高強鋼 的英文怎麼說

中文拼音 [gāoqiánggāng]
高強鋼 英文
dead-hard steel
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 強 : 強形容詞（強硬不屈;固執） stubborn; unyielding
  • 鋼 : 鋼名詞（鐵和碳的合金） steel
  • 高強 : excel in; be master of
  1. Abstract : experimental researches on normal section ultimate fle xural strength of prestressed reverse - rib - slab with excessive steel bar were m ade, and according to chinese norm ( gbj10 - 89 ) and american norm ( aci ) in which s train harmony analysis method was adopted, its ultimate strength was calculated, these make us further realizse the ultimate flexural strength of prestressed r everse - rib - slab with excessive steel bar

    文摘:通過疊合結構中預應力超筋倒肋薄板正截面極限承載力的試驗研究，分別採用規范gbj10 - 89中的受彎構件、偏心受壓構件的計算公式及美國aci規范中的應變協調分析方法計算了極限承載力，從而更清楚地認識了配有高強鋼絲的超筋倒肋板的極限承載力計算問題。
  2. Based on the model experiment of 9 normal - strength concrete specimens and 12 high - strength concrete specimens in this case, the hysteretic property and seismic performance of normal - strength and high - strength concrete frame column are analyzed, and factors that affect the seismic performance of combined torsion member are also studied. in this paper, seismic performances of reinforced concrete members are discussed

    在9根普通混凝土、 12根高強鋼筋混凝土框架柱在雙向壓彎剪反復扭矩復合作用的模型試驗研究的基礎上，對普通和高強混凝土框架柱的抗震特性和滯回特性進行了分析，研究了各影響因素對鋼筋混凝土復合受扭構件抗震性能的影響。
  3. Initially all structures were prestressed by high-strength bars.

    起初，每個橋梁都是通過高強鋼筋施加預應力的。
  4. Experimental study on the bending behavior of reinforced concrete slabs strengthened by using high - strength steel - wire mesh and polymer morter

    高強鋼絞線網聚合物砂漿加固鋼筋混凝土板抗彎試驗研究
  5. Acoustic-emission techniques have been used to determine the rate of cracking of highstrength steel due to hydrogen embrittlement.

    聲發射技術已被用來確定高強鋼因氫脆而開裂的速率。
  6. Pk prestressed composite slab is a new composite floor structure by improving the traditional prestressed composite slab, its precast slab is a prestressed ribbed panel of which prestressed steel is a spiral ribbed high - strength wire, which make the precast component a higher stiffness and buckling capacity

    本文研究的pk預應力疊合樓板是通過不斷改進傳統預應力疊合板后研製的一種新型疊合樓板結構，其預制構件為帶肋薄板，預應力筋採用螺旋肋消除應力高強鋼絲。
  7. Lime - titanic type electrode used for welding low - alloy high strength steel of 50kg grade 490mpa

    鈦鈣型藥皮焊條，用於焊接50公斤490mpa低合金高強鋼。
  8. Flexural toughness of steel fiber reinforced high - strength concrete

    高強鋼纖維混凝土彎曲韌性試驗研究
  9. A method of calculating the shear strength of steel reinforced high - strength concrete short columns

    高強鋼骨混凝土框架柱的抗剪強度計算
  10. Technical conditions for hot - extruding pe protection high strength wire cable of cable - stayed bridge

    斜拉橋熱擠聚乙烯高強鋼絲拉索技術條件
  11. With the appearance of high strength concrete high tensile steel wire and cable, the cable - stayed bridge is more and more widely used and popular. it unites three diversely bearing structure style, compression tower tension cable and bending press beam, into one bridge style

    斜拉橋是隨著高強度混凝土材料、高強鋼絲和拉索的出現才得到廣泛推廣應用的橋型，它把主塔受壓、拉索受拉及主梁受壓彎的三種不同受力的構件有機地組合在一個統一體中。
  12. The opening stress and the life of crack growth is calculated and compared with the test results and the experience formula. the feasibility of the newman theory of opening stress used in the high strength steel is validated. then through the slice synthesis method, the three dimension surface crack of the weld joint of cone - cylinder is decomposed into many plane through cracks

    本文將基於裂紋閉合現象建立的帶狀屈服模型，用在平面貫穿裂紋中，計算此時的裂紋張開應力和疲勞裂紋擴展壽命，與試驗結果和經驗公式比較，驗證newman裂紋張開應力理論在高強鋼中的可行性；然後，用切片合成法，把潛艇結構凸錐柱結合殼焊縫處的三維表面裂紋分解成平面貫穿裂紋，用帶狀屈服模型的理論來分析平面貫穿裂紋，得到裂紋沿深度方向的擴展速率，進而得到潛艇結構的疲勞壽命。
  13. Study on the corrosion test of high strength steel bar in atmosphere

    高強鋼筋在大氣中的腐蝕試驗研究
  14. With the development of modern engineering technology, high - strength rebar and concrete are being used universally, the cross section size of reinforced member is more and more small, and the slenderness ratio is more and more great. this trend extrude the carrying capacity and stability of reinforced concrete member obviously

    隨著技術的發展，高強鋼筋和高強混凝土在建築工程中的應用日益普遍，鋼筋混凝土構件的截面尺寸越來越小，長細比越來越大，這一發展趨勢使得鋼筋混凝土柱的承載力和穩定問題愈發地突出。
  15. Experimental study on welding of d6ac ultra - high strength steel with thin - wire tandem sequence submerged arc welding

    超高強鋼的細絲雙弧焊接工藝試驗研究
  16. Because of the former anchorage systems designed according to matching 1860mpa strength strands in the beginning of 90 ", they can not be suitable any more for the super strength strands with 2000mpa. therefore, some accidents occurred such as strands sliding and broken when tensioning. in addition, the advantages of the new materials as their high mechanics performance are not be used completely as the prestressing structures was designed as per the 1860mpa strands, which will result in the waste of materials, in view of the above - mentioned facts, by means of analyzing the development of anchorage systems home and abroad, in connection with the characteristics of the super strength strands ( 2000mpa ), this topic made a research on hvm15 anchorages by theoretical calculation and finite element analysis, and also on the manufacturing process and test

    隨著預應力技術的發展和冶金工業冶煉技術的不斷進步，預應力鋼絞線的強度不斷提高，由原來1470mpa提高到1860mpa ， 90年代末期已出現了2000mpa超高強鋼絞線，而原來的是在90年代初期按抗拉強度為1860mpa的鋼絞線標準設計的，因此，原有的錨具已不能適應現有超高強度2000mpa的鋼絞線強度要求，在工程中出現了斷絲滑移現象，同時，在使用和設計時仍按1860mpa鋼絞線的指標進行設計應用，沒能充分發揮材料的力學性能，造成材料浪費。
  17. Alloying element to high tensile steel weld metal mechanical property influence

    合金元素對高強鋼焊縫金屬機械性能的影響
  18. Sand - blasting nozzles, drawing nibs for high strength steel wire, lathe cutting tools, saw tips

    適合於噴沙嘴、適合高強鋼絞線的拔絲夾頭、車刀、鋸齒。
  19. Rehabilitation of reinforced concrete members with high - strength steel wire mesh and polymer mortar is a brand new technique of structural strengthening both in china and abroad

    摘要高強鋼紋線網聚合物砂漿加固技術是近幾年來在國內外發展起來的新型技術。
  20. Widely used low hydrogen type electrode suitable for welding low - alloy high strength steel of 50kg grade 490mpa, such as ships, bridges and pressure containers

    應用最廣的低氫型藥皮焊條，用於焊接50公斤級490mpa低合金高強鋼，如造船，橋梁及壓力容器結構，可全位置施焊。
分享友人
分享到 Line

分享到臉書