高溫粘合劑 的英文怎麼說

中文拼音 [gāowēnniángějì]
高溫粘合劑 英文
high-temperature adhesives
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  • 高溫 : high temperature; elevated temperature; hyperthermia; megatemperature; inferno
  • 粘合劑 : adhesie cement
  1. In the dissertation high - temperature corundum honeycombed ceramic regenerative body was prepared by an extrusion process, a - al2o3 minute powder as main raw material, clay, cmc etc as plasticizers, tung oil etc as lubricator. the plastic performance was tested on a plastic measure apparatus

    以a - al _ 2o _ 3微粉料為主原料，採用粘土、羧甲基纖維素（ cmc ）等有機-無機復合增塑劑，加入桐油等作為潤滑劑，採用擠出成型法制備剛玉質高溫型蜂窩陶瓷蓄熱體。
  2. In this paper, a high performance sma system applied to steel bridge deck is put forth in allusion to the pavement project of the wuhan junshan yangtze river highway bridge. it comprises steel slab, zn coating layer, closing layer, adhesive, pre - mixed asphalt stone and dual layer sma from bottom to top. it is based on the fea results of the forces and deformation of the pavement layer by means of the algor feas, according to this bridge ' s traffic and the ambient temperature varying range of the pavement layer

    本文針對武漢軍山長江公路大橋鋼箱梁橋面鋪裝工程，從鋪裝層環境溫度變化范圍、交通量等使用條件出發，在用algorfeas有限元分析軟體分析鋪裝層受力變形基礎上，提出了（即鋼板+金屬鋅塗層+封閉層+粘接劑+預拌瀝青碎石+雙層sma ）的高性能鋼橋面sma鋪裝體系，並對這種sma的組成材料，包括改性瀝青、集料、礦粉、纖維進行了比較研究，設計了這種sma的配合比，對sma混合料的性能進行了對比試驗，對這種sma方案進行了疲勞性能研究，驗證了所選擇sma方案的可行性。
  3. The binding principle in pelletizing covers a comprehensive model of interfacial reaction among particles inside green pellets, the formation of binding film during hardening of green pellets by baking to obtain enough strength for a volumetric catalyzed reduction model for cold - bound pellets bearing composite binder and corresponding high temperature reduction system in rotary kiln

    提出了含復合粘結劑的生球強度界面作用力綜合模型，冷固球團礦強度的粘結膜機理，含復合粘結劑的冷固球團礦催化還原體積反應機制及全窯高溫快速還原熱工制度。
  4. The results show that the dynamic elastic modulus, loss modulus and complex viscosity of the nanocomposite are higher than those of pp, while the loss factor is lower, that the complex viscosity of the nanocomposites is more sensitive to temperature, and that the flow activation energy and the crystallization temperature increase respectively by 15 % and 10k as compared with pp, which may contribute to the enhanced interfacial interaction between pp and ommt resulting from the addition of tmpp

    結果表明：與純聚丙烯相比，納米復合材料具有較高的動態彈性模量、損耗模量和復合粘度，力學損耗因子則降低，納米復合材料的復合粘度對溫度的敏感性略高於聚丙烯；界面改性劑的加入增強了有機蒙脫土與聚丙烯的界面作用，與聚丙烯相比，納米復合材料的流動活化能提高約15 % ，結晶峰溫度提高10k左右。
  5. Using the dynamic mechanical analyzer ( dma ), pdms / pma ipn was investigated at temperature of 5 - 180 c. the initiator, the component ratio, the type of pdms and the filler effected the damping properties. the result showed that the damping ability varied with the parameter and there was an optimal value. the excellent damping material in the papers was ipn, where tan man was 0. 735, and the damping functional temperature ranged with tan 8 > 0. 3 was 46 c. the micro - morphology and structure of pdms / pma ipn were characterized by two kinds of sem

    高分子阻尼材料的有效阻尼功能區是在ipn材料的t _ g區間內，而研究常溫條件下的阻尼性能更具有重要應用價值，運用動態熱機械分析（ dma ）儀對ipn阻尼材料進行表徵，在5 180內對其損耗因子（ tan ）進行研究，發現引發劑和交聯劑的用量、聚硅氧烷的用量和分子量等參數對ipn阻尼性能的影響較大，存在一個合理配比值，當pma與粘度為3300pa ? s的pdms之比（質量比）為1 . 17 ： 1 、交聯劑用量為1時， tan最大值為0 . 735 ，大於0 . 3的溫域差達到46 。
  6. The grade composite, road performance and its mechanism are systemically studied. 1 ) the aggregate grade of ogfc is studied through the volume method base on the analysis of the aggregate grades. then the grade is verified and the relation between the grade and pore rate is studied statistically, the typical grades of ogfc are developed ; 2 ) the reasonable pore rate of ogfc is studied on the basis of the balance of mechanics and function performance ; 3 ) the mineral fiber is added to the ogfc mixes to increase asphalt content, thus the anti - water performance of ogfc mixes are improved ; 4 ) high viscous asphalt fit for the preparation of ogfc is prepared through composite modification by sbs and rubber powder ; 5 ) the mechanics mechanism of ogfc is studied in the paper, it shows : asphalt paste, as well as the coarse aggregate skeleton, is essential to the mechanics of ogfc

    在分析各國ogfc級配的基礎上，運用礦料體積法進行ogfc級配設計，用正交實驗對礦料級配進行了優化設計，運用數理統計方法分析礦料級配和孔隙率之間的關系，並回歸出礦料關鍵篩孔通過率與ogfc骨架空隙結構關系的數學方程，進而提出了ogfc的合理級配；通過對不同孔隙率典型級配混合料的性能研究，綜合力學和功能性能，得出了ogfc的合理孔隙率范圍：針對高速公路面層對ogfc力學性能方面的要求，本文從瀝青膠結材料、纖維穩定劑兩方面對ogfc的性能進行改善：通過sbs和橡膠粉復合改性的方法開發出了適合ogfc的高粘度改性瀝青，摻加聚合物纖維，提高ogfc的最佳瀝青用量，進而改善了混合料的高溫性能和抗水損害性能，優化設計出能滿足高速公路路用性能，車轍動穩定度達5000次/ mm以上，動融劈裂強度比90 ，透水系數31ml / s ，並具有防滑降噪功能的開級配瀝青磨耗層（ ogfc ）混合料。
  7. Adhesives - methods of preparing bulk specimens - elevated - temperature - curing one - part systems

    粘合劑.散裝樣品的制備方法.高溫處理單成份系統
  8. The main effect factors include : 1. microbial species, which seem to have different degradation rate under varied circumstances and n - alkanes ; 2. physical and chemical properties of crude oil itself, which have an important effect on biodegradation, such as conglutination, boiling point, refractive index, ingredient and concentration of the oil ; and 3. culture condition of microorganism, under which the degrading activity of microorganism will be affected by surfactant, light condition, sorbent, nutrition, co - metabolite, oxygen, temperature and salinity during the inoculation of selected or indigenous microorganisms

    其中主要影響因素包括：菌種的影響，菌種在不同的環境中和對不同碳鏈長度的碳氫化合物表現出不同的降解效率；石油物質本身物理化學特性的影響，如石油物質在水體或土壤中的濃度以及石油的粘度、沸點、折射率等特性；生存環境條件的影響，在接種入高效率的降解菌或利用土著微生物進行降解時，降解率受到生存環境中各種條件的影響，如表面活性劑、光照條件、吸附劑的利用、營養鹽、共代謝底物、氧氣、溫度、鹽度等。
  9. Abstract : this paper introduces a new class f epoxy glass - cloth laminate. the synthesis of a epoxy adhesive and the production process were studied. the properties of the laminate were compared with those of some similar products abroad. the results show that the laminate has higher adhesive strength 、 resistivity in moist conditions 、 dielectric strength and mechanical strength in higher temperatures. it is applicable for electric equipments, especially those to run in higher moisture or higher temperature conditions

    文摘:本文介紹了最近開發成功的一種新型f級耐高溫層壓板，研究了環氧樹脂膠粘劑的合成，層壓板的製造工藝及其性能，並與國外同類產品進行了對比，結果表明，它具有粘接強度、浸水后絕緣電阻及耐電壓、高溫機械強度高等特性，可用作大型高壓電機、輸變電設備以及核電工程、低溫高真空工程中絕緣結構材料，尤其適用於高電壓、高溫、高機械強度的工作環境。
  10. This kind of brake shoes uses organic and inorganic fibers composition reinforced material instead of asbestos, and takes phenolic resin with additives of cashew shell oil and melamine as bond

    這種剎車塊用交聯性有機纖維和無機纖維復合增強材料取代石棉並以腰果殼油、三聚氰胺對作為粘合劑的酚醛樹脂改性，使其分解溫度提高。
分享友人
分享到 Line

分享到臉書