高寬 的英文怎麼說

中文拼音 [gāokuān]
高寬 英文
takahiro
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  1. Real beds with internals and with aspect ratios not much larger than unity should satisfy these requirements rather well.

    具有內部構件的真實床層，其高寬比1不太大於1時，應該可以相當好地滿足這些要求。
  2. Gets the maximum texture aspect ratio supported by the hardware

    獲取硬體支持的最大紋理高寬比。
  3. This method is often used to change the aspect ratio of a video stream

    此方法通常用於更改視頻流的高寬比。
  4. According to the american miniature book society, a book should be no more than 7. 35 centimetres tall, wide or thick

    據美國迷你書協會稱，迷你書的高、寬和厚都不應超過7 . 35厘米。
  5. From the aspect of the coupling action of geological and engineering conditions, this paper analyzes their influences on high slope stability. the result shows that constructional surface, lithology, slope angle and height are the most influential factors. provided that a slope angle in a stepped slope is constant, the slope stability is very sensitive to the height / width ratios of steps, and the best design for the slope is to make the height of each step no more than one - third of the total height and the height / width ratio between 1 : 0. 2 - 0. 3

    從地質與工程耦合作用出發，分析了地質因素和工程條件對高邊坡穩定性的影響，指出結構面、巖性以及坡角和坡高是邊坡穩定性的重要影響因素，在邊坡角一定的前提下臺階狀邊坡的臺階高寬比對邊坡穩定性影響山十分明顯，一般以每級臺階的高度不超過總坡高的1 / 3 ，高寬比在1 ： 0 . 2 0 . 3之間為最佳設計。
  6. 3. the parameters of steel frame with infill which affect the lateral, resistant ability, such as panel ratio, frame - to - panel connectors, frame - to - panel interface friction, gap between panel and frame and mortar joint bond and friction were discussed. it is emphasized that the reduced location, shape and dimension is very important for the function of dog - bone reduced beam flange and must be paid more attention

    對填充墻高寬比、填充墻與鋼框架抗剪連接件、內填充墻與框架梁空隙、填充墻開洞和鋼框架與內填充墻界面摩擦等影響填充墻鋼框架抗側力性能的因素進行了討論，並指出設計中考慮這些影響因素對于達到預期的設計目的是至關重要的，必須予以重視。
  7. We obtained a high quality zno thin film with the pl fwhm of 94 mev at 900. the free exciton binding energy deduced from the temperature - dependent pl spectra is about 59 mev at 900, suggesting that the film quality can be improved by annealing process

    當退火溫度為900時獲得了高質量的氧化鋅薄膜，光致發光譜的半高寬為94mev ，通過變溫實驗得到激子束縛能為59mev ，表明退火過程提高了薄膜的質量。
  8. Now the most common standard to characterize the mechanical property of a surface of metallic material is the half width of the x - ray, and micro hardness

    摘要目前用來表徵金屬材料表面力學特徵最常見的指標是x射線衍射譜線的半高寬和顯微硬度，人們普遍認為，材料的半高寬值越大，其硬度越高。
  9. It is common considered that the more the half width is high, the more its hardness is based on the fact that the half high width of the shot peening affected layer in hard state decreases many scholars engaged in investigation of shot peening technology proposed that the shot peening affected layer is work softened

    許多從事噴丸研究的學者從硬狀態材料噴丸影響層半高寬減小的實驗事實提出噴丸影響層發生了「加工軟化」的觀點，實驗選用超高強度鋼為實驗材料，對其不同硬度的實驗結果發現，噴丸使硬狀態表面的半高寬大幅度減小，但使它們的表面屈服強度得到了提高。
  10. Rake reception is used for improving the wide band receivers

    提高寬帶接收機性能，我們選擇，犁耙式接收。
  11. Through the simulation of the forming process, we can get the deformations, stress, strain, plastic flowing in sheets and the interface state under impact load and rolling load, the deformation of the sawtooth form and comparing to the initial state, the results above are expressed in computer animated way. and the effect of geometrical ( mainly different form, including 90 degree, isoceles triangle ， 75 degree, and 1. 5 high and wide ), material and technical parameters on the bond strength are analyzed, also including the comparison of different sawtooth form. the optimum parameters are got

    對雙金屬復合板成型過程進行模擬，從而得到在沖擊載荷和軋輥壓力作用下基板和覆板的應力、應變分佈和塑性流動變形規律，復合后的齒形的變形情況與初始齒形形成對比，以動畫的方式模擬成型過程，並分析了不同幾何參數（主要是不同的齒型，其中包括直角齒型、等腰齒型、 75度齒型、 1 . 5高寬齒型） 、材料參數、工藝參數對復合強度的影響，以及不同齒型的變形對比以及齒型對復合情況的影響，提出最優齒型、最優工藝參數，有效地指導了實驗。
  12. The broadband signal is generated by high speed d / a, and the logical control of the system such as the interface timing control of ide or sdram is implemented by fpgas

    採用高速d / a實現輸出信號的高寬帶，採用多片fpga完成整個系統的時序邏輯控制，比如ide介面時序的實現， sdram的操作等。
  13. Description of moongate : blue oval sparkly vortex as tall as a player and about as wide

    月門的描述：能容納一個玩家高寬的橢圓形，裏面是有火花的藍色漩渦。
  14. The geometric nonlinear effect should be taken into account in the calculating of steel frames, for its big proportion of height to breadth and small section

    由於鋼制框架的高寬比較大，柱截面較小，因此，這類結構應考慮其幾何非線性的p -效應計算。
  15. The characteristics of longitudinal and lateral frame columns are different from general frame columns, due to the high depth - to - width ratio of cross - sections and withstanding large vertical loads. the axial compressive ratio is a very important factor in columns design

    縱、橫向框架柱具有與一般框架柱不同的特點，如柱截面高寬比較大，且承受很大的豎向荷載，其軸壓比設計問題是柱設計的一個非常重要的因素。
  16. After measuring dark current, photocurrent and response to x pulse of gaas detector before and after 1. 7 mev electronic radiation, the response tune, fall time of trailing edge, full width of half maximum ( fwhm ), sensitivity, carrier life, mobility are researched and contrasted. the result shows that the response speed of detector, time resolution ratio and nonlinear of back edge of output signal have been improved greatly after electronic radiation. though sensitivity of the detector reduces, its measuring range can be widened

    為了使探測器的性能得到進一步的提高，我們對其進行了電子輻照改性，並測量了本徵砷化鎵探測器和經過1 . 7mev電子輻照的探測器的暗電流、光電流及對x射線的脈沖響應，並對其響應時間，后沿下降時間，半高寬（ fwhm ） ，載流子壽命，靈敏度進行對比，研究，結果顯示經電子輻照后的探測器的性能得到了改善，使響應速度，分辯率進一步提高，並消除了探測器輸出信號后沿的非線性，雖靈敏度有所降低，反而使其測量范圍得以拓寬。
  17. Another phase, the high temperature phase, is hexagonal with space group p - 62m, which is stable from 300 to 800. the lattice parameter and the full width of half maximum ( fwhm ) of xrd peaks of u3o8 were also investigated at different temperature, and it were found that they change with the temperature under rules

    在兩種相結構各自穩定的溫度范圍內， u _ 3o _ 8的點陣參數以及衍射峰半高寬（ fwhm ）出現了有規律的變化，這種變化表明u _ 3o _ 8的晶體結構依賴于環境溫度的變化。
  18. The effect of deposited condition, include substrate temperatures, different substrates and annealing on the structural properties of zno films has been studied in considerable detail. it is found that the optimal conditions to deposit zno are below : the substrate temperature of 450c, the substrate of sapphire. the sample on this condition is 0. 3491

    通過分析襯底溫度、不同襯底和退火對樣品結構的影響，得到了樣品的最佳制備條件：襯底溫度450 、藍寶石襯底，此條件下制備的樣品具有高度（ 002 ）取向性， （ 002 ）衍射峰半高寬僅僅0 . 3491 ，原子力顯微鏡（ afm ）分析表明zno薄膜具有密集堆積的均勻柱狀晶粒。
  19. Both static and cyclic load tests are conducted for a same size specimen. the purpose is to find the effect on shear strength from different height - width ratio, and to get the shear resistance limit by static and cyclic loading. according to test results, the improvement suggestions for the wall details and design are presented in this paper

    同樣尺寸的二個試件分別在頂端進行水平單調加載和水平方向低周往復加載抗剪試驗一次，試驗目的是測試墻體的不同高寬比對抗剪強度的影響以及墻體在單調加載及低周反復加載兩種情況下的抗剪強度pu並做出比較，從而對墻體構造及設計提出改進建議。
  20. According to the code for aseismatic design of building structure ( gbj11 - 89 ), the seismic base - shear method has always been used to calculate the seismic response of building structures. in those structures, their weights and rigidities equally distribute along their heights which do not exceed 40m, and their deformations are mostly the shearing type ( when the structures " ratio of height and width are smaller than 4 )

    我國《建築抗震設計規范》 （ gbj11 ? 89 ）中規定，對于重量和剛度沿高度分佈比較均勻、高度不超過40m ，並以剪切變形為主（房屋高寬比小於4時）的結構，可採用近似計演算法，即底部剪力法來計算其地震響應。
分享友人
分享到 Line

分享到臉書