點近似 的英文怎麼說

中文拼音 [diǎnjìnsì]
點近似 英文
point approximation
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 近 : Ⅰ形容詞1 （空間或時間距離短） near; close 2 （接近） approaching; approximately; close to 3 （親...
  • 近似 : approximate; similar; approach; approximation; roughness; propinquity
  1. Abstract : considering the second nearest - neighbor interaction and cubic, quartic anharmonic interactions simultaneously, we employ the multiple scales method combined with a quasidiscreteness approximation to calculate the lattice vibration. it is shown that the kind of nonlinear chain exhibits envelope soliton, envelope kink and envelope antikink soliton. these results can also be used to explain the experimental phenomena that the kink amplitude of the self - localized structure is determined only by the intrinsic properties of its lattices

    文摘:同時考慮次近鄰諧振相互作用和三次方、四次方非諧相互作用，利用多重尺度結合準離散近似方法去計算晶格振動行為，發現一維非線性點陣中存在包絡孤子及正扭結型包絡孤子、反扭結型包絡孤子，解釋了自局域結構的幅度只取決于點陣中的固有參數的實驗現象
  2. This type of approximation is made at a finite number of points.

    這種近似法是在有限數目的節點處來進行的。
  3. Based on the analysis of mechanism for joint region, the " frame - wall " and " aslope compression stub column " mechanical models and yielding patterns of core zone of the joints are set up. the shear load - carrying formulation for joint core zone is also given in terms of plastic ultimate analysis. and then, the comparisons between the formulas given in this paper and that of chinese design code ( draft ) and nonlinear fem as well are presented

    對節點核心區的抗剪，通過受力機理的分析，建立了鋼「框架剪力墻」加混凝土「斜壓短受力體系及其屈服機制，根據塑性極限分析，給出了節點核心區抗剪承載力計算的迭加公式， 《規程》公式和非線性有限元近似模擬分析結果進行了比較。
  4. In the course of working, ， the plow will make use of the shuttling method so that it can dig alternately either on the left or on the right. compared to the unilateral plow, it can improve the productivity because it can help leave off the soil 、 take from the consumed energy and reduce the empty journey. to meet the requests above, we will use a remote cylinder with both a small cubage and double functions, approximately designing the plow to be columniform and symmetric. after the experiment for a period in the field, we found that the most frayed areas had happened at the places of both plow shank and share and at the same time the base of the remote cylinder had ruptured suddenly

    與單向犁相比，其優點在於：耕地無開、閉壟，地表平整，降低了耕后整地的能量消耗，減少了地頭的空行程，因而大大提高班次生產率。為了滿足犁體梭式作業的要求，我們採用了一隻小容積雙作用的液壓油缸；同時對犁壁曲面的形狀採用了近似圓柱形的對稱設計。但經過一段時間的田間試驗，我們發現：該犁犁胸部分的犁脛和犁鏵上的犁尖在工作中磨損較為嚴重；主犁梁和油缸缸體的連接部分（即油缸底座）突然發生了斷裂，造成整個犁體無法正常工作。
  5. The striking fact about heron's work is his commingling of rigorous mathematics and the approximate procedures and formulas of the egyptians.

    Heron的工作突出之點是他把嚴密的數學同埃及人的近似方法和公式融合在一起。
  6. The time - frequency curve of stern scatterer is analyzed. furthermore, high quality images are obtained by identifying the regions which are uniform in frequency. chapter 4 exposits the method of optimal time selection for ship isar imaging in detail

    本章分析了船尾處特顯點的時頻分佈曲線，並選擇了時頻曲線中頻率近似不變的時間段得到艦船圖像，其成像質量有了較大的提高。
  7. Finite element method ( fem ) is an approximate solution in engineering, there exists some error in the analysis result, so it is important to check the result and to geta right view of the result in the analyzing process, then this can lead the right analysis in the next step

    摘要有限元法是一種工程近似求解的方法，存在誤差，所以在用有限元軟體進行工程分析計算時，很重要的一點是分析過程中必須審視分析的結果，對結果有正確的認識，從而指導工程分析的正確進行。
  8. Isolated points and algebraic structure of rough equality classes in approximate space

    近似空間中的孤點與粗相等類的代數結構
  9. Abstract : the effect of correction of self - consistent potential on electronic structure in simple cubic nanocrystal particles is calculated by means of the green ' s function method in the tight - binding approximation, taking only the nearest neighbor matrix elements into account. the numerical results show that the electronic energy spectrum is shifted, the chemical potential is not equal to the atomic energy level, the electronic density at each lattice point is changed, and the variation of electronic density at surface lattice point is the largest

    文摘:在緊束縛近似下，只計及最近鄰的矩陣元，採用格林函數計算了自洽勢修正對簡立方納米晶體顆粒的電子結構的影響，發現電子能譜發生了移動，化學勢不等於格點原子能級，各格點的電子密度也發生了變化，其中以表面格點的電子密度變化最大。
  10. So if you are a veteran moviegoer of hong kong cinema, you probably wouldn t find anything new or genuinely funny in this film

    和近期其他愛情喜劇有點相似的是，片中男主角仍屬弱男一族。
  11. This dissertation emphasizes on the creation of image space, the author present a display system in which screen moves with a sinusoidal velocity profile to create image space. this paper uses linear approximation to make the system display homogeneous graphic and analyzes worst - case positional error due to linear approximation

    本論文重點分析了顯示單元中成像空間的構造，提出屏幕按正弦曲線運動的方式來構造成像空間，用線性近似的方法得到均勻的圖像，並分析了由於線性近似帶來的最大屏幕位置誤差。
  12. A real rough set space and the concepts of real lower and upper approximation corresponding to real - valued attributes is studied. a rhombus neighborhood for som is proposed, and the combination of som and rough sets theory is explored in the dissertation. according to the distance between the weight of winner node and the input vector in the real rough sets space, some new weights learning rules are defined

    本文提出採用菱形鄰域代替一般的方形鄰域，可以減少待修正權重的數目;並利用實數粗糙空間的下、上近似集的精確概念劃分自組織映射的輸出結果，使得改進后的映射結果中各類樣本點之間有明顯的間隔，易於進行分類識別。
  13. A general synthesis model of mixed - point straight - line linkage in the general condition was established, and some key parameters in the equations were solved

    摘要採用解析法建立了一般情況下混合點近似直線機構綜合的通用數學模型，並給出了方程中關鍵參數的求解方法。
  14. The quantum dots are considered as pyramid shape approximately, therefore the dittraction of dots is considered as diffraction from triangle. the transverse period is obtained using the transform of fourier. the trustiness of this modal is showed through comparing with the result come from triple - axis diffraction formula and result of stm

    將量于點近似看成金字塔狀，從而量于點的衍射可以看成三角形衍射，利用三角型的傅立葉變換，求得量于點的橫向周訕，與三9m力射結果及盯m求得量于點的橫向周期一致，說明本模型的可靠性。
  15. Abstract : this paper offers a mathematical model of drilling - well layout by transforming the availablity of the original wells into 0 - 1 programming problem

    文摘:利用均勻網格對點近似覆蓋的性質，將舊井的利用問題歸結為0 - 1規劃問題，依此建立數學模型。
  16. The 4th order mathematic model of the load simulator is established and its linear form is obtained by linearizing at operating conditions. also the coefficients of the linear model are calculated and discussed, based on measured characteristics of the proportional valve

    然後採用了機理建模的方法建立了系統的四階數學模型，應用工作點近似線性化的方法，對系統進行線性化處理。
  17. Problem set 2 : continuum approximations of non - stationary random walks, random walk in a harmonic well, steps with fat tails, saddle - point asymptotics

    問題2 ：非穩定型隨機漫步的連續極限，具調合井的隨機漫步，具備巨大尾部的漫步，鞍點近似解。
  18. 2 ) systematically introduced parameter estimation of distributed sources on the base of models, including the maximum likelihood estimate, least squares estimator, dspe, dispare, etc. 3 ) studied four low complexity algorithms : one order approximation, two point sources approximation, traditional beamforming and relax of parameter estimation

    2 ）在模型基礎上系統地介紹了已有分散式目標參數估計方法，包括最大似然與最小二乘演算法， dspe和dispare演算法等。 3 ）研究了四種低復雜度演算法：一階近似演算法、兩點近似的演算法、常規波束形成演算法和relax演算法，這些演算法都是次優演算法，但計算量小，具有實用價值。
  19. The error analysis model of sampling system was set up for the first time, by combining the saddlepoint approximation analysis and numerical arithmetic, which greatly increased the potential of further application and improved the reliability of the error approximation of the optical sampling histogram

    論文首次建立了採用鞍點近似法與數值演算法相結合的取樣系統誤差分析模型，大大擴展了鞍點近似演算法的適用范圍，提高了誤碼率估算的可靠性。論文提出了基於時分取樣方法的光子模數轉換。
  20. Abstract : this paper developed time domain integral constraints on error response for siso feedback control systems caused by nominal plant ' s near cancellation of stable pole - zero near the j - axis. these integral constraints should be satisfied by any feedback control systems. these integral constraints give new insight into the inherent trade - offs. it will result in the settling time longer or the infinite norm of the error response larger when there are near cancellations of stable pole - zero near the j - axis. hence, when feedback control systems are designed, it is necessary to avoid the compensator ' s poles and zeros nearly cancelling the nominal ' s zeros and poles ( even if these poles and zeros are stable )

    文摘:導出了單輸入單輸出反饋控制系統誤差響應基於名義系統穩定的零、極點近似相消的時間域積分約束，此積分約束是任何反饋控制系統均應滿足的.這一約束給出了單輸入單輸出反饋系統固有折中的新的觀點.名義系統穩定的零、極點近似相消的存在導致反饋控制系統的調節時間延長或者誤差響應的無窮范數變大.因此，在反饋控制系統設計中，盡量避免補償器的零、極點與名義系統的極、零點近似相消（即使這些零、極點是穩定的）
分享友人
分享到 Line

分享到臉書