高磁導率材料 的英文怎麼說

中文拼音 [gāodǎocáiliào]
高磁導率材料 英文
high-permeability material
  • : Ⅰ形容詞1 (從下向上距離大; 離地面遠) tall; high 2 (在一般標準或平均程度之上; 等級在上的) above...
  • : 名詞1. [物理學] (磁性; 能吸引鐵、鎳等的性質) magnetism 2. (瓷) porcelain; china
  • : 動詞1. (引導) lead; guide 2. (傳導) transmit; conduct 3. (開導) instruct; teach; give guidance to
  • : 率名詞(比值) rate; ratio; proportion
  • : 名詞1 (木料) timber 2 (泛指可以直接製成成品的東西; 材料) material 3 (供寫作或參考的資料) ma...
  • : 名詞1 (材料; 原料) material; stuff 2 (喂牲口用的穀物) feed; fodder 3 (料器) glassware 4 (...
  • 材料 : 1. (原料) material 2. (資料) data; material 3. (適于做某種事的人才) makings; stuff
  1. The raw materials, the composition, the time of milling, the calcining temperature, the different additives, the sintering temperature and the sintering parameters were investigated. the result showed : it was advantaged to obtain high initial permeability mnzn ferrite with stable frequency characteristic using high - purity raw materials ; in order to obtain mnzn ferrite with high properties, we must control strictly the composition ; it could improve the properties of mnzn ferrite by optimizing calcining temperature. the lower calcining temperature made the permeability higher, and the higher calcining temperature could promote the frequency characteristic of permeability ; we chosen the right time of milling according to the requirement of power diameter ; in order to improve the properties of mnzn ferrite, it is necessary to add effective additives. in this dissertation, the influence of bi2o3 、 moo3 、 k2co3 、 co2o3 were investigated ; the sintering temperature, the time of heat - retaining and sintering parameters were the key factors of preparing high permeability mnzn ferrites

    研究結果表明:採用純度的fe2o3有利於獲得起始且頻特性優良的鐵氧體;為了制備所需性能的鐵氧體,需要嚴格控制配方中各種原的含量,優化配方;由於粉體活性受預燒條件的影響,所以對不同要求的鐵氧體選擇的預燒條件就不一樣,適當降低預燒溫度有利於獲得較的起始,而為了獲得良好的頻特性可以適當地提預燒溫度;根據對粉體顆粒粒徑的不同需求,可以選擇不同的球磨時間;而有效的添加劑是改善性能的必要條件,本文在添加劑的研究中主要對bi2o3 、 moo3 、 k2co3 、 co2o3的影響分別作了詳細地討論;燒結溫度、保溫時間和燒結氣氛是mnzn鐵氧體制備最關鍵的工藝,適宜的燒結工藝可以獲得理想微結構和組成,從而得到性能的鐵氧體;而從的微結構上來看,要提的截止頻,就要適當地細化晶粒、增加晶粒內部的氣孔。
  2. Mnzn power ferrite material characteristics

    Mnzn鐵氧體
  3. Imported from germany, elevator kiln produce high frequency, low power loss material : nh2c equivalent to tdk pc44 and high initialpermeability material : nh13a ui 13000. advanced controlling technique of internalatmosphere and temperature curve to ensure its excellent performance, their high quality and stable character will meet telecom and networkcustomers strictly demand. we specialized in manufacturings. m. p. s transformers, inductors

    公司引進德國鐘罩爐設備,採用先進的爐內氣氛控制方法和特殊的氣氛曲線,生產頻低損耗功鐵氧體nh2c相當于tdk pc44及鐵氧體nh13aui 13000 ,充分滿足客戶對網路通訊用芯在性能和穩定性上近似苛刻的要求。
  4. And then we used the armor plate to do the experiment, we found that the thin silicon steel board which poses high magnetism conductance rate is far better than the normal steel board

    選擇鋼板作渦流加熱實驗時,發現具有的薄硅鋼板的渦流熱效應明顯比普通鋼板好。
  5. The nh2c and nh15a high permeability material and ferrite cores developed by lfg co., have been approved to be the new products at province level

    公司研發的nh2c性能軟鐵氧體芯超nh15a芯日前通過省級新產品鑒定。
  6. Compared with traditional silicon steel, fe - 6. 5wt % si in theory is considered as an excellent property soft magnetism alloy. it has such excellent soft magnetism properties as higher permeability higher saturation magnetic induction near - zero magnetostriction and low core loss

    Fe - 6 . 5wt si硅鋼是一種性能優異的軟合金,與傳統硅鋼相比,它具有飽和感應強度、低致伸縮和低鐵損等更優異的性能。
  7. What is an active protection, elementary : mike or receiver of the signal - an amplifier, 1 transistor - a capacitor with changeable resistor - an output on speaker or emitter

    范圍超過100千兆赫,採用反射體屏蔽,具有介電常數,性,水或鎂7分水作為遮蓋金字塔,填充物- - -一個吸收器- - -石墨,碳。也可以建造積極保護方式電容器。
  8. For improved low - frequency magnetic shielding, a shield consisting of a high - permeability magnetic material ( e. g., mumetal ) should be considered

    要改善低頻屏蔽的效果,就要考慮用(即合金)來製作屏蔽體。
  9. Especially y - ni - 22fe, which have been widely used in industry things such as magnetic record heads, transformers or magnetic shielding materials due to its high permeability, low coercive force and relatively high saturation magnetization

    特別是- ni - 20fe合金,因其較、飽和化強度、低的矯頑力而廣泛用於記錄頭、變壓器和屏蔽等。
  10. Magnetic conductivity non - magnetic alloy with very high strength, excellent wear resistance and very low magnetic conductivity, used for forming ddie for permanent - magnetic materials

    合金具有很的強度和優良的耐磨性以及極低的。用作永的成型模具。
  11. The first part of this thesis includes the following information : ( 1 ) the significance of materials and the progress in every fields of material science in recent years ; ( 2 ) the history of magnetic material and the classification of magnetic material ; ( 3 ) the emergency and the classification of organic magnetic materials as well as the significant progress in the field of ferrocene polymeric magnet recently ; ( 4 ) introducing die development and the status quo of dielectric polymer and discussing the four parameters which are used to characterize the dielectric beheaviour of material, these parameters mclude dielectric constants dielectric loss ^ electric conductivity and breakdown strength

    本文在開頭部分簡單講述了以下內容了: ( 1 )的重要性以及近些年來業各個領域的發展; ( 2 )的發展史以及的分類; ( 3 )有機的出現、有機的分類和近些年來有機金屬尤其是二茂鐵分子體領域所取得的重要進展; ( 4 )分子介電的發展與現狀,對表徵介電性能的四個重要參數即介電常數、介電損耗、電和擊穿強度做了比較詳盡的論述。
  12. So the study of high permeability on mn - zn ferrite materials is an important way

    所以研究mn - zn鐵氧體是軟鐵氧體研究的一個重要方向。
  13. High permeability soft magnetic mn - zn ferrite materials is a wide used functional materials

    mn - zn鐵氧體(以下簡稱鐵氧體)是應用非常廣泛的一種功能
  14. Thinning the crystal grain and increasing the center vent are effective approach to raise the limiting frequency of high permeability mnzn ferrite. through large quantities of experiments, we made progress in raising limiting frequency of high permeability mnzn ferrite. we prepared the broad band mnzn ferrite of which the initial permeability was 10000

    通過採用上述實驗中的優化配方、添加劑組合以及制備工藝,我們在高磁導率材料的寬頻特性方面取得了很大的進展,研製出了起始為10000的寬頻mnzn鐵氧體,當頻達到300khz時,起始下降不到20 % ,其性能相當于epcos公司改進的t38
分享友人