高壓層積材 的英文怎麼說

中文拼音 [gāoyācéngjīcái]
高壓層積材 英文
high-pressure laminate
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 壓 : 壓構詞成分。
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 積 : Ⅰ動詞（積累） amass; store up; accumulate Ⅱ形容詞（長時間積累下來的） long standing; long pending...
  • 材 : 名詞1 （木料） timber 2 （泛指可以直接製成成品的東西; 材料） material 3 （供寫作或參考的資料） ma...
  • 高壓 : 1 （殘酷迫害; 極度壓制） high handed 2 [氣象學] （高氣壓） high pressure3 （高電壓） high tension...
  1. In the light of its special property being not easy to gain strength, through mechanics researches on different methods to stabilize this kind of low _ liquid _ limit silty soil as subbase material, evaluated both technically and economically, we have got a cement lime stabilization plan to meet the index requirements for non _ side _ limit strength of compression of subbase of class2 road stipulated in the specification ; by means of improving the workmanship, thickening the loose layer of soil, adding soil on covering weave fabric before compaction, such problems can be solved as very poor compaction, loose surface during compaction, roughness and unevenness, coats of layer and shear damages

    本文針對黃河沖積而成的低液限粉土其粘粒含量極低、土的不均勻系數很小、膠體活性差的工程特性，通過採用不同方法穩定該類土作底基層材料的力學性能研究，從技術、經濟角度綜合評價，得到滿足規范抗壓強度指標要求的水泥石灰穩定方案。通過對原材料、試驗配合比設計、施工、等方面進行優化，從而顯著減輕了基層的早期及長期縮裂程度，從而提高了路面的耐久性。
  2. But the low pressure pipeline technique is not widely used in north china, the main reasons are the irrigation are is more larger the north china, and the low pressure pipeline irrigation system is very large, the corresponding pipe, pipefitting is very lack, all these make the use of low pressure irrigation in south china very little, and now there is still not the standard of low pressure pipeline irrigation for south china

    由於南方地區灌區面積大，管灌系統規模大，與其相配套的大口徑管材、管件規格少，配套建築物較多，灌區類型多樣，壓力變化范圍大，技術難度高，基層工程技術人員了解和掌握不充分，至今尚無適合南方地區低壓管道輸水灌溉工程設計的規范，這些是影響南方低壓管道輸水灌溉技術發展的因素。
  3. In this paper, finite element software ansys is used to simulate the thermal conductivity and pressureless infiltration technique is used to produce aluminum infiltrated silicon carbide composite with high volume fraction of sic. the influence of interfacial thickness and temperature on thermal conductivity and cte have been investigated and analysed

    本文採用有限元軟體ansys對鋁滲碳化硅復合材料的有效熱導率進行了數值模擬，用無壓浸滲法制備了高體積分數的鋁滲碳化硅復合材料，研究了界面層厚度和溫度等對鋁滲碳化硅復合材料的熱導率和熱膨脹系數的影響，並進行了分析。
  4. After mechanical and process properties testing, the results indicated that : ( 1 ) the film resin can make the properties good in climbing drum peer strength of sandwich constructions composite, the little effects of the film resin on other mechanical properties have been given ; ( 2 ) the sandwich composite has the better mechanical properties at central symmetry layer than asymmetric layer ; ( 3 ) through the study of the different pressure of the sandwich composite, the result is obtained that the edgewise properties increases, the flexural properties decreases with the pressure increase from 0. 2mpa to 0. 5mpa ; ( 4 ) at the sameness extend layer, the mechanical properties of the laminate is bigger than that of the honeycomb sandwich panel ; ( 5 ) through the studies on honeycomb sandwich plate delamination under three - point bending tests. it is found that the flexural strength decreases with the area of delamination increases

    研究表明： （ 1 ）膠膜能明顯的提高蜂窩夾層結構的剝離性能，對其它性能的影響不大； （ 2 ）對稱鋪層較非對稱鋪層的力學性能高； （ 3 ）固化壓力由0 . 3mpa提高至0 . 5mpa時，蜂窩夾層結構的側壓強度提高，而彎曲強度和剪切剛度分別降低； （ 4 ）蜂窩夾層結構中的面板較同樣材料鋪層的復合材料疊層板的力學性能低； （ 5 ）蜂窩夾層結構的界面上有缺陷時，彎曲強度下降，且隨著缺陷面積增大，彎曲強度下降幅度增大。
分享友人
分享到 Line

分享到臉書