齒頂高度 的英文怎麼說
中文拼音 [chǐdǐnggāodù]
齒頂高度
英文
outside pitch line length-
The results indicate that if the value of press stress is over certain figure, press stress and al plate ’ s thickness have little influence on sawtooth distortion for the same kind of sawtooth ; sawtooth distortion is well - regulated under static press, while it is irregular under impact press. bottom coating make great influence on bond strength of samples which can improve the value remarkably ; bonding mechanism of clad steel is mechanism of mechanical effect that sawtooth which is hooked occludes with al plate
結果表明:同種齒型,當壓應力大於一定的值時,壓應力和覆板的厚度對齒形的變化影響不大;靜壓下齒形變化比較規則,鋸齒頂端向一側彎曲成鉤狀;沖壓下齒形比較凌亂,鋸齒的頂端沒有明顯的變形;后處理對試樣的結合強度影響很大,打底試樣由於粘結層的作用,結合強度較高;機械作用機制是復合鋼板的主要復合機理,鋸齒彎曲成鉤狀和鋁板形成機械咬合。After thoroughly analyzing the influence of each pump parameters on the gear pump performance, the paper developes the criterion for optimum gear parameters, which can be utilizied in practice easily for gear manufacturing using normal involute gear hob with two - fillet type. the conclutions studied by the paper are : 1. both the addendum coefficient and the deddendum coefficient of the pump gear should be 1. 125
以目前國內普遍使用的雙圓弧頭全齒高為2 . 5倍模數漸開線標準滾刀作為泵齒輪的加工刀具,通過對齒輪加工原理的分析,提出了欲使泵齒輪參數達到最佳,泵齒輪的齒頂高系數和齒根高系數都為1 . 125 ;對變位系數的確定應考慮到泵齒輪的根切、齒頂厚、重合度以及側隙因素;泵齒輪為避免過渡曲線干涉,必然要存在根切現象。
分享友人