點滴試驗 的英文怎麼說

中文拼音 [diǎndīshìyàn]
點滴試驗 英文
drop test
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 滴 : Ⅰ動詞（液體一點一點地向下落） drip Ⅱ名詞（一點一點地向下落的液體） drop; droplet Ⅲ量詞（用於滴下的液體的數量） drop
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 點滴 : 1. （零星微小） a bit; crumb 2. （滴劑） drop 3. （藥劑靜脈滴注） drip; intravenous drip
  • 試驗 : trial; experiment; test
  1. Standard guide for measurement of thin chromium coatings by spot test

    用點滴試驗法測量薄鍍鉻層厚度
  2. Test method for cleanliness and compatibility of residual fuels by spot test

    通過點滴試驗對殘余燃料相容性和清潔性的試驗方法
  3. Standard test method for cleanliness and compatibility of residual fuels by spot test

    用點滴試驗法測定殘余燃料清潔度和兼容性的標準試驗方法
  4. Analysis of experimental data indicates that there exist several following problems during the whole operation : first, the emission is serious and the density of hc and co smoke is very high at on and off period. second, there is oil dripping from the dripping vitta as a result of the fault of ignition system and combustion structure. the last, there might be accidents of disabled ignition resulted from the improper operation at the beginning

    通過對樣機的試驗分析和研究表明，汽車空氣燃油加熱器在整個工作過程中，其排放存在以下三個問題：一、開機和關機兩個階段的排放問題嚴重，廢氣中hc和co的濃度值及煙度測量值都很高；二、因點火系統和燃燒結構的缺陷而導致開機后一段時間內有油滴從滴油管滴落；三、在點火過程中，會出現因操作不當而點火失效的現象。
  5. 05. 01 test method for dropping point of lubricating grease

    潤滑脂滴點試驗方法
  6. Standard test method for dropping point of lubricating grease

    潤滑脂滴點的標準試驗方法
  7. Standard test method for dropping point of waxes

    石蠟滴點的標準試驗方法
  8. Test methods for sealing quality of anodic oxide coatings on aluminium and aluminium alloys - part 1 : dye spot test method

    鋁及鋁合金陽極氧化覆層密封質量試驗方法.第1部分:染料點滴試驗方法
  9. Methods of test for petroleum and its products - determination of drop melting point of wax and petrolatum

    石油和石油產品的試驗方法.石蠟和石蠟油滴熔點的測定
  10. This research was conducted to : ( 1 ) understand the characteristic and pattern of trickle source infiltration, ( 2 ) study mulched crop evapotraspiration for cotton and corn in a arid climate sandy loam soils. according to the researches of the dissertation, the main results are as follows : ( 1 ) the shape of wetted soil volume is influenced by soil texture, discharge rate and the total volume of applied water in case of trickle source infiltration

    本文以粘壤土為研究對象，對微源入滲特性規律進行了系統的室內試驗研究，並且對膜下滴灌大田作物棉花和玉米的需水規律進行了野外試驗，得到了以下幾點結論： （ 1 ）地表微源入滲土壤濕潤體的形狀受到土壤質地、供水強度和灌水時間的影響，一般為半個橢球體。
  11. However, the movement and transformation of n in soil under fertigation remains unclear. the methods of simulation experiment and culture experiment were used to study the movement and transformation of n in soil under fertigation by drip irrigation. the main experimental results were shown as folio wings : ( 1 ) the water infiltration under drop irrigation is a point infiltration ; and the soil moisture in vertical and horizontal directions was increased with the irrigation time, and the movement rate were decreased with the irrigation time

    本研究採用室內模擬試驗和生物培養試驗相結合的方法，研究了在滴灌施肥條件下，化學氮肥施入土壤后的遷移、轉化規律以及對作物生長的效應，獲得了以下主要結論： （ 1 ）滴灌條件下水分以點源入滲土壤，水平和垂向的濕潤鋒均隨入滲時間的增加而逐漸變大，在入滲開始階段濕潤鋒的推進速率較大，隨入滲時間的延長，濕潤鋒的推進速率逐漸變慢。
  12. The hemolymph immune reaction of american cockroach to the entomopathogenic fungus, metarhizium anisopliae isolate cqma102, which is broadly used in locust control, was studied in the research. the results will enrich our knowledge about insect immune mechanism and the insecticidal mechanism of entomofungus. they will also be the fundamental work for insecticide development

    本研究以重要的室內蜚蠊種類? ?美洲大蠊（ periplanetaamericana ）為實驗材料，採用蜚蠊的非致病菌? ?金龜子綠僵菌（ metarhiziumanisopliae ） cqma102菌株作為供試菌，較系統地研究了綠僵菌孢子進入蜚蠊體腔后（點滴和注射處理） ，蜚蠊血淋巴某些理化性質的改變、血淋巴的免疫反應以及蜚蠊的行為反應等，有助為研究昆蟲的抗病機理和生物殺蟲劑的殺蟲機理，同時也為生物殺蟲劑的開發提供了必要的基礎。
  13. Sweet pepper leaves were dripped by 14c - glucose and 14c - sucrose, the tracer experi ment indicated : exogenous sugars could be translocated to every part of plant after being absorbed by leaf, but the centralized distribution to some exuberant organs in growth such as fruit, young stem and leaf, had no relation between organ dry weight and distributive amount ; the absorptivity of 14c - glucose by leaf was higher than that of 14c - sucrose

    用含有14c標記的外源糖（葡萄糖和蔗糖）點滴青椒葉片，示蹤試驗表明：外源糖被葉片吸收后可運轉到植株的各個部位，但集中向果實，幼嫩的莖、葉等生長比較旺盛的庫性器官分配，其分配量與器官干重無關；青椒對外源葡萄糖的吸收率高於蔗糖。
  14. Standard test method for drop melting point of petroleum wax, including petrolatum

    包括凡士林在內的石油蠟滴熔點的標準試驗方法
  15. This paper reviewed the modeling and experiments of the transient phenomena involved in the various subsystems of the thermal spraying process at home and abroad, such as : effect of process on droplets behaviors, microstructure, residual stress analysis and spray materials, and based on experimental resuts to discuss the droplets thermal - transfer discipline and effects on coatings properties

    摘要從熱噴塗工藝參數對塗層形成的影響、微觀組織及殘余應力分析和噴塗材料等幾方面對國內外熱噴塗塗層形成機理的研究進展進行綜述，重點綜述了工藝參數影響液滴行為的研究，並結合試驗探討了液滴的熱傳輸規律及對塗層最終性能的影響。
  16. Insulating and sheathing materials of electric and optical cables - common test methods - part 5 - 1 : methods specific to filling compounds - drop - point - separation of oil - lower temperature brittleness - total acid number - absence of corrosive compo

    電纜和光纜用絕緣和護套材料.通用試驗方法.第5 - 1部分:填充復合物的專用方法.滴點.油分離.較低溫脆性.總酸值.無腐蝕性成分. 23 ?時的電容率. 23 ?和100 ?時的直流電阻率
  17. Common test methods for insulating and sheathing materials of electric cables. part 5 : methods specific to filling compounds. section one : drop - point - separation of oil - lower temperature brittleness - total acid number - absence of corrosive components - permittivity at 23 - d. c. resistivity at 23 and 100

    電纜絕緣和護套材料通用試驗方法第5部分:填充膏專用試驗方法第1節:滴點-油分離-低溫脆性-總酸值-腐蝕性- 23時的介電常數- 23和100時的直流電阻率
  18. Insulating and sheathing materials of electric and optical fibre cables - common test methods - methods specific to filling compounds - drop point - separation of oil - lower temperature brittleness - total acid number - absence of corrosive components - permittivity at 23 c - d. c. resistivity at 23 c and 100 c

    電纜的絕緣和護套材料.通用試驗方法.填充復合物的專用方法.滴點.油分離.低溫脆性.總酸值.無腐蝕性成分. 23時的電容率. 23和100時的直流電阻率
  19. Common test methods for insulating and sheathing materials of electric cables ; part 5 : methods specific to filling compounds ; section one : drop point ; separation of oil ; lower temperature brittleness ; total acid number ; absence of corrosive components ; permittivity at 23 ; d. c. resistivity at 23 and 100

    電纜絕緣和護套材料的通用試驗方法.第5部分:填充復合物的專用方法.第1節:滴點油分離較低溫脆性總酸值無腐蝕性成分.在23時的電容率在23和100時的直流電阻率
  20. Common test methods for insulating and sheathing materials of electric cables - part 5 : methods specific to filling compounds - section 1 : drop point - separation of oil - lower temperature brittleness - total acid number - absence of corrosive components - permittivity at 23 centigrade degrees - d. c. resistivity at 23 centigrade degrees and 100 centigrade degrees

    電纜絕緣和鎧裝材料的通用試驗方法.第5部分:填充復合物的專用方法.第1節:滴點.油分離.較低溫脆性.總酸數值.不腐蝕組分. 23下的電容率. 23和100下的直流電阻率
分享友人
分享到 Line

分享到臉書