高容量電纜 的英文怎麼說

中文拼音 [gāoróngliángdiàn]
高容量電纜 英文
high capacitance cable
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 纜 : Ⅰ名1. （拴船用的鐵索或多股粗繩） cable; hawser; mooring rope 2. （擰成多股的似纜物） thick rope; cable Ⅱ動詞（用繩索拴船） cable
  • 高容量 : high power capacity
  • 電纜 : cable; electric cable
  1. With aggrandizement of capacity and ascent of automating the degree of modern power station machine unit, the quantity of the power station cable also increasing quickly

    隨著現代電廠機組容量的增大和自動化程度的提高，電廠電纜的數量也大幅度增加。
  2. The problem about neutral - point - grounding mode is an all - around technical problem which associated with not only power system reliability ， insulation coordination ， electromagnetic interference ， but assault safety 。 in china ， the neutral grounding modes of the 10kv net involved of none grounding, grounding by arc suppressing coils, resistance grounding or reactance grounding in the past 。 with the development of civic power network ， low resistance grounding mode was used to restrain the over voltage, particularly in guangzhou, shanghai ， beijing ， and zhuhai etc. it was reported that the over - voltage level of low resistance grounding mode is lower than that of arc suppressing coil mode, but the operation carried out the other way 。 at substations in guangzhou and shanghai it was found that the low resistance grounding mode is successful 。 but in some areas ， such as zhuhai ， substations grounding with low resistance revealed some problems ， including power supply reliability rapidly dropping ， transmitting line often tripping ； and person safety being threatened 。 so interiorly the grounding mode selection of the 10kv network was disputed, which mainly focused on the fault form of 10kv net grounding, the apply area of suppressing arcing coil grounding mode, power supply reliability level of the two modes, person safety, communication interfere and the workload of maintenance

    爭議點主要是在10kv電網接地故障的形式、消弧線圈接地的應用范圍、兩種運行方式供電可靠性的高低、人身安全、通訊干擾和運行維護工作量等諸多方面。 11 17本論文就是針對以電纜為主的城區10kv電網中性點接地方式的選擇問題進行研究。論文首先對10kv電網的中性點運行各種方式進行分析，比較各方式的特點，然後以重慶儲奇門變電站10kv電網的實際參數來建立數值計算模型，在考慮了電網接地電容電流變化、中性點電阻取值大小、接地點接地電阻值變化等多種影響因素的情況下，對中性點經消弧線圈接地和經小電阻接地方式下電網的過電壓水平和接地點短路電流大小進行了數值計算，其計算結果與電科院所作現場試驗進行了比較。
  3. A major step in bringing in a large capacity submarine cable welcomed

    政府歡迎落實鋪設高容量海底電纜邁進一步
  4. The project included the train station, tunnel, platform, and parking lot. the main works are briefly described as follows : e power

    電氣： 22 . 8kv ，干線全為低壓無毒電纜，設備容量48 . 5mva高低壓開關箱共310隻
  5. The thesis is composed of 9 parts : the background, significance, main topics and innovations in the thesis are introduced in chapter 1 ; in chapter 2, the main function and performance of interface circuits are described from the view of system by using the example of gigabit ethernet ' s transceiver ; the transmission media ' s frequency characteristics and model are analyzed for the high - speed data transmission system in chapter 3 ; the line driver is presented in chapter 4 ; the equalization principles for high - speed data transmission system are introduced in chapter 5 ; a novel adaptive equalizer for 1000base - cx transceiver is presented in chapter 6 ; in chapter 7, a fixed equalizer for 2. 5gbps transceiver is described ; in chapter 8, layout design and measured results are discussed ; at last, the conclusions are drawn in chapter 9. during period of finishing the thesis, i read lots of literatures about the interface circuits in high - speed data transmission system, studied their principles and design techniques, and designed : 1 、 the line driver for 2. 5gbps baseband copper cable transceiver ; 2 、 the fixed equalizer for 2. 5gbps baseband copper cable transceiver ; 3 、 the fixed equalizer for 1. 5gbps sata ( serial at attachment ) transceiver ; 4 、 an adaptive equalizer for 1000base - cx transceiver

    論文由9部分組成：在第一章引言中介紹了論文的背景、意義、國內外研究現狀，以及論文的主要內容和創新；第二章以千兆位以太網為例，從系統的角度介紹了高速數據傳輸系統介面電路的主要功能和性能指標；第三章分析了高速數據傳輸系統的傳輸介質的頻率特性和模型；第四章描述了線驅動器的設計原理及其電路實現；第五章描述了高速數據傳輸系統的均衡原理；第六章描述了適用於1 . 25gbps基帶銅纜收發器系統的自適應均衡器的設計原理和電路實現；第七章描述了適用於2 . 5gbps基帶銅纜收發器系統和1 . 5gbps串列硬盤介面（ sata ）收發器系統的固定均衡器的設計原理及其電路實現；在第八章中分析了電路的版圖設計及晶元測試結果；最後，第九章總結了全文。在完成論文期間，查閱了大量的有關高速數據傳輸系統介面電路方面的文獻，較系統地學習了線驅動器、傳輸線和均衡器等方面的理論知識和電路設計原理，設計了用於： （ 1 ） 2 . 5gbps基帶銅纜收發器系統的線驅動器； （ 2 ） 2 . 5gbps基帶銅纜收發器系統的固定均衡器； （ 3 ） 1 . 5gbpssata系統的固定均衡器； （ 4 ） 1 . 25gbps基帶銅纜收發器系統的自適應均衡器。
分享友人
分享到 Line

分享到臉書