點掃描 的英文怎麼說

中文拼音 [diǎnsǎomiáo]
點掃描 英文
spot scan
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 掃 : 掃構詞成分。
  • 描 : 動詞1. （照底樣畫） copy; depict; trace 2. （在原來顏色淡或需改正之處重復塗抹） retouch; touch up
  1. Simulation for target image - point scanning of ir aam seeker

    某型紅外空空導彈導引頭目標像點掃描模擬研究
  2. Equal channel angular processing of the pearlitic steel ( 0. 65 wt. % c ) was successfully carried out at 650 with route c in this study, obtaining a total equivalent true strain ~ 5. the microstructure evolution of pearlitic steel in ecap was investigated by means of transmission electron microscope and scanning electron microscope. the main results are as the following : 1

    本研究成功地實現了c方式650珠光體鋼65mnecap變形，累積等效真應變達到5 。並用透射電鏡、掃描電鏡研究了珠光體組織的演變特點和滲碳體的變形。主要結果如下： 1
  3. The control system included the following units : video decode unit, data format conversion unit, fpga controller, cache unit and d / a monitor. the above self - design control unit plus row and column power supply units make the whole fed driving system, thus drove the 25 inch sample and realized color video display. the 25 inch vga sample thus fabricated could display video images, and obtained its brightness 400cd / m2, contrast ratio 1000 : 1, 256 circuit gray scale

    本文介紹了fed驅動系統的工作原理，重點論述了基於fpga的vga級彩色fed新型驅動控制系統的研製，這種新型fed驅動控制系統主要包括視頻解碼電路、數據格式轉換電路、 fpga控制電路、數據緩存電路和d / a監控電路，配合后級列灰度調制單元和行掃描單元，組成完整的fed驅動系統，可以驅動25英寸vga級fed顯示屏，實現彩色視頻顯示，樣機亮度達400cd / m2 、對比度為1000 : 1 ，灰度等級為256級。
  4. The amount by which the dot deflects past the end of the screen is called the screen-overscan.

    光點偏轉超過熒光屏邊緣的總數叫做熒光屏過掃描。
  5. Based pc, d / a convertor and 2 - dimension galvanometer scanning system, laser marking control system is built. coordinate data scanned and kept in the computer are transformed into the analog signals by d / a converter, then control the galvanometer to deflexion

    基於pc 、 d / a轉換器和二維振鏡掃描系統搭建激光打標機控制系統，將存儲在主控計算機的掃描坐標點的坐標數據通過d / a轉換，將數字信號轉換成模擬信號來控制振鏡偏轉。
  6. In the system, the collimation semiconductor laser - scanned beam scanning two perpendiculars direct of one plane of the measured workpiece at the same time is made. the beams with the dimension information of two perpendiculars direct are processed by the scanning receive system, the high - speed photoelectric transition and electronic data process. two measured results of the diametric directs and ellipse tolerance, etc, parameter, of the turning workpiece on the same plane are obtained by non - contact automatic measurement

    在單向激光掃描檢測技術的基礎之上，提出了一種雙向激光掃描檢測系統，其採用激光掃描檢測技術與特殊光學系統相結合，用準直半導體激光掃描光束對被測工件徑向某一截面的兩個相互垂直方向同時掃描，經掃描接收光學系統、高速光電變換、電子學系統和微機數據處理系統，對將攜帶有垂直方向被測量信息的光束進行處理，實現了回轉體工件同一截面兩個垂直方向的徑向尺寸和橢圓度等參數的非接觸自動測量，解決了同時非接觸測量回轉體零件同一截面兩個徑向尺寸的難題，它具有高速，高精度和非接觸自動測量等特點。
  7. The simulation results suggest that, at the end of the scanning line, the dissymmetric temperature field and the great temperature gradient result in the balling phenomenon and great thermal stress, which could lead to the destruction of the sintering samples in this region. because of the coupling effect between scanning lines, the balling phenomenon is increased as the increase of the scanning lines, thus the over short scanning lines should be avoided in the sintering process. different scanning strategies have significant influence on the sintering

    模擬結果表明，掃描端點溫度場的不對稱及較大的溫度梯度造成了端點球化現象，並在端點處產生較大的熱應力，使燒結成形試樣易在此處破壞;激光掃描線間的耦合作用使端點球化現象隨掃描線的增加而逐漸顯著，燒結時應避免過短的掃描線;不同掃描策略對燒結成形有很大影響，交替掃描會影響燒結試樣的質量，實際製造時應採用單向掃描策略。
  8. Fss - flying spot scanner

    飛點掃描設備
  9. Fss flying spot scanner

    飛點掃描儀
  10. Flying spot scanner

    飛點掃描器
  11. Light spot scanner

    光點掃描設備
  12. Our centre is equipped with the very latest 4th generation flying - spot laser from bausch & lomb

    （博士倫特新第4代飛點掃描激光儀器。
  13. 8 mm wide magnetic tape cartridge dual azimuth format for information interchange - helical scan recording

    信息交換用8mm寬盒式磁帶雙方位格式.螺旋觸點掃描記錄
  14. The small scanning - spot excimer laser corneal system was developed based on flying - spot scanning model

    摘要以飛點掃描切削模式為基礎，研製小光斑飛點掃描準分子激光角膜屈光矯正系統。
  15. In this modality, line - scan is adopted instead of point - by - point - scan, and the count of scattered photons is obtained by parseing line - scanning energy spectral data

    該方法採用逐行掃描代替逐點掃描，對行掃描的能譜進行解析以獲得散射光子的計數。
  16. A new binocular vision sensor based on lcd grating technique is developed. it has the functions of three traditional vision sensors : point scanning, line scanning and grating code

    研製了基於液晶光柵技術的新型雙目視覺傳感器，無需硬體改動，只需改變軟體即可實現點掃描、線掃描和光柵編碼型視覺傳感器的功能。
  17. And wherein the model is adapt to the change of size of the transition zone of corneal. the model can be used to correct wavefront aberration. the hardware and sofeware of the ophthalmic excimer laser system is designed

    設計了準分子激光人眼像差矯正系統的硬體和軟體系統，並對像差矯正系統實現的關鍵技術? ?飛點掃描技術、主動跟蹤技術、能量閉環控制技術進行了深入的研究。
  18. The schema of the excimer laser aberration correction system was provided. according to this paper ' s research result. we developed the ophthalmic excimer laser system. ( aov - fb system ) with cooperation of su zhou 66 vision tech co., ltd. during animal and clinic practices, it has achieved satisfied outcomes

    根據論文理論研究成果，設計了準分子激光眼科治療機的硬體系統和軟體系統，並就飛點掃描、主動眼球跟蹤技術，能量閉環控制等關鍵技術進行了深入的研究，同有關單位合作，研製了新一代的準分子激光眼科治療機，目前已經投入臨床應用，取得了良好的效果。
  19. Based on the relationship between the change of the cornea thickness and optical path length, the ablation profile for the correction of wavefront aberration is presented and simulated on computer. the process of scanning - spot excimer laser is studied and simulated on computer. models for calculation of residual wavefront aberration on situations of lateral decentration and torsional misalignment are brought up

    使用改變光程的方法建立起波前像差與角膜切削量之間的關系，並對像差矯正模型進行計算模擬;深入研究了小光斑準分子激光飛點掃描模型，對飛點掃描過程進行計算模擬;提出了中心偏移和旋轉情況下剩餘像差計算模型，為定量研究切削中心定位精度對像差矯正的影響提供了依據。
  20. The functions have the feature of convenience and effect developed by automation. the technique for processing scanning image of engineering drawings ensure obtaining clear and exact image. computer simulation and program development illustrate that applying neural network in character recognition can achieve satisfaction effects

    提出的採用automatfon技術實現的系統功能具有簡便、有效的特點，掃描圖紙的處理過程中所使用處理技術為獲得清晰、準確的圖紙圖像提供了保障，採用人} _神經網路的字元識別方法經過模擬實驗與程序設計，證明有良好的效果。
分享友人
分享到 Line

分享到臉書