驗證裝置 的英文怎麼說

中文拼音 [yànzhèngzhuāngzhì]
驗證裝置 英文
demo plant
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 證 : Ⅰ動詞（證明） prove; verify; demonstrate Ⅱ名詞1 （證據） evidence; proof; testimony; witness 2 （...
  • 裝 : Ⅰ名詞1 （服裝） dress; outfit; attire; clothing 2 （演員的化裝品） stage makeup and costume Ⅱ動詞...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 驗證 : test and verify; checking; proving; testing; confirmation; [數學] corroboration; inspection; veri...
  • 裝置 : 1 （機器設備的配件）installation; device; apparatus; equipment; arrangement; gear; appliance; rig...
  1. Throughout the history of gyro testing on servo runs, these timers have proven irreplaceable for backup data behind far more complex timing devices.

    從整個伺服運轉的陀螺試驗過程來看，證明不能用后來更復雜的記時裝置代替這種記時器來得到輔助數據。
  2. Shipbuilding. binnacles and adjusting devices. type testing and certification

    造船工業.羅盤座和校正裝置.型式試驗和認證
  3. To eliminate the errors, the parallel double - sensor scheme which can eliminate the influence of the tooth space error of the measurement tooth - wheel and the contraposition double - sensor scheme which can reduce the influence of the installing eccentric error of the measurement tooth - wheel are demonstrated in detail and realized in this paper

    為消除這些誤差，詳細論證並實現了用並聯式雙傳感器方案消除測量齒盤分齒誤差的影響和用對置式雙傳感器方案消減測量齒盤安裝偏心誤差的影響。構建了試驗臺，驗證了誤差研究和雙傳感器方案的正確性。
  4. An experiment instrument of horizontal evaporation cooling motor with the same dimension such the calculation model is designed and established

    為了驗證計算結果，設計並建立了與計算模型尺寸相同的臥式蒸發冷卻電機楔形氣隙旋轉實驗裝置。
  5. This paper also studies an hvdc system based on leee fbm, a svc system based on ieee fbm and a statcom system based on ieee fbm. it proves the function of supplementare subsynchronous damping controller ( ssdc ) in the above devices to mitigate ssr. it also analyzes the influence of input signal of ssdc on ssr mitigation, tdeng hvdc as an example

    在psasp小干擾線性化平臺psaspaisst上，對基於ieeefbm的hvdc系統、基於ieeefbm的svc系統和基於ieeefbm的statcom系統分別進行了ssr小干擾穩定分析，驗證了在這些裝置中安裝次同步振蕩阻尼器（ ssdc ）對r的抑制作用，並以hvdc為例，研究了ssdc輸入信號對其抑制ssr的影響。
  6. The article provides the demonstrations of the light source, transmitting / receiving set and homochromor. the whole work is to fix on the sets and select the parameters of them. at the end of the design of sets, a whole set is achieved by assembling the three main parts

    本文在實驗裝置的設計方面，主要對包括光源、收發裝置、單色儀等部分進行了充分論證，確定了光源和收發裝置，對單色儀的參數進行了計算與選擇；在硬體設計的最後部分，對整個實驗裝置進行了系統整合，使之成為了一個有機的整體。
  7. The maximum range is the most important specification for a laser altimeter and 200km is the required level for the spaceborne laser altimeter in the lunar resources survey. in the paper, one kind of method and setting characterizing the laser altimeter ' s performance aiming at the specification of maximum range - noncooperative regulable attenuation was put forward and founded

    中科院知識創新重大方向?月球資源探測衛星激光高度計，要求實現200km的對月測距能力，本文以地面驗證激光高度計最大測程指標為目標，提出並建立一種激光高度計性能驗證方法?非合作目標可調衰減法和裝置。
  8. On the theory, the predictive function control method based on the state space is discussed and the simulation results validate the pfc method ' s advantages on robust and anti - jamming comparing with pid method by computer simulation. the application research includes the application of the software of predictive function control ( apc - pfc ) and the software of the multiple - variables predictive control ( apc - hiecori ). the former were applied in the temperature control chlorinating process and ph control in the process of zymolysis of penicillin, the latter were applied in the advanced control of reclaim equipment of lox in china petroleum & chemical corporation yangzi petrochemical co., ltd

    本文主要從理論和應用兩方面對預測控制方法進行了研究，理論方面主要是從預測函數控制的基本原理出發，研究了一般情況下的基於狀態空間描述的預測函數控制策略，並通過計算機模擬驗證了pfc演算法比常規pid演算法具有更好的魯棒性和抗干擾性：在實際工業過程的應用上，又分為兩類演算法及軟體的應用，預測函數控制策略及apc - pfc軟體的應用主要以聚乙烯氯化過程的溫度控制和青霉素發酵過程的ph值控制為主，多變量預測控制演算法和apc - hiecon軟體的應用主要以揚子石化公司的液化氣回收裝置先進控制為主。
  9. Aircraft - minimum airworthiness requirements and test conditions for certified air cargo unit load devices

    航空器.經認證的航空貨運集裝單元裝置最低適航性要求和試驗條件
  10. Aircraft. minimum airworthiness requirements and test conditions for certified air cargo unit load devices

    航空.獲取合格證的航空貨物單元裝載裝置的最低適航性要求和試驗條件
  11. It can be used not only to change the fire precision of the base bleed projectile, but also to improve the effect of reduction drag and expansion range. the calculating model of the secondary expansive pressure of the burning gas is constructed by means of analysis of the experimental resuits, it has been confirmed that the new base bleed unit can be designed, with the secondary expansive principle of the burning gas pressure. the engineering project of a hybrid base - bleed - rocket high - level efficient extended - range projectile is designed, with the secondary expansive principle of the burning gas pressure, the feasibility and the true worth of its engineering applications is validated in theory

    本文提出了底排燃氣壓力不隨外部壓力變化，既可改善底部彈射擊精度又可提高減阻效果的二次擴張原理，建立了底排燃氣二次擴張壓力的計算模型，並通過採用二次擴張原理的新型底排裝置與傳統底排裝置的對比試驗，驗證了新型底排裝置結構實現的可行性；完成了基於底排燃氣二次擴張高效增程原理的底排?火箭復合高效增程彈方案設計及其有關計算，從理論上驗證了其工程應用的可行性和實際價值。
  12. By the result of these experiments, acoustic emission ( ae ) was chosen to use in the research. at the same time, we analyse the phenomenon of acoustic emission at the base of theory, the characteristic signal of acoustic emission which comes from the faulty bearing at the angle of application, and the expression of the characteristic signal. contrast was also made on the data achieved separately from vibrational signal and ae signal, and it is proved that ae is feasible and available to the diagnosis to the fault of the rolling bearing

    主要工作有如下幾方面：對本段前期實驗室階段採用的振動法幅值域無量綱處理進行了分析，並研製了現場所使用的滾動軸承故障檢測裝置，將無量綱參數診斷法應用於段修現場，且做了大量試驗；對于現場試驗中所出現的問題進行了分析，提出將聲發射的方法用於軸承的在線故障診斷；從理論上分析了聲發射現象，從應用的角度分析故障軸承的聲發射信號的特徵以及聲發射信號特徵的表示方法，並在實驗室中，採用振動法和聲發射法實時檢測的實驗數據進行了對比和分析，證明了使用聲發射法對軸承故障檢測的可行性和有效性。
  13. We should avoid buying from commercial web sites that have not been verified as being secure. because if we don t know the background of the web site, we may be easily cheated

    我們應該避免和未裝置已通過安全驗證的商業網站購買東西，因為與背景不明的網站交易，較容易受騙。
  14. Fire hazard testing - part 11 - 5 : test flames - needle - flame test method - apparatus, confirmatory test arrangement and guidance

    著火危險試驗.第11 - 5部分:試驗火焰.針狀火焰試驗方法.裝置證實試驗協議和指南
  15. Glycol was the fit solvent. one set of extractive experiment equipment with continuously feed was designed and established to validate the extractive distillation and extractive distillation with salt. good results of the two technology processes and the extractive solvent recycling experiment were gained respectively

    本文還設計安裝了一套實驗室連續進料萃取裝置進行工藝的驗證實驗，對萃取精餾和加鹽萃取精餾工藝流程分別進行了驗證，並對萃取劑的回收利用進行了實驗，取得了良好的效果。
  16. This sensor has higher sensitivity and excellent stability, in the detection of gas oxygen and dissolved oxygen, the response time were 5. 57s and 14. 625s

    實驗結果證明，測定膽固醇用的熒光式光纖生物傳感裝置具有較高的靈敏性和優良的穩定性，其測定氣體氧和溶解氧的響應時間分別為5 . 57s和14 . 125s 。
  17. Electrical installations of buildings - part 6 - 61 : verification ; initial verification

    建築物的電氣裝置.第6 - 61部分:驗證.初始驗證
  18. Due to the uncertainty of factors such as far - range, atmospheric attenuation and operated target, a steady and reliable method and setting to characterize laser altimeter ' s performance is an important and difficult technology

    由於測程遠、大氣衰減、被測目標物等不確定性因素，建立一種穩定可靠的激光高度計性能指標驗證裝置和方法，是一項重要的、必須解決的技術難點。
  19. Abstract : during the heating of scrap with carbon or hydrocarbon contented substances in some process, it will bring problems like explosion of carbon monoxide, fume and smell from oil volatilization, etc. ， if incomplete combustion occurs. through laboratory experiments, the time related variation of gas contents and post combustion ratio of fume during the heating of oil - bearing scrap are studied. the results show that the restrictive chain of reaction procedure is the thermolysis of oil ; that temperature and ( co ) / ( co2 ) ratio influence transformation ratio and post - combustion ratio under lower temperature ; that 900 is the temperature above which the complete reaction can be ensured at all ( co ) / ( co2 ) ratios

    文摘:在某些廢鋼熔煉過程中，當爐料中含碳及碳氫物質且燃燒不充分時，會帶來煙氣中一氧化碳的燃爆、油污揮發時造成的煙霧、臭味等問題.通過實驗室裝置研究含油廢鋼在加熱過程中煙氣成分隨時間的改變以及二次燃燒率的變化，試驗結果表明，反應過程的限制性環節是油分的熱分解；在較低的溫度下（ co ） / （ co2 ）比例影響轉化率和二次燃燒率；而在任意比例下保證充分反應的溫度為900以上
  20. Research and spplication of ug based on knowledge engineering

    一種指紋驗證裝置的研究與應用
分享友人
分享到 Line

分享到臉書