高硅表面層 的英文怎麼說

中文拼音 [gāoguībiǎomiàncéng]
高硅表面層 英文
high silicon surface layer
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 硅 : 名詞[化學] silicon （14號元素符號 si）
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 高硅 : high silicon
  • 表面 : surface; superficies; boundary; face; rind; sheet; skin; outside; appearance
  1. 4 the cleanout and the passivation of si surface was carried out by a two - step process to overcome the surface oxide layer and balance the charge between the substrate and epitaxy. by this way, the crystal quality and emission characteristic of zno thin films can be improved, which provide a way to resolve the native oxide layer of si substrate

    4 、通過用等離子體對硅襯底表面進行清洗和鈍化兩步處理，解決硅襯底表面的氧化層和界面電荷平衡問題，制備出了高質量的氧化鋅薄膜材料，找到了一條獲得了高質量的氧化鋅薄膜的新途徑。
  2. Ghg - electrical grade activated silica powder is produced by way of mingling on the basis of electrical grade silica powder. it has activt effect on surface & make silica powder mingled with resin, raise cohesive force between resin & silica powder, raise the water - resestance on the sunface and the compressive strength of pour object, reduce sediment, gradation & split, increase filler of silica powder, and replaced inpoted products on the producing line of imported dry type transfomer & high tension mutual induc tance equiment, it has been the best pouring insulate materual in electrical trade

    電工級活性硅微粉是在電工級硅微粉的基礎上進行偶聯化處理而製成，具有表面活性作用，能使用硅微粉與樹脂發生交聯，提高樹脂與硅微粉的粘結力和界面增水性，提高澆注體抗沖擊強度，減少沉澱、分層、開裂現象，增加硅微粉的填充量，在引進的乾式變壓器、高壓互感器生產線上已成功地代替了進口產品，成為電工行業理想的環氧澆注絕緣材料。
  3. Placing a thin layer of insulation between the silicon surface and the transistors protects the transistors from " electrical effects, " leading to higher performance and lower power consumption

    在硅表面之間放上很薄的一層絕緣體，可以防止晶體管的「電子效應」 ，這樣可以實現更高的性能和更低的功耗。
  4. After analysis of the xrd data, an obvious small peak was observed at 29 = 32. 62 ? the experimental results showed that the improved stabilization of the porous silicon layers was due to the formation of sio2 ( 1103 ) structure in the internal surface

    Xrd光譜顯示在2口= 32 . 620出現了一個小峰，揭示了經過過氧化氫后處理后多孔硅表面形成了一層二氧化硅（ l10刀）脫，從而提高了多孔硅厚膜的穩定性。
  5. Use of mineral silicate as adsorbent in wastewater treatment is studied, which refers to its modification with different methods in order to improve the adsorption ability

    摘要國內外許多學者對硅酸鹽吸附劑進行了改性研究，通過增大吸附劑的比表面積、改變表面化學性質、增強離子交換能力以及擴大層間間距等來提高吸附劑對污染物的吸附量。
  6. Through the research on the crystallite of the composites modified with silicone coupling agent and pp - g - mah, research showed that the size of the crystallite and oriented crystallization had obviously influence on the mechanical performances. the sem results showed that nano - sio2 was dispersed well in pp, which promoted the matrix undergo shear yielding rather than brittle fracture

    通過對硅烷偶聯劑?馬來酸酐接枝聚丙烯共聚物作為界面改性劑改性pp微晶的研究，表明微晶尺寸變化與復合材料的力學性能有關；在界面附近形成擇優取向的結晶層，促使基體發生屈服變形，提高了復合材料的韌性。
  7. The buried layers moves towards sample surface, forming surface layers. the implantation - damaged zone also moves towards the surface and is recovered gradually. the fe - implanted films were implanted, or doped, with small amount of carbon for improving the film quality

    另外隨退火溫度變化的還有注入損傷層，隨退火溫度的升高注入損傷逐漸恢復，損傷層厚度逐漸減小，到850的時候硅化物層斷裂，損傷層則上升到樣品表面。
  8. Sige simox : oxygen ions with high dose were implanted into sige grown directly on silicon substrate for the first time, and sige - oi novel structure was formed successfully with additional high temperature annealing ; it has been confirmed that oxygen implantation with 45kev, 3 1017cm - 2 and annealing at 12500c in ar + 5 % o2 for 5 hours, are fit for the formation of sige - oi structure ; ge loss during the high temperature annealing has been observed, which is originated from ge volatility and ge diffusion ; it has been proposed to use nanoporous layer induced by h + / he + implantation to surppress ge diffusion and to use surface oxidation to overcome the upper limit of sige simox. sige smart - cut : hydrogen ions were implanted into sige material and followed by high temperature process ( 4000c to 7000c ) ; blistering study was done and suggested the possibility of sige layer transfer by smart - cut technology ; it is concluded that the bubble formation is easier in sige than in si, and the strain in sige / si and the difference of binding energy in sige and in si could possibly contribute to this effect. behavior of sige / si implanted with hydrogen : gave a detailed study on sige implanted by beamline or phi hydrogen implantation ; it has been found that great strain is introduced into sige by hydrogen implantation and this strain could be alleviated by high temperature annealing ; both for conditional beamline implantation and piii hydrogen implantation, 600 is appropriate for the post - implantation treatment

    Sige - simox工藝方面：首次採用硅（ 100 ）襯底上直接外延的100nm厚sige的樣品中注入高劑量的o離子，通過退火處理成功制備了sige - oi新結構，即sige - simox工藝，證實了以45kev注入3 10 ~ （ 17 ） 7cm ~ （ - 2 ）劑量的氧離子，隨后在氧化層的保護下經1250 ， ar + 5 o _ 2氣氛的高溫退火（ 5小時）過程，可以制備出sige - oi新型材料；實驗中觀察到退火過程中的ge損失現象，分析了其原因是ge揮發（ ge通過表面氧化層以geo揮發性物質的形式進入退火氣氛）和ge擴散（ ge穿過離子注入形成的氧化埋層而進入si襯底中） ，其中ge擴散是主要原因；根據實驗結果及實驗中出現的問題，對下一步工作提出兩個改進的方案：一是通過在si襯底中注入適量h ~ + / he ~ +形成納米孔層來阻斷ge擴散通路，二是可以通過控製表面氧化來調節安止額士淤丈撈要表面sige層中的ge組分，從而部分解決sige
  9. The antiablation of silicone rubber liner can be improved both by changing the structure of unvulcanized rubber and adding antiablative fillers, and the bond strength between propellant charge and the liner would be increased largely by coating the primer liquid on the charge surface

    硅橡膠包覆層中填料的粒徑對硅橡膠的補強效果十分重要；可從改變生膠結構、添加耐燒蝕填料兩方面來改善硅橡膠包覆層的耐燒蝕性；在推進劑藥柱表面上塗覆底塗液可以大幅提高硅橡膠包覆層與推進劑的粘接強度。
  10. The simulation results showed that the delamination might be observed when the moisture concentration was in the range of 50 % and 95 % of saturate concentration for non - coating, topside coating and both sides coating samples

    兩相共存的微孔洞還山於水分子爭奪高分子的氫鍵使高分子與晶元表面的二氧化硅層的結合減弱，而逐步擴展形成可觀察到的分層。
  11. However, the reserves of calcium bentonite is low and the surfactants are expensive, which bring many difficulties to industrialization. in this paper, an abundant and low cost raw material, calcium bentonite, and several new modifying agents such as compound quaternary ammonium salt with cheap caprolactam or anionic surfactant or silane coupling agent were used to synthesize new - type organobentonites, in the principal of efficient, cheap and simple

    作者嘗試以資源十分豐富的鈣基膨潤土為原料，依據高效、廉價、使用簡單的原則，以傳統插層劑季銨鹽為基礎，分別用價格較低的己內酰胺、陰離子表面活性劑、硅烷偶聯劑部分取代季銨鹽作插層劑，來制備新型的有機膨潤土。
分享友人
分享到 Line

分享到臉書