高阻抗放大器 的英文怎麼說

中文拼音 [gāozǔkàngfàngdàqì]
高阻抗放大器 英文
high-impedance amplifier
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 放 : releaseset freelet go
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 阻抗 : [電學] impedance
  • 放大器 : amplifier; pantograph; lawnmower; enlarger; magnifier
  • 放大 : amplify; magnify; boost; enlarge; blow up; gain; amplification; enhancement; multiplication; magn...
  1. If the node is at, or near to, ground then a grounded guard ring will be appropriate, if it is at some other potential it may be necessary to use a high input impedance buffer amplifier, with its input connected to the node, to force the guard ring to the node potential

    如果被保護的節點的電位是（或接近）零電位，採用地線保護環最為合適；如果節點電位是其他值，那麼可以用高輸入阻抗放大器組成緩沖器，輸入端連接該節點，輸出端連接保護環。
  2. Double - way high impedence prepositive amplifier for electrochemical test

    雙路高阻抗電化學測試前置放大器
  3. Semiconductor integrated circuits. detail specification for type jf3140 and jf3140a bimos operational amplifiers with high input impedence

    半導體集成電路. jf3140 jf3140a型bimos高輸入阻抗運算放大器詳細規范
  4. We have designed different measurement instruments according to the methods. the instrument used to measure electrode is a high precision multi - channel system constructed with a iaadc as the core and high input impedance amplifier and low input current multiplexer

    對于硫屬玻璃電極，我們設計了以高精度的adc為核心，配以高輸入阻抗低噪聲的前置放大器和低漏電流多路模擬開關的多路精密電極測量系統。
  5. In non - selfsustained discharge the excitation and ionization processes can be controlled separately, which is useful to optimize the e / p value of the discharge. the ballast resistance can be leaved out and the maximal electro - optical efficiency reaches 19 %

    非自持放電使激光器的激發和電離過程分開，有利於使二者分別處于各自的最佳e p值附近，放電的正阻抗特性使放電電路可以省去限流電阻，極大地提高激光器的實際效率。
  6. The current in the dac ’ s output can drive the load, and the structure can save a buffer consisted of operational amplifier, so the structure can achieve high speed with no close - loop and feedback in this circuit

    該10位分段式電流舵型數模轉換器的輸出端可直接用電流輸出來驅動負載阻抗，省去運算放大器構成的輸出緩沖，整個電路中沒有形成閉環和反饋，因此這種電路結構可以達到很高的速度。
  7. While low voltage and low power is realized when designing the operational amplifier in this text, great efforts have been devoted to increasing the input common mode range and the swing of output signal, and lowing the output resistance at the same time

    只是實現低壓低功耗而不實現良好的性能顯然是錯誤的。本文在設計實現低壓低功耗的運算放大器的同時，也想法提高輸入共模範圍和輸出信號的幅度，同時降低輸出阻抗。
  8. The complementary high impedance iutputs are suitable for driving transmission lines directly or connecting a omp to bring low impedance outputs

    互補的高阻抗電流輸出適合直接驅動傳輸線或帶一個外部運算放大器以產生低阻抗輸出電壓。
  9. Transistor hi - fi power amplifier, the output impedance is low, can actuate the speaker well

    高速晶體管hi - fi功率放大器，輸出阻抗低，能更好地驅動揚聲器。
分享友人
分享到 Line

分享到臉書