高爐煤焦油 的英文怎麼說

中文拼音 [gāoméijiāoyóu]
高爐煤焦油 英文
blast furnace coal-tar
  • : Ⅰ形容詞1 (從下向上距離大; 離地面遠) tall; high 2 (在一般標準或平均程度之上; 等級在上的) above...
  • : 名詞(黑色固體礦物) coal
  • : Ⅰ形容詞1 (物體受熱失去水分 呈現黃黑色並發硬、發脆) burnt; scorched; charred 2 (著急) worried;...
  • : Ⅰ名詞1 (脂肪; 油脂) oil; fat; grease 2 (姓氏) a surname Ⅱ動詞1 (用桐油、油漆等塗抹) apply t...
  • 焦油 : tar; pez; goudron; coke tar
  1. Its current products include : top oscillation electrical precipitator, side electrical oscillation precipitator, magnetism controlled static electricity precipitator, wet electrical precipitator, honeycomb electric catching tar instrument, high - pressur silicon rectifier equipment and plc low - pressure controlling system, blast furnace gas impulse precipitator, high concentration pulverized coal collector, coke oven and boiler flue gas low pressure impulse precipitator, blower fan inhaler, crossing piping gas cooler, high temperature fume cooler, gyre - orientation impulse hop - pocker and all sorts of molded sections

    目前主要產品有:頂部振打臥式電除塵器、側部振打電除塵器、磁控靜電除塵器、濕式電除塵器、蜂窩電捕器、壓硅整流裝置及plc低壓控制系統、氣脈沖除塵器、濃度粉收集器、及鍋煙氣用低壓脈沖除塵器、風機空氣過濾器、橫管式氣冷卻器、溫煙氣冷卻器、回轉定位脈沖大布袋及加工各種冷彎型鋼。
  2. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋在實際運行中存在的問題:在額定負荷下,膛出口超溫、低溫段過熱器前煙溫達936 ,遠遠超過815的設計值;噴燃器四周水冷壁結嚴重,過熱器管壁溫度超標,無法帶上額定負荷;甚至有時因燃質量的變化,必須投助燃的嚴重情況進行了分析研究。在實際生產過程中,燃燒器的結構、布置,水冷壁的粘污、結垢,過剩空氣系數、一次風溫、種及其濃度變化等許多因素都會偏離鍋的設計工況,從而影響內的傳熱和燃燒,造成膛出口超溫、水冷壁結渣等問題。
分享友人