abrasive 中文意思是什麼

音標 [ə'breisiv]
abrasive 解釋
adj. 形容詞 1. 有磨損力的,有剝蝕作用的。
2. 引起摩擦的,招人討厭的。
n. 名詞 琢料,磨料,金剛砂。

  1. The operating latitude of zibo zhongtai abradant and abrasive tool co., ltd : abradant, abrasive tool, carborndum stick, refractory material, manufacturing the products according to the charts and samples which were provided by the consumers, jointly manufacturing some products, jointly managing and so on

    淄博中泰磨料磨具有限公司經營范圍:磨料、磨具、碳硅棒、耐火材料、並承辦來圖來樣加工、合作生產、合作經營等業務。
  2. Fahmy was transparent and subtle, convivial and abrasive.

    法赫米這個人既開朗又含蓄,善於交際而又喜歡磨人。
  3. Abrasive wear may be defined as damage to a surface by a harder material.

    磨粒磨損可定義為較硬的材料對一個表面的破壞。
  4. If the washing machine tubs were chipped or damaged, then the abrasive damage to the cuff edge was greatly increased.

    當洗衣機桶部破損時,袖口的磨損增大。
  5. The voice was tart, high, businesslike, the tone flat, midwestern, abrasive.

    他的聲音又尖又高,聽來是那麼嚴肅認真,他的口氣平淡而枯燥,是中西部美國人的口氣。
  6. Thus the type and magnitude of abrasive stresses that a fabric must withstand during use will vary with the type of garment or article.

    因此,織物在使用過程中所承受的摩擦壓力的類型和大小,將根據衣服和製品的類型而變化。
  7. The slides are first cleaned ultrasonically several times in alternate baths of trichlorethylene and acetone, and are then scrubbed with a mildly abrasive detergent.

    首先,把載片輪流放在三氯乙烯和丙酮溶液池中,用超聲清洗若干次,然後用一種中極的研磨去垢劑擦洗。
  8. Bonded abrasive products sticks technical specifications

    普通磨具磨石技術條件
  9. Abrasive grains - chemical analysis of silicon carbide

    普通磨料碳化硅化學分析方法
  10. Bonded abrasive products. disc wheel with inserted nuts

    普通磨具.螺栓緊固平形砂輪
  11. Test method for abrasion resistance of organic coatings by air blast abrasive

    鼓風磨蝕試驗測定有機塗料耐磨性能試驗方法
  12. Abrasive base paper

    砂紙原紙
  13. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine

    切勿使用任何類型的沙布,拋光粉或如酒精,汽油等溶劑進行清潔。
  14. Mc nylon boasts of fatigue - proof, anti - impact and abrasive resistance etc. it has been successfully applied on straight gear, worm wheel, bevel wheel and screw gear for 25 years

    Mc尼兼有耐疲勞抗沖擊和耐磨等性質,使其在輪應用上極受歡迎,已成功地應用在直輪蝸輪斜輪和螺旋輪上有25年的歷史。
  15. Abrasive grains - method for determining the capillarity

    研磨粒料.測定毛細管作用的方法
  16. Abrasive macrograins - determination of capillarity iso 9137 : 1990

    磨料粒度.毛細作用測定
  17. Abrasive grains. determination of capillarity

    普通磨料.毛細現象的測定
  18. Test for capillarity of abrasive grains

    磨料顆粒的毛細試驗
  19. The grinding block made of carborundum abrasive, is very hard and sharp

    磨光機磨塊採用金剛石磨料製成,硬度極高,磨削鋒利。
  20. Variation ratio of dimensional after water rinse, ultimate strength, neps and pile, tearing resistance, bursting strength, joint strength, commissure ' s swerve strength, fabric shift ( slip ), ventilate degree, elasticity ( resilient rate / deformation rate ), anti - water permeability ( hydrostatic pressure ), extension and resilience, abrasive resistance, gets wet the nature, hydroscopicity, stock ' s transverse ductility, fire resistance, antistatic

    水洗尺寸變化率(縮水) ,斷裂強力,起毛起球,撕破強力,彈子頂破強力,脹破強度接縫強力,縫口脫開程度,紗線滑移性能(滑脫) ,透氣量,彈性(回復率/變形率) ,抗滲水性(靜水壓) ,延伸及回復性,耐磨性,沾水性,吸水性,襪子橫向延伸,阻燃性能,抗靜電。
分享友人