齒尖角 的英文怎麼說
中文拼音 [chǐjiānjiǎo]
齒尖角
英文
tool angle-
Leaves papery, oval in outline, 6 - 7cm long and 8 - 11 cm wide, base rounded or subtruncate, trilobed or sometimes 5 - lobed ; lobes triangular - ovate, rarely ovate - oblong, apex acute or acuminate, margin serrulate, with appressed acute teeth, sometimes entire near base, glabrous or with tufted hairs at vein axils abaxially ; petiole 2 - 3 cm long, glabrous
葉紙質，輪廓闊卵形，長6 - 7厘米，寬8 - 11厘米，基部圓或近截平， 3裂或有時5裂，裂片三角狀卵形，有時卵狀長圓形，頂端漸尖，邊緣有疏而銳利地鋸齒，有時近基部全緣，兩面無毛或下面脈腋有簇毛；葉柄長2 - 3厘米，無毛。The beyond is the simple notation of serial number of pricker, totaled 7 digits of codes, in which the first digit represents the diameter of needle - bar of pricker, the second digit represents the siding of triangle side on functional section of pricker, the third digit represent the length of functional section of pricker, whereas in standard notation, it represents the distance from needlepoint to gradual deflating small port ( lower port ), the fourth digit represents the total length of pricker, which is the distance from the inside of bending helve to the needlepoint, the fifth digit represents the total quantity of dents on the cording of functional section, and the sixth digit represents the model of barb on functional section, while the seventh digit represents the distance between barbs on functional section
以上為刺針編號的簡單寫法，共7位代碼，第一位是刺針針桿的直徑；第二位是刺針工作段三角面的邊寬；第三位是刺針工作段的長度，同標準寫法所不一樣的是針尖到漸縮錐小口（下口）的距離；第四位是刺針的總長度，按彎柄內側至針尖的距離；第五位是工作段棱上的總齒數；第六位是工作段上鉤刺的型號；第七位是工作段上鉤刺與鉤刺之間的距離。Witch has worked out the tooth shape of datum rack and computer simulation of gear manufacture. pointedness, undercut and tooth tip becoming sharp are analysed. tooth thickness calculation and measurement, superposition coefficient calculation and belt length calculation are resolved
2 、給出了基準齒條的齒廓形狀，進行了齒輪加工計算機模擬，分析了可能出現的稜角問題，進行了齒輪內齒頂圓的求解、根切問題分析、齒厚計算與測量、齒頂變尖的分析、重合度的計算、帶長度的計算及齒輪設計的程序編制等。
分享友人