高錳碳鋼 的英文怎麼說

中文拼音 [gāoměngtàngāng]
高錳碳鋼 英文
high manganese carbon steel
  • : Ⅰ形容詞1 (從下向上距離大; 離地面遠) tall; high 2 (在一般標準或平均程度之上; 等級在上的) above...
  • : 名詞[化學] manganese (25號元素, 符號 mn)
  • : 名詞[化學] (非金屬元素) carbon (c)
  • : 鋼名詞(鐵和碳的合金) steel
  1. And with the increased test time, the superiority of the low carbon high alloy steel was well illuminated. the worn surfaces of the three steels show that the mechanism of the low carbon high alloy steel is impact abrasion, the high manganese steel is impact - corrosion, and the medium carbon alloy steel is the heaviest impact - corrosion

    最後通過hitachi - x - 650掃描電子顯微鏡考察了低合金和中合金試樣的沖擊腐蝕磨損表面形貌,並用olympus光學顯微鏡進行了光學金相分析,對這三種的磨損機理進行一定的探討。
  2. Standard specification for high - strength carbon - manganese steel of structural quality

    結構級強度的標準規范
  3. High manganese carbon steel

    高錳碳鋼
  4. Development and study on properties of low - alloyed middle carbon steel with higher silicon - manganese content

    低合金耐磨的開發及性能研究
  5. In this study, the resistance to high impact, corrosion and abrasive wear was determined for low carbon high alloy steel, and for comparison, the high manganese steel and the medium carbon alloy steel are also tested

    腐蝕磨損試驗機的轉速400轉分。在不同的介質( ph 3 )和不同的時間內,對低合金和中合金進行了沖擊腐蝕磨損性能的研究。
  6. We discussed the behavior of corrosion - abrasion of the liner of wet - grinding machine in simulated metallurgical conditions. the results show that under the simulated slurry, the corrosion rate and the wear loss of the low carbon high alloy steel is better than the high manganese steel and the medium carbon alloy steel

    實驗表明,在模擬冶金礦山的實際工況條件下,低合金具有優良的綜合性能,壽命最長,是比和中合金更適合冶金礦山的嚴酷工況條件的濕式磨機襯板新材質。
  7. Transportable gas cylinders - specification for the design and construction of refillable transportable seamless normalized carbon manganese steel gas cylinders of water capacity up to 0, 5 litre for compressed, liquefied and dissolved gases and up to 1 litre for carbon dioxide

    可運輸儲氣瓶.壓縮液化和溶解氣體用的水容量達0 . 5升和二氧化用的水容量達升的可再充裝無縫正火儲氣瓶的設計和製造規范
  8. Standard specification for pressure vessel plates, carbon steel, high - strength manganese

    壓力容器用強度板標準規范
分享友人