齒帶 的英文怎麼說

中文拼音 [chǐdài]
齒帶 英文
basal ridge
  • : Ⅰ名詞1 (牙; 牙齒) tooth 2 (物體上齒形的部分) a tooth like part of anything 3 [書面語] (年齡...
  1. Leaves opposite, papery, ovate, suborbicular or elliptic, 4 - 8 cm long, apex rounded, base rounded to broadly cuneate, margin with regular and slightly sinuate teeth except base, covered with yellowish brown tufted appressed hairs ; petioles 0. 6 - 1. 5 cm long

    葉對生,紙質,圓卵形、近圓形或橢圓形,長4 - 8厘米,頂端圓形,基部圓形至寬楔形,邊緣除基部外具整齊而稍波狀的鋸,兩面被黃褐色簇狀短伏毛;葉柄長6 - 15毫米。
  2. Crawler bulldozer. bolts for drive sprocket segment

    式推土機.驅動輪塊用螺栓
  3. Keyway broach with chamfer types and dimensions

    倒角鍵槽拉刀型式與尺寸
  4. The results indicate that a stable deformation localization band occurs in the coal cutting course and develops to macroscopic crack ; the deformation localization band is slantwise ; while the cutter tooth is used, the deformation localization develops slowly, and the localization becomes wider and the strain value in the band area higher afterwards ; when the point - attack pick used the localization develops quickly and the localization band becomes narrow and the strain value in the band lower

    研究表明:截截割煤體過程中,煤體出現穩定的變形局部化,且最終發展為宏觀裂紋;煤體變形局部化為一個傾斜:刀截割時,變形局部化發展較慢,但產生變形局部化后,局部化寬且內應變值較高;而鎬截割時,變形局部化發展較快,但產生局部化后,局部化窄且內應變值不如刀高。
  5. After canvassing the basic theories and methods of reliability and optimization design of the transmission system, analyze the designs of the v - belt transmission, arc cone gear and disk spring separately. it is propitious to raise efficiency, improve capability, increase reliability, and decrease cost and so on

    在研究了機械可靠性優化設計基本理論和方法之後,分別分析了v型傳動、圓弧錐輪、液壓卡盤碟型彈簧的可靠性優化設計,對其進行針對性的研究,並通過試驗對設計結果進行檢驗。
  6. Lifting the foot onto vague terrain and using the points differently allow one to pull with crampon rather than simply push

    把腳提到一個不明情況的腳點和利用不同的點使人有時候著冰爪做牽引動作,而不只是簡單的推進。
  7. Similarly, crampons have evolved as well, allowing them to be used on these types of ice which is quite different from that for which they were traditionally used, for example : kicking straight on with the foot in order for the front points to penetrate

    同樣的,冰爪和傳統的比起來也有很大的不同,得到了發展使他們能夠用於這種地形,例如:的冰爪使垂直冰面踢冰穿透冰壁成為可能。
  8. Crawler bulldozer. nuts for track shoe and sprocket segment

    式推土機.履塊用螺母
  9. Crawler bulldozer. sprocket segment for drive

    式推土機.驅動輪
  10. Remote control gear with transmission tubing for manual operation ; crown gear units, slewable

    用手操作的傳輸管的遙控裝置.可快速旋轉的冠形
  11. Remote control gear with transmission tubing for manual operation ; protecting hoods for crown gear units, slewable

    手動傳動管的遙控傳動裝置.可回轉冠形輪裝置防護
  12. Remote control gear with transmission tubing for manual operation ; leading - trough bearings with crown gear units slewable, watertight

    手動發射管的遙控裝置.可回轉冠輪的防水的導向槽
  13. This large gear turns the small one to rotate the cylinder.

    這個大動小輪使滾筒旋轉。
  14. The wheels of the single side are same velocity through the synchronized dentiform belt

    該模型通過同步使單側的車輪等速。
  15. He suffered from awkward posture, protuberant black eyes and badly snaggled teeth, which fixed his face with a kind of devilish leer.

    他相貌醜陋,黑黑的蛤蟆眼,七扭八歪的牙,使他的臉上有一種魔鬼般的惡意。
  16. Trauma to teeth, lips, and vocal cords and exacerbation of cervical spine injuries can also occur

    也能發生牙、嘴唇、聲的損失和頸椎棘突損傷的加重。
  17. It is the first time in china to set the speed increase gears form in the new compressor and to adopt several new techniques including the condenser with oil - separator built - in, jet exhauster and electrical expansion valve used to supply liquid for the flooded evaporator in the unit

    本壓縮機在國內首次採用了增速輪的形式,冷水機組在國內內首次採用了內置油分冷凝器、引射器和電子膨脹閥對滿液式蒸發器供液等新技術。
  18. If you are looking for a natural appearance and feel after dental restorations, with minimum effects to neighbouring healthy teeth, dental implants is for you

    如果您希望修復后牙的外觀、感覺和功能與自然牙一樣。又不想給鄰近的健康牙齒帶來損傷,那麼請您考慮種植牙。種植牙是目前彌補缺失牙最先進的方法。
  19. Double - edge cutting band saw

    雙邊齒帶
  20. This paper introduces the characteristic of these two types of driving mode, compares them from aspects of mounting, operation and maintenance, then comes to the conclusion that the belt motion will lead the development of automatic door

    介紹了齒帶和螺桿兩種門傳動方式的特點,並從安裝、使用和維護的角度進行分析比較后認為,齒帶傳動是發展趨勢。
分享友人