點中心 的英文怎麼說

中文拼音 [diǎnzhōngxīn]
點中心 英文
center of points
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  1. The pathology characteristic that liver fiber changes is collect there are many fibre hyperplasia and deposit inside abbacy and liver flocculus, but have not form the interval inside flocculus, liver cirrhosis has false flocculus to form, central vein area and collect abbacy occurrence interval, the normal structure of liver is destroyed, liver fiber changes further progress to be liver cirrhosis namely

    肝纖維化的病理特點為匯管區和肝小葉內有大量纖維組織增生和沉積，但尚未形成小葉內間隔，肝硬化則有假小葉形成，中心靜脈區和匯管區出現間隔，肝的正常結構遭到破壞，肝纖維化進一步發展即為肝硬化。
  2. Linear estimation of the number of zeros of abelian integrals for cubic isochronous centers

    對某些三維等時中心abel積分零點個數的線形估計
  3. It also put forward a novel conception to resolve the locating center and abscission point under the condition that the fruit or vegetables are partially sheltered

    同時，提出一種全新的理念解決果實被部分遮擋時中心點和採摘點確定問題。
  4. Revert suggestion : when received the affirmance faxed by the issuing bank, according to the suggestion, make corresponding register, inform the accepting network dealing with respectively

    回復意見：受理行授權中心收到發卡行傳回的《確認書》 ，根據發卡行的回復意見進行相應的授權登記后，通知受理網點做相應處理。
  5. Because it is impossible to adjust the air bearing absolutely balance, the difference between mass center and rotation center must lead to a notable gravity disturbance torque. in the process of identification, modeling and identification of gravity disturbance torque is considered, and an extended kalman filter is educed for identifying air bearing inertia matrix and gravity disturbance torque, and then the algorithm is validated

    由於氣浮臺平衡調試方法和手段的限制，實驗過程中氣浮臺質心與轉動中心有一定的位置偏差，必將導致較大的重力干擾力矩，在辨識演算法的推導過程中，重點考慮了重力干擾力矩的建模和參數辨識問題，推導了氣浮臺的轉動慣量和重力干擾力矩辨識的擴展卡爾曼濾波演算法，並對演算法進行了數學模擬和全物理模擬驗證。
  6. Infinity is used as a base point in homemorphic transformation to study infinity for a class of fifth system and isochronous center problems

    摘要通過同胚變換把系統無窮遠點化為原點，研究了一類五次系統無窮遠點中心與擬等時中心問題。
  7. 0. 10in connectors for frequencies below 3 mhz for use with printed boards. part 3 : two - part connectors for printed boards having contacts spaced 2. 54 mm o. 100 in centres and staggered terminations at that same spacing

    印製板用頻率低於3mhz的連接器.第3部分:觸點中心相隔距離和交錯線端子相隔距離為2 . 54mm
  8. 0 75in connectors for frequencies below 3 mhz for use with printed boards. part 4 : two - part connectors for printed boards having contacts spaced at 1. 91 mm 0. 075 in centres and staggered terminations at that same spacing

    印製板用頻率低於3mhz的連接器.第4部分:觸點中心相隔距離和交錯線端子相隔距離均為1 91mm
  9. Research on interface shows the joint begins at the bond periphery, then the center area of the joint, and at last the achievement of connection of the whole joint

    鍵合試驗發現:鍵合點的形成始於鍵合點周邊，然後是鍵合點中心區域，最後完成整個界面的連接。
  10. A hardpoint marker should be placed at the center of the hardpoint

    掛載點標記應位於掛載點中心。
  11. Your goal is to play the lower left - hand corner of maps flashing flashing dots, the more dots close to the center, the higher the score

    你的目標是游戲左下角地圖中一閃一閃的圓點，越接近圓點中心，得分越高。
  12. Test results show that axial force of permanent magnet bearings is not influenced by progressive displacement or displacement decline ; axial force is symmetry of origin

    此外，試驗結果表明了永磁軸承的軸向力不受位移遞增或遞減試驗的影響，而且軸向力是沿原點中心位置對稱的。
  13. 0 ? 75in connectors for frequencies below 3 mhz for use with printed boards - two - part connectors for printed boards having contacts spaced at 1, 91 mm 0, 075 in centres and staggered terminations at that same spacing

    印製板用頻率低於3mhz的連接器.觸點中心間距和交錯端子間距均為1 ? 91mm
  14. 0. 100in connectors for frequencies below 3 mhz for use with printed boards - two - part connectors for printed boards having contacts spaced at 2, 54 mm 0, 100 in centres and staggered terminations at that same spacing

    印製板用頻率低於3mhz的連接器.觸點中心距和交錯線端子間距均為2 . 54mm
  15. This article introduced the reforming measures of the experimental teaching of basic biology experimental teaching center of life science college of liaoning normal university from the aspects of reforming background, processes, principle, measures, creation, features of center and developing program etc

    摘要從改革背景與歷程，改革理念、措施與創新點， 「中心」特色及發展規劃等幾個方面，介紹了遼寧師范大學生命科學學院生物基礎實驗教學中心的實驗教改措施。
  16. Swd : short way of design measured from center of bond to center of bond

    短節距：從節點中心到節點中心的短的菱形對角線的長度。
  17. Lwd : long way of design measured from center of bond to center of bond

    長節距：從節點中心到節點中心的長的菱形對角線的長度。
  18. At last, the paper evaluates modernization of towns in county administrative areas by quantitative way. it points out many problems at present in the span of scale alteration. for example, the ability of convergence is limit, land - use per - person exceeds normal standard, a lot of towns are lack of fund, the infrastructure lags behind

    最後，以全省222個重點中心鎮為研究對象，對縣域城鎮的現代化水平進行定量化評估，指出縣域城鎮規模變動過程中所面臨的問題，如人口吸納力不足、人均用地嚴重超標、城建資金匱乏、基礎設施滯后等，並提出了進行制度創新、增強城鎮集聚能力等對策和建議。
  19. New af system with 9 cross - type sensors, and world ' s first diagonal high - precision cross - type af at center point with f / 2. 8 and faster lenses

    9個十字對焦點，中心的是世界首創對角型高精度十字對焦，這個形狀可挺奇怪的
  20. Part four gives several improving measures such as improving the spatial distribution, changing the cities " scale degree structure, choosing important center city etc as to solve the problems mentioned in part three. several regional supplementary measures are also advised

    第四部分：針對第三部分提出的問題提出了城市群的優化措施，主要包括空間布局上的優化、城市群規模等級結構的完善以及重點中心城市的選擇等。
分享友人
分享到 Line

分享到臉書