高電阻高阻抗 的英文怎麼說

中文拼音 [gāodiànzǔgāozǔkàng]
高電阻高阻抗 英文
high resistance
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 電阻 : （物質阻礙電流通過的性質） resistance; electric resistance （電路中兩點間在一定壓力下決定電流強度...
  • 阻抗 : [電學] impedance
  1. In this thesis, the author analyses the deficiency in detecting and controlling function of the computer detecting and controlling system utilized in present transforming station. the strategy of design of software on operation and direction of 5 00kv transformer station is presented. it points out that we can deduce the mathematic analytical formula using the current, voltage and power of two terminals of transmission line as input. on this basis, we do realtime calculation of 500kv transmission line ' s parameter. we can also deduce the linear analytical formula of three - winding autotransformer ' s resistence using its current, voltage and power as input. the corresponding software is programmed on this basis

    論文提出以輸電線路本端和對端電流、電壓、功率作為輸入量，導出了超高壓長線的波阻抗和傳播常數的數學解析式，在此基礎上進行了500kv輸電線路實時參數計算；提出以三繞組自耦變壓器的電流、電壓、功率為輸入量，導出了自耦變壓器繞組的電阻、電抗的線性解析式並進而對變壓器的實時參數進行計算；在此基礎上編制了相應的軟體。
  2. In the work, it was systemically studied that the effects of two suggested modifying ways on electrochemical characteristics of lithium metal electrode and its behaviors in lithium cell. finally, the action mechanisms of these two modifying ways were analyzed. through the study on pretreatment effects of different cyclic ether on lithium electrode, it was found that 1, 4 - dioxane ( doa ) and 1, 3 - dioxolane ( dol ), both could form a favorable passivating sei film on lithium electrode surface through

    研究不同環醚對鋰電極的預處理作用發現， 1 ， 4 -二氧六環（ doa ）和1 ， 3 -二氧五環（ dol ）對金屬鋰電極的表面預處理均可以在金屬鋰表面形成一層良好的sei鈍化膜，對鋰金屬電極起到了保護性作用，使鋰電極具有較小的界面阻抗，有效地提高了金屬鋰電極的充放電循環效率，改善了鋰金屬電極在循環過程中的表面形貌;而doa和dol對金屬鋰電極的表面預處理，不會明顯的影響鋰電極的動力學性能。
  3. Used as linings, bottoms in electrolytic cells, smelting furnaces

    高強抗滲澆注料用於電解槽底部，作為阻擋層使用。
  4. To achieve the high impedance required specially designed "electrometer" vacuum tubes, field effect transistor must be used in the input stage.

    為適應高阻抗需要，儀器輸入電路中須用特殊設計的靜電計專用電子管、場效應晶體管。
  5. 2000hours low impedance, suit for use in switching power supplies and high frequence circuit

    2000小時，低阻抗，適用於開關電源及高頻電路
  6. In applications where high impedances and very low currents are involved a guard ring may be used to minimize the effects of low insulation resistance

    保護環用在那些高阻抗或電流非常微弱的電路中，用於減輕因絕緣電阻不夠高而產生的（漏電）問題。
  7. If the node is at, or near to, ground then a grounded guard ring will be appropriate, if it is at some other potential it may be necessary to use a high input impedance buffer amplifier, with its input connected to the node, to force the guard ring to the node potential

    如果被保護的節點的電位是（或接近）零電位，採用地線保護環最為合適；如果節點電位是其他值，那麼可以用高輸入阻抗放大器組成緩沖器，輸入端連接該節點，輸出端連接保護環。
  8. Double - way high impedence prepositive amplifier for electrochemical test

    雙路高阻抗電化學測試前置放大器
  9. Since the secondary winding is normally operated into a high-impedance circuit, the secondary current is quite small.

    因為次級繞組通常輸入高阻抗的電路，因此次級電流很小。
  10. Long - pulse high - impedance intense e - beam diode

    長脈沖高阻抗強流電子束二極體
  11. Probe, and one high impedance probe - are all matched to the 50 inputs of

    一個是磁場探頭，一個是電場探頭，還有一個是高阻抗探頭。
  12. We have made three - dimension electric conduct grid by hand and we have successfully used it as anode grid in lead - acid battery. this kind of three - dimension electric conduct grid can improve the utilization of pam by 7 - 9 % in different discharge current density and can reduce the plate electrochemical impedance to one tenth of the normal plate. also this kind of grid can improve the marginal reaction current density in a certain degree

    我們通過手工製作了三維導電體板柵，並成功的應用於電池的正極作為正極的板柵，這種三維導電體板柵能夠在各種不同的放電電流密度下提高正極活性物質利用率7 9 ，能夠使電池正極板的電化學阻抗降低到普通板柵的1 10左右，使正極板的極哈爾濱j _程大學碩十學位論文限反應電流密度略有所提高，但是這種板柵的耐腐蝕性能很不理想，使得所製作電池的壽命很短。
  13. From the experiment we have found out that the carbon fibre can improve the anode performance when it was used as pam additive and meanwhile it can have some benefits to the anode life. when its content at 0. 2 - 0. 3 % in pam can achieve its best result and under this situation it can improve the utilization of pam by 5 % at different discharge current. carbon fibre and sulfate sodium is used as complex pam additive and its effect is better than that of carbon fibre which alone is used as additive

    通過實驗我們發現，碳纖維作為鉛酸電池的正極活性物質添加劑能提高鉛酸電池正極的性能，並且對電池正極板的壽命有一定的好處，當碳纖維在正極活性物質中的含量為0 . 2 0 . 3能得到最理想的效果，這個時候能在各種不同的放電電流下提高正極活性物質的利用率5左右，並且能夠使極板的電化學阻抗降低。
  14. In non - selfsustained discharge the excitation and ionization processes can be controlled separately, which is useful to optimize the e / p value of the discharge. the ballast resistance can be leaved out and the maximal electro - optical efficiency reaches 19 %

    非自持放電使激光器的激發和電離過程分開，有利於使二者分別處于各自的最佳e p值附近，放電的正阻抗特性使放電電路可以省去限流電阻，極大地提高激光器的實際效率。
  15. The research of patch antennas based on photonic - bandgap ( pbg ) structures is a relatively new area. the goal is to improve the performance of the patch antennas by using the special features of pbg structures. though some good research results have been obtained by scientists in the world, there still exit some problems to be solved for improving the performaces and reducing the size, weight and cost

    雖然國內外已經在基底鉆孔型、地面腐蝕型、高阻抗表面型、 uc - pbg型、覆層型和軟表面型電磁（光子）晶體貼片天線等方面開展了研究，但是在這些研究中還遺留著多方面的問題有待解決，以顯著改善天線的性能指標，減少天線的體積，重量，降低天線的加工費用等。
  16. The electrochemical impedance spectroscopy of anodic reaction shows that the formation of black nickel was mainly controlled by electrochemical reaction at low anodic potential, and is mainly controlled by electrochemical reaction and diffusion at high anodic potental. with the increasing of anodic potential., the formation of black nickel is still controlled by electrochemical re

    陽極反應的電化學阻抗譜表明，氧化電位較低時ni （ oh ） :氧化生成黑鎳的過程主要受電化學反應所控制，電位較高時，黑鎳形成過程主要受電化學反應及擴散混合控制，電位進一步增加，析氮反應占據主導優勢，陽極氧化過程仍主要受電化學反應及擴散混合控制。
  17. Usually the bridge circuit has a relatively high input impedance so that it has an insignificant effect on the signals in the transmission line

    通常橋接電路具有較高的輸入阻抗，因此傳送線上的信號將不受影響。
  18. In order to drive a high impedance load such as hpm sources, it is necessary to commutate fcg ' s long pulse width, high - current and low voltage pulse to a short pulse with high voltage

    為用fcg驅動象hpm源這樣較高阻抗的負載，必須使用脈沖功率調制電路把fcg產生的低電壓、大電流、上升時間長的電壓脈沖轉化為高電壓、上升時間短的脈沖。
  19. The complementary high impedance iutputs are suitable for driving transmission lines directly or connecting a omp to bring low impedance outputs

    互補的高阻抗電流輸出適合直接驅動傳輸線或帶一個外部運算放大器以產生低阻抗輸出電壓。
  20. Ti ? the input current that holds the input at the previous state when the driving device goes to the high - impedance state

    當驅動器件轉至去高阻抗狀態時，保持輸入處于先前狀態的輸入電流。
分享友人
分享到 Line

分享到臉書