agent concentration 中文意思是什麼

agent concentration 解釋
滅火劑濃度
  • agent : n 1 行為者,動作者;【語法】主動者。2 原因;動因;作用物,(作用)藥劑。3 代理人,代辦人;代理商...
  • concentration : n. 1. 集中。2. 【化學】提濃,蒸濃,濃縮;濃度;稠密度;【礦物】汰選,選礦,富化。3. 集中注意,專心。
  1. Different factors influencing the effect of antibiosis finishing for knitted socks are experimented ; including concentration of finishing agent, dipping temperature, dipping time, baking temperature, baking time and bath ratio

    摘要通過實驗確定整理劑濃度、浴比、浸漬溫度、浸漬時間、焙烘溫度和焙烘時間對滌棉針織襪抗菌防臭整理效果的影響。
  2. The suitable concentration of the selective agent kanamycin is 50mg. l - 1. the duration of infection and co - culture with agrobacterium influences soybean transformation evidently

    農桿菌侵染時間和共培養時間對大豆的轉化有明顯的影響,侵染時間以15min為宜,共培養時間以3d為宜。
  3. As a selectable agent, concentration of kanamycin is different with medium of buds induction. concentration of kanamycin is higher in the medium that has higher frequency of buds induction

    在不同的出芽培養基上,卡那黴素的選擇濃度也不同,出芽率越高,卡那黴素所需的濃度越高。
  4. Results mai luoning injection did not interfere with limulus agent at the 20 times diluted concentration

    結果脈絡寧注射液經20倍稀釋后對鱟試劑反應無干擾作用。
  5. Starch nanoparticles ( sn ) have been prepared with w / o starch microemulsion as microreader and epichlorohydrin as cross - linking agent. the factors affecting the preparation of sn have been investigated via the characterization of tem. the results show that the size and size distribution of sn are mainly controlled by the interfacial strength of microreactor, and the interfacial strength of microreactor is chiefly influenced by w value ( the molar ratio of water / surfactant ) and concentration of starch

    利用所得到的w o型澱粉微乳液作為微型反應器,以環氧氯丙烷為交聯劑制備出澱粉納米粒,並藉助透射電鏡的表徵研究了各制備因素的影響,研究結果表明:澱粉納米粒的粒徑及粒度分佈主要受微型反應器的界面強度控制,而影響界面強度的因素主要是r值(即水與表面活性劑的摩爾比值)及澱粉液濃度。
  6. Fe - ni alloy fiber were first prepared in a mixed solution of ferrous and nickelous salts, using kbh4 as a reducing agent. conditions, such as quantity of naoh, concentration of salts, and species of surfactants, of preparation of fe - ni alloy were studied. the result show that fe - ni alloy were soft magnetic materials and they exhibited superparamagnetization at room temperature that have been widely used in industry

    本文用液相還原法首次制備出纖維狀的fe - ni合金、球形的fe - co 、 co - ni合金、 fe - co - ni合金粉體材料,並對其性能進行了分析和測試,結果表明:這些合金粒徑小,比飽和磁化強度較大,矯頑力為零,呈現超順磁性,是非晶態的軟磁材料。
  7. Their properties have been investigated by using scanning electronic microscopy ( sem ), differential scanning calorimetry ( dsc ), x - ray diffraction ( xrd ), thermogravimetry - differential thermal analysis ( tg - dta ), infrared spectroscopic analysis ( ir ), and gas chromatography ( gc ), etc. the effects of the mulser ' s stirring rate and the emulsifier concentration on the properties of encapsulated pcms have been systematically studied, and nanopcms have been obtained by increasing the stirring rate or the emulsifier concentration. the influences of different nucleating agents on micropcm performances have also been investigated in detail to search for a suitable nucleating agent to prevent micropcms from super - cooling

    首先,系統研究了乳化機轉速和乳化劑濃度對膠囊性能的影響,並通過提高轉速或乳化劑濃度獲得相變材料納膠囊;其次,系統研究了不同成核劑對微膠囊性能的影響,找到合適的成核劑抑制了相變材料微膠囊的過冷現象;再次,詳細研究了環己烷對膠囊性能的影響,並通過添加適量環己烷提高了相變材料微膠囊及納膠囊的耐熱溫度。
  8. Our previous work identified delayed mutation occurred at target supf trna gene in plasmid transfected into cells pretreated with low concentration of alkylating agent n - methyl - n ' - nitro - n - nitrosoguanidine ( mnng )

    在收回的質粒上我們檢測到了延遲發生的、高於對照5倍以上的突變。由於w在細胞中的半壽期僅為1
  9. A series of near roundness cds nanoparticles with a particle diameter of 3 ~ 6nm have been prepared by controlling the concentration and proportion of reactants and adopting sodium hexametaphosphate as stabilizing agent. the studies demonstrate that these particles present obvious quantum size effect and an appropriate excess of cd2 + ion and hexametaphosphoric acid group polysnion are helpful to the dispersion and flame capability ' s improvement of particles. another series of near roundness monodisperse au nanoparticles with a diameter of 12. 3nm was prepared via sodium citric acid deoxidizing auric chloride acid

    利用六偏磷酸鈉作為穩定劑,通過控制反應物的濃度及比例,制備了粒徑為3 6nm 、呈近似球形的cds納米顆粒,光譜測試結果表明,顆粒具有明顯的量子尺寸效應,適當過量的cd ~ ( 2 + )離子以及六偏磷酸根聚陰離子有助於顆粒的分散並提高其發光性能;採用檸檬酸鈉還原氯金酸,制備了接近球形、平均粒徑約為12 . 3nm的單分散體系au納米顆粒;採用wessling的前驅聚合物法獲得導電聚合物ppv前驅體。
  10. The effect of different processing conditions, chitosan concentration, soaking time, baking temperature, and compounding agent on linen property are determined

    分析了殼聚糖濃度、浸漬溫度、焙烘溫度和添加助劑對亞麻染色性能的影響。
  11. Determination of copper ion concentration by conductometric titration method using chelate complextriethylenetetramine as the titration agent

    三乙烯四胺螯合電導滴定法測定常量銅離子濃度
  12. The his - tagged peacl - gfp purified from the supernatants could polymerize into green fluorescent filamentous structures with diameter, length and shape being identical to that of muscle f - actins, which could be labeled by tritc - phalloidin ( a specific agent for staining actin microfilaments ), and were identified as having a 9 nm diameter by negative staining, corresponding with that of the muscle f - actins ( 7 - 10 nm ). under polymerization conditions, his - tagged peacl - gfp polymerized with kinetics similar to those of skeleton muscle actin, that is, an obvious lag nucleation period at the beginning of polymerization and an s - like typical polymerization curve could be obtained. the critical concentration is 0. 75 umol / l near to that of chicken muscle actin ( 0. 56 umol / l ) under the same condition

    熒光標記結合熒光顯微觀察表明:從可溶性上清中純化的his - taggedpeac1 - gfp聚合形成的微絲不僅可以直接在熒光顯微鏡下觀察,也可被微絲的特異標記物鬼筆環肽所標記,而且其直徑、長度以及形態上與已知的聚合肌動蛋白熒光絲一致;電鏡負染的結果進一步證實其直徑為9nm ,與傳統微絲直徑相當( 7 ? 10nm ) ;聚合曲線有明顯的停滯期,為典型的s型聚合曲線,聚合臨界濃度為0 . 75 mol l ,這一結果與已有報道相似。
  13. The investigation showed that nanofiltration membrane with good character can be made when concentration of coating solution is 1 % - 2 %, coating time is 1 hour, concentration of cross - linking agent is 0. 5 % and cross - linking time is 5 hours

    研究表明塗層液濃度在1 2 ,浸塗時間1h ,交聯劑濃度為0 . 5 ,交聯時間5h的條件下可以得到性能較好的納濾膜。
  14. Technique and condition of developing membrane such as thickness of support layer, concentration of coating solution, coating time, ph value of coating solution, concentration of small molecular additive in coating solution, concentration of cross - linking agent, cross - linking time and composite times were studied

    對制膜工藝條件如基膜厚度、塗層液濃度、浸塗時間、塗層液ph值、塗層液中小分子添加劑的含量、交聯劑類型、交聯劑濃度、交聯時間及復合次數對納濾膜性能的影響進行了研究。
  15. Uses : used in cleaning and pickling if metal surface ; used in accelerating curing of low concentration formalin adhesives ; used in modification of starch, production of bonds and coating materials ; used as desizing agent and bleach activator ; used as an essential component of bleaching formulations for hair cosmetics

    用途:用於金屬表面的清潔和酸洗;用於加快低濃度福爾馬林粘合劑的處理過程;是生產澱粉的調節劑,並應用於粘合劑的塗料生產中;用於脫漿劑和漂白活性劑;是染發劑的基本成分這一,起脫色作用。
  16. The influences of additive, polymer concentration, profile control and flooding agent ( pfa ), gel and gel breaking liquid on the characteristics of the microbial were evaluated

    摘要採用不同微生物,研究了調驅劑中主要添加劑、聚合物濃度、調驅劑溶液、調驅劑的成膠體及破膠液時微生物性能的影響。
  17. The transformed hairy roots were detected for agropine to make sure the transformation was successful. a conclusion was reached as follows : agrobacterium rhizogenes r1601 was an ideal strain for hairy roots transformation from trichosanthes bracteata voigt which exhibited extraordinary transformation rate ( 60 % ). od600 = 0. 7 was the optimum infection concentration for the tested transforming agent, with temperature at 25, ph at 6. 0, 20min of infection and 48h of co - culture and phytohormone at 1. 0mg / l being the most favourable hairy root - inducting pattern

    通過實驗和對結果的數據分析,得出下面的結論:發根農桿菌r1601是較好的大苞栝樓發根的誘導菌株,它對預培養24h的大苞栝樓子葉外植體具有最好的轉化效率和發根誘導率( 60 ) ,最適的菌株感染濃度od _ ( 600 )為0 . 7 ,溫度27 、 ph值為6 . 0 、 20min的感染時間和48h的共培養,以及黑暗條件和1 . 0mg / l的激素最有利於發根誘導的環境條件。
  18. Development and application of a high efficiency oily sludge concentration agent

    高效含油污泥濃縮劑的研製與應用
  19. Study on reductive leaching of neutral leached residue in chloride system by high concentration acid and reductive agent at high temperature

    氯鹽體系中鋅焙砂中浸渣高溫高酸還原浸出研究
  20. The orthogonal experiment has been used to optimize the electrolyte composition and the craft parameters, with the increasing of the main salt and reducing agent concentration in the electrolyte, the electroless plating coating ’ s adhesive strength and the coverage ratio also increase ; increasing the complex agent content, the electroless plating coating ’ s adhesive strength and the coverage ratio exist the maximum value ; the electroless plating deposition rate distinctly increases when the electrolyte temperature and the ph value were increased, but the increasing of temperature and ph value affects the electrolyte ’ s stability

    採用正交實驗對鍍液成分、工藝參數進行了優化,隨著鍍液主鹽、還原劑添加量的增加,鍍層結合強度及其覆蓋面依次增強,隨著絡合劑添加量的增加,鍍層結合強度及其覆蓋面先增加然後減少,隨著鍍液溫度及其ph值的升高,化學鍍沉積速度明顯提高,但影響鍍液的穩定性。
分享友人