高度表滯后 的英文怎麼說

中文拼音 [gāodùbiǎozhìhòu]
高度表滯后 英文
altimeter fatigue
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 滯 : Ⅰ動詞（使停滯; 使不流通） stagnate; block up Ⅱ形容詞（停滯; 不流通） sluggish; slow-moving; stagnant
  • 高度 : altitudeheightelevation
  1. Business valuation based on modern economy is one of the most difficult and comprehensive professional work in asset appraisal, but also stands for the trend of the appraisal. as china implemented planned economy all the long in the past years, the concept of business value was proposed later than other advanced countries. the study on the theory and method of business valuation we made is relatively backward. all these lead to that we merely use cost method in practice. with the improvement of market economy, the validity of cost method is challenged. hunting for appraisal methods suitable for china circumstance has become more and more urgent. this thesis presents its own opinion on the adjustment of the basic frame of theory of business valuation. for the first time, it puts systems theory into the study of the theory base, and believes that the enterprise as a compound entity has higher efficiency than the sum of its constituent, and then proposes new appraisal assumption. aiming at the obscure understan ding, it analyses a group of conception related to business valuation. after giving a whole analysis and study, this thesis indicates the income approach which emphasizes earning - capacity of a enterprise should become the correct choice of china, and makes a further study on the origin - features and feasibility of this method

    植根于現代經濟的企業價值評估是資產評估中綜合性最強，技術難度最高的業務之一，也是評估業未來的發展方向，由於我國過去長期實行計劃經濟體制，企業價值概念的提出和運用時間較晚，缺少現代經營理念的積累，企業價值評估的理論與方法的研究比較滯后。本文試圖以理性分析和案例分析相結合的方法，系統研究和分析企業價值評估的基礎理論及其現實條件下，適應我國經濟發展的評估方法，以期為構建有中國特色的企業價值評估理論和方法體系做一些有益的探索。文章以企業價值評估的基本概念為起點，在對眾多關于企業性質的學說和理論觀點進行概括抽象的基礎上，指出了整體性、持續經營和盈利性是企業的重要特徵，依據企業的整體性運用系統方法闡明了企業的價值大於組成企業的單項資產價值之和，據此提出了反映企業價值評估特點的有機組合增殖假設；依據盈利性的特點，強調了企業價值評估的核心應為企業的獲利能力，而不是組建企業的成本；對企業價值、企業價值評估含義、特點的論述以及對相關概念的辨析表明了作者的個人觀點和文章的基本定位，而從評估目的入手劃分的以產權變動為目的的企業價值評估和以財務決策為目的的企業價值評估與企業價值評估的假設、評估核心共同決定了評估方法的選用。
  2. Select the best project, improve efficiency and realize creating design. the core of three - dimensional visualization is generating a structural model and browsing ito it is very difficult to generate a structural model because there is no standardization of design of hydraulic engineering, so the research of three - dimensional design of hydraulic engineering gets along slowly, and the development of relative software lags,

    近年來，三維可視化技術在工程結構設計中日益受到重視，其直觀的表現形式，為工程結構設計人員形成設計概念、選擇最佳方案、提高工作效率、實現創造性設計提供了方便。三維可視化技術的核心是結構建模和瀏覽。由於水工結構設計的非規范性，結構建模非常困難，因此水工結構的三維設計研究進度緩慢，軟體開發滯后。
  3. It is indicated that the relaxation of elastic energy stored during the forward martensitic transformation is responsible for the expansion of transformation hysteresis, which is in good agreement with experimental results associated with the hysteresis enlargement by deformation of niti, niti - based and cualni shape memory alloys

    結果表明，塑性變形產生的位錯以及變形的第二相顆粒對逆馬氏體相變溫度的提高具有一定作用，但塑性變形導致應變能釋放才是形變提高形狀記憶合金相變滯后的主導因素。
  4. If there are high temperature gradient between cool liner and hot liner, compressive plastic strain appear at that transient time, which lead to gas film wall bearing high tensile stress at high temperature. high tensile stress is one of main reasons which destroy combustor

    分析表明，起動過程中由於熱傳導滯后引發的溫度梯度可以導致火焰筒氣膜唇邊在起動瞬間發生較大的壓縮塑性應變，進而使得該區域在工作時承受較高水平的拉伸應力，高的拉應力會導致火焰筒萌生裂紋。
  5. In this part, the new situation party school faces, such as the changes of the construction environment, the new requirements, and changes of the targets educated, is analyzed ; the new problems are noted. the problems can be demonstrated in the six aspects : the ideological understanding is not enough ; the reform in general is not complete ; the management system is not sound ; students " motive of joining the party is deviant ; the devotion of the teachers is not enough ; the theoretical study is relatively backward

    該部分首先分析了新世紀新階段高校黨校建設所面臨的新情況，即高校黨校建設的環境出現新的變化、高校黨校工作面臨新的要求、高校黨校的教育對象出現新的變化;其次指出了當前高校黨校建設面臨的新問題，主要表現在六個方面，即思想認識不夠到位、總體改革力度不大、管理體制不夠健全、學生入黨動機出現偏差、教師精力投入不夠、理論研究相對滯后。
  6. As the temperature of pyrolysis and the soak time increasing, the carbon materials become more stacked, the specific surface area reduces, both reversible capacity and irreversible capacity decrease, the initial coulumbic efficiency increases, and the hysteresis in the voltage profile between charge and discharge is cut down

    隨著熱處理溫度的升高和恆溫時間的延長，所得炭材料的有序化程度增加，比表面積減小，可逆嵌鋰容量與不可逆容量均減小，首次充放電效率增大，電壓滯后現象得到抑制。
  7. The results of simulations show that the effects of these three intelligent controllers are all far better than that of pid control, and the dynamic and steady performances of the later two controllers are better than the common fuzzy control. in the end of the paper, a type of intelligent temperature - humidity controller is developed, the hardware structure and software algorit hm of this controller are introduced

    計算機模擬實驗結果表明：這三種智能控制器在純滯后系統中的控制效果均優于傳統的pid控制，其中規則自調整模糊控制器、基於單個神經元的自適應模糊控制器的動、靜態性能和魯棒性均比普通模糊控制器有較大幅度的提高。
  8. The simple control theory used in this field for years ca n ' t meet the new requirement of the system any more due to the higher control target, and a more advanced theory need to be found to support the system with higher complexity, hi contrast with the slow progress of the control theory, the automatic control tool experienced the evolution of pneumatic meter control, centralize data control system and distributed control system has made a great achievement, that is the new net integrated and distributed control system - field bus control system

    控制要求的不斷提高，控製程度的愈加復雜使長久以來在生產中運用的單一的經典控制理論和技術已經不能滿足系統的需求，現代化工業過程式控制制系統迫切地需要高級理論的支撐。與理論發展相對滯后形成對比的是，自動化技術工具的蓬勃發展，在經歷氣動儀表控制、集中式數字控制系統到集散式控制系統后形成了新一代的網路集成式全分佈的現場總線控制系統。
  9. The deputy minister pointed out in her lecture that the international competitiveness of china ' s industries was weak as a whole, as shown on the low technical innovation ability, the backward management philosophy and marketing approaches, shortage of some raw material, excessively high reliance on import and insufficient international cooperation both in width and depth by small and medium enterprises

    馬秀紅副部長在演講中指出，我國產業的國際競爭力水平總體不強，主要表現在產業技術自主創新能力弱，企業管理理念、營銷方式滯后，部分資源性商品自給不足，對進口依存度過高和中小企業開展國際合作寬度和深度不夠等方面。
  10. It analyzes the opportunities in the aspects of macro - economic environment, national industry policy, substitutes and entry into wto. it also analyzes the threats in the aspects of relatively hysteretic development of backward related industry, ineffective barrier of entry & exit in some extent, increasingly strict requirement of environment protection. then, it analyzes the strengths in the aspects of human resource, relative international competence of some representative companies, faster development of technology industrialization, improved integrated recovery and relative advantages of capital and cost

    從宏觀經濟環境、國家產業政策、替代品以及加入wto等四個方面進行了機會分析；從後向關聯產業的發展嚴重滯后、行業的進入與退出壁壘一定程度失效、環境保護要求的日益提高等幾個方面分析了我國鉛鋅冶煉行業發展所面臨的威脅；從人力資源、代表性企業具有一定的國際競爭能力、技術產業化進程加快、綜合回收水平提高、資源成本的比較優勢等方面分析了行業所具有的優勢。
  11. Based on the characteristic of the coupling objects it optimizes the decouple parameters, and the simulation result proves that the decoupling optimized algorithm compensates the hydraulic system lag, achieves the best collection efficiency, and enhances the stability of walking

    並根據耦合對象的特性，進行去耦優化，模擬結果表明該去搞優化演算法能補償液壓系統滯后特性，獨立進行集擴頭高度最優調節，達到最佳集礦效率，提高行走穩定性。
分享友人
分享到 Line

分享到臉書