover heat is discussed and the operation scheme is given

    利用多孔介質吸附模型和平衡吸附壓力概念建立了該系統工作過程物理數學模型,數值模擬方法模擬了其工作過程和影響因素,提出了控制吸附床含方案,證了改進流程回收能量可行性並給出了操作方案,提出並分析了用熱電製冷回收水蒸氣潛熱節約電能方法。
  17. Experimental study of new wet cyclone dust collector

    新型式旋流除塵研究
  18. According to the practice on gezhouba to shanghai hvdc transmission project and in consideration of condition on three gorges hvdc project, some suggestions on protection of overvoltage and insulation coordination for outer insulation, against pollution - wet, dc neutral bus over - voltage and dc & ac filter are technically presented. it may be a reference in design of three gorges converter station

    根據葛南直流工程並結合三峽工程情況,在換流站外絕緣、直流耐污技術、直流中性母線過電壓防護、交直流濾波過電壓防護等方面提出了過電壓和絕緣配合技術要求,供設計參考。
  19. By means of the study of theory and experiment, the lp - ii ultrasonic humidifier was designed and manufactured, which was then used in the experiments on the wet compression at the inlet of supercharged diesel, and good results were obtained

    本文在理論和試研究基礎上,設計了用於增壓柴油機進氣加lp -型超聲波霧化,並用於試,取得了預期效果。
  20. Biological systems for testing sterilizers and sterilization processes - particular requirements for self - contained biological indicator systems for use in moist heat sterilizers

    滅菌和滅菌過程生物系統.用於熱滅菌自含生物指示系統特殊要求
分享友人