air cooled type 中文意思是什麼
air cooled type
解釋
空氣冷卻式-
Air cooled type granulator water cooled type granulator
風冷式造粒機 -
Air cooled type granulator
風冷式造粒機 -
Air - cooled condensation aircrew of the indoor type
室內型風冷式冷凝機組 -
Engine type : air - cooled 4 stroke ohv single cylinder
發動機類型:單杠風冷四沖程頂置氣門鉆孔敲68mm45mm -
The type selection, design thinking, and principle of air - cooled system for the first 600 mw unit at home have been expounded, the experience of errection and debugging being presented, and related recommendations being given
摘要闡述國內第一臺600mw機組直接空冷系統的選型、設計思路及其原則，介紹安裝和調試工作的經驗，並給出了相關建議。 -
Mining type flameproof supply and control units for use on systems up to 1100 v. specification for air - cooled transformers to power drilling machines
電壓可達1100v的系統用礦山型阻燃式電源和控制裝置.第4部分:鉆機供電裝置的氣冷變壓器規范 -
Frozen the wind spee air - cooled condensation aircrew of the indoor type
室內型風冷式冷凝機組 -
Conventional submersible non - clog pump motors are air - filled non - jacketed type designed to be cooled by convection heat transfer to the surrounding media
一般的潛水無堵塞泵電機是風冷、無加套結構設計，由周圍介質的對流傳熱進行冷卻。 -
We manufacture condensers and evaporator coils of fin and tube type, mini air cooled condensers ( mac ), fhp condensing units, automotive hvac systems and oem refrigeration equipments
我們生產用於壓縮器和散熱器魚鰭形和管狀的線圈，微型氣冷壓縮機（ （ mac ） ， fhp壓縮組件，自動hvac系統及貼牌製冷設備。 -
Mining type flameproof supply and control units for use on systems up to 1100 v. specification for air - cooled lighting transformer units
電壓可達1100v的系統用礦山型阻燃式電源和控制裝置.第3部分:氣冷式照明用變壓器裝置規范 -
The motor shall be of the air - filled type and shall be cooled by an internal closed loop cooling system
電機應該是風冷式，應該由內置循環冷卻系統進行冷卻。 -
The condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure
建立了空氣冷卻實驗臺，熱管的加熱方式為電加熱，工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗，得出分離式熱管有一最佳充液率，其值為45 %左右；凝結換熱系數隨著蒸汽壓力的增加略有降低，在實驗的壓力范圍內，降低了9 . 5 % ；不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分，通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱；隨著壓力的增加，不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制 -
Abstract : the condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure
文摘:建立了空氣冷卻實驗臺，熱管的加熱方式為電加熱，工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗，得出分離式熱管有一最佳充液率，其值為45 %左右；凝結換熱系數隨著蒸汽壓力的增加略有降低，在實驗的壓力范圍內，降低了9 . 5 % ；不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分，通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱；隨著壓力的增加，不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制
分享友人