高氏體 的英文怎麼說

中文拼音 [gāoshìtǐ]
高氏體 英文
golgi complex
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 氏 : 氏名詞1 （姓） family name; surname 2 （放在已婚婦女的姓后 通常在父姓前再加夫姓 作為稱呼） née : ...
  • 體 : 體構詞成分。
  1. This gland is located on the distal end of spermatophore cyst, and shaped like a semicylinder which consists of many acini

    促雄性腺位於精莢囊末端，半圓柱狀，由許多腺泡組成，細胞內富含粗面內質網和高爾基氏體，推測其分泌蛋白質性質的激素。
  2. Development of high strength low - carbon bainite steel

    高強度低碳貝氏體鋼的試制
  3. The particles distributed hi the matrix of grey cast iron, but some contact each other. the composite layer extend gradually into the substrate. when volume fraction of wc is 36 wt % and 27 wt %, the matrix of the composite is high chromium cast iron, consist of white carbide bars and the austenite. wc particles distributed uniformly, retaining approximately quondam granular form in the composite layer which has an evident interface area with the substrate, with good bonding strength

    對不同碳化鎢體積分數的灰鐵和低鉻鑄鐵基復合材料的微觀組織結構分析表明：碳化鎢體積分數為52時，復合層內基體為灰口鑄鐵組織，顆粒直接分佈在灰鐵基體上，部分碳化鎢顆粒有相互接觸的現象，基材與復合層之間沒有明顯的過渡；碳化鎢體積分數為36 、 27時，復合層內基體為高鉻鑄鐵，由面塊狀的奧氏體和白條狀碳化物組成，碳化鎢顆粒表面固溶於基體組織中，粒形基本保持完整，分佈均勻，與基體構成冶金結合，基材與復合層之間存在一個明顯的平緩過渡區。
  4. The results show that the solidification microstructure of high speed steel fe - 2 % c - 4 % v - 4 % mo - 5 % cr - x % w ( wt ) contains of martensite, retained austenite structure, and mc, m6c, m2c carbides, and mc / m2c complex carbides by xrd, sem and metallographs. most of the mc carbides locate in the cell and other carbides distribute along the boundary of the cell

    結果表明：經金相組織觀察、 x射線衍射和掃描電鏡分析， fe - 2 c - 4 v - 4 mo - 5 cr - x w合金系高速鋼凝固組織包含馬氏體基體、殘余奧氏體及各種類型的碳化物如mc型碳化物、 m _ 2c型碳化物、 m _ 6c型碳化物和mc m _ 2c類型復雜碳化物，大部分mc型碳化物分佈於晶粒內部，其它類型碳化物則沿晶界呈網狀分佈。
  5. Spf chickens with 21 - day - old were infected subcutaneously with oil - emulsion vaccine of ibdv of germinal or cellcular and injected intramuscularly with different dosages bursin which gain through ultrafilter. lt is proved that bursin of chickens and ducks can both shorten the time of antibody induced against ibdv, raise the level of serum antibody. they make chickens obtaining strong immunocompetente in a short time. agp liters of the group of infecting 0. 4mlcbs + ibdv of germinal and 0. 8mlcbs + ibdv of cellcular or 0. 8mldbs + ibdv of germinal and cellcular are higher than immune control group about 2 liters averagely. the chickens were inoculated with ibdv live vaccine mixed with the different dosages of lyophilized bursin by the eye drop method. the results sugest that cbs or dbs of different dosages can both improve the antibody inducation to different age chickens against ibdv. they may also alleviate the immunological injury of activated virus to bursa of fabricius. and promote the repairation of the lesion. it can be found that bs can raise body weight gain and feed coversion ratio

    將超濾獲得的法氏囊活性肽分別以不同劑量肌肉注射21日齡spf雞，同時頸部皮下注射ibd胚毒或細胞毒滅活苗，結果表明：雞、鴨法氏囊活性肽都能夠縮短ibd油苗誘導產生抗體的時間，提高抗體水平，使雞可以在比較短的時間內獲得堅強的免疫。 0 . 4mlcbs胚毒組和0 . 8mlcbs細胞毒組或0 . 8mldbs胚毒和細胞毒組的agp抗體滴度平均比免疫對照組高2個滴度。將法氏囊活性肽與ibd活苗聯合免疫雞，結果表明：不同劑量的cbs和dbs都可以對不同日齡雞ibd抗體的產生有不同程度的促進作用；還可以減少弱毒對雞法氏囊組織的損傷，加快其修復。
  6. Abstract : the structure and the properties of the grinding ball made of the composite cast iron have been researched in this paper. the result indicates that added trace boron and a proper quantity copper to this kind of composite cast iron can increase its quench - hardening ability, and raise its hardness and impact toughness

    文摘:研究了一種復合鑄鐵磨球的組織和性能，結果表明，化學成分和淬火工藝對這種復合鑄鐵磨球的組織和性能有很大影響，微量的硼和適量的銅可以明顯地提高磨球的淬透性，經過余熱淬火得到貝氏體或馬氏體基體組織，從而提高磨球的硬度和沖擊韌性。
  7. The lath martensite nanometer structure can play the role of fine - particle strengthening and dislocation strengthening as well as coordinate the distribution of dislocation. it is hopeful that the strength and toughness of material with this structure can be increased at the same time

    板條馬氏體組織納米化結構，可起到納米晶粒的細晶強化與位錯強化的聯合作用，並可協調位錯分佈，有望使具有這種組織的材料強度和韌性同時得以提高。
  8. There is a chemical reserve zone in the stack. in this zone the fe is present as feo, and the gas component is close to the balance composition of fe0. 947o / fe. so there is a part of longitudinal section, in which : l ) gas keeps its component, as ascending. 2 ) the composition of the gas is close to the equilibrium composition of the fe0 947o + co - " 0. 947fe + co2 under the temperature of the thermal reserve zone of about 1200 + 100k

    根據冶煉理論，高爐在爐身一定高度上有一個「化學貯備區」 ，在該區，含鐵物料實際上都是浮氏體，並且煤氣成分接近fe _ （ 0 . 947 ） o fe平衡時的成分，這樣，高爐內存在高爐熱控制模型開發一個縱向區域，在該區內：二）煤氣上升時，成分不變。
  9. Tensile strain hardening behaviours of nitrogen strengthening high manganese austenitic cryogenic steel

    氮強化高錳奧氏體低溫鋼的拉伸應變硬化行為
  10. Three kinds of fracture facet of a high nitrogen bearing austenitic steel in low temperature brittle fracture

    高氮奧氏體鋼低溫脆斷中的三種斷裂刻面
  11. Probing into bational use of leakage protection device

    新型高強度準貝氏體鋼及其在煤礦的應用
  12. Microstructure refinement of high strength low carbon bainitic steel

    高強度低碳貝氏體鋼的工藝與組織細化
  13. Irreversible temper embrittlement of high strength and toughness gdl - 1 bainite steel

    1型高強韌貝氏體鋼的不可逆回火脆性
  14. The ultrasonic quenching of medium carbon alloy high strength steel 35crmnsi was conducted, using h66025t ultrasonic generator. the result showed the mertensite lath was fined obviously and the nucleation rate was improved. it proved the theory that the propagation of elastic wave in austenite can promote the nucleation of martensitic transformation

    採用h66025t超聲波發生儀，對中碳合金高強度鋼35crmnsi進行超聲波淬火，發現馬氏體板條明顯細化，提高了馬氏體相變形核率，證實了彈性波在奧氏體中傳播促進馬氏體相變形核理論。
  15. Rational cutting condition of high manganese steel

    塗層硬質合金刀具切削奧氏體高錳鋼的磨損破損研究
  16. Electronic structure calculation and alloying be havior of austenites in high - strength and high - toughness steel

    高強高韌鋼中奧氏體相電子結構的計算及其合金化行為
  17. Suitable for a wide range of low and high alloy steels, titanium alloys, austenitic stainless steels, heat resistant alloys, fibre glass reinforced plastics etc

    適合於低合金鋼、高合金鋼、鈦合金、奧氏體不銹鋼、耐熱合金、玻璃纖維強化塑料等。
  18. We apply the system to the ultra - fine grain steel welding, the simulated mean grain size in cghaz agreed well with the corresponding independent experimental data. in this paper, three factors influencing the grain growth, the steep temperature gradient in haz. the grain boundary liquid and the precipitates particle, were studied specially using mc technique

    研究表明溫度梯度造成的「熱釘扎」現象和晶界液化現象都對靠近熔合線附近的晶粒長大有明顯的阻礙作用，對最終的晶粒大小分佈有重要的影響：而800mpa超細晶粒鑰中的tin粒子山于溶解溫度高，抑制奧氏體晶粒長大的效果十分顯著。
  19. The calculated results show that the main reason why the g as carburizing process is accelerated is due to the obvious increase in the diff usion coefficient and transfer coefficient of carbon resulted from the addition of re

    稀土元素加速滲碳過程的主要原因是增加了碳在奧氏體中的擴散系數，同時提高了碳的界面傳遞系數。
  20. Results of the experiments showed that the wear mechanisms of the sintered steel included abrasive wear, adhesive wear and fatigue wear, and it was the abrasive wear most important. it was the sintered steel mixed by ni, mo that was the best on the wear resistance, because of the great lot of bainite ; the sintered steel quenched and low temperature tempered mixed by mo, w that was the best on the wear resistance, because of the rigidity of the steel was the highest

    實驗結果表明：本文中幾種燒結鋼的磨損機制均是由磨粒磨損、粘著磨損、和疲勞磨損共同作用的，且以磨粒磨損為主；在燒結態下，復合添加合金元素鎳、鉬的燒結鋼的耐磨性能最好，這是因為生成了大量的硬質相貝氏體；而淬火、低溫回火態下，則復合添加鉬、鎢的燒結鋼的耐磨性能最好，這是因為熱處理態下添加鉬、鎢的燒結鋼的硬度最高。
分享友人
分享到 Line

分享到臉書