alloy film 中文意思是什麼
alloy film
解釋
合金薄膜-
The replicas are made by using a thin film of fusible alloy on a stiffening platen.
復制是用附著在加強托板上的可熔合金薄膜實現的。 -
In this paper, the influence of chemical deposition cobalt film alloy subjoining rare earth film were investigated to improve deposition technology, structure and properties of cobalt soft magnetic film alloy
為改善化學沉積鈷基合金的工藝、組織結構和性能，本文進行了稀土元素介入化學沉積鈷基軟磁薄膜的研究。 -
Use low - density aluminum alloy oxide to the first, with the introduction into superior performance ; neiqiang use special vocabulary design let s hear first from the surface temperature is equipped with colour sets, enabling patients to feel comfortable ; pipeline grey colour black red light green light blue pink sea blue purple yellow note : 220 - tone models of the length of 52cm diameter listen first bamboo : 48mm film - based 30mm bell type
採用低密度的鋁合金氧化聽頭，具有優越的導音性能;內腔採用特殊的圓弧設計，且聽頭表面都配有彩色的隔溫套，能使病人使用時感到舒適;管道顏色黑色灰色紅色深藍粉紅淺藍深綠淺綠海藍紫色黃色注：型號220導音管長度52cm聽頭外圓直徑： 48mm膜型30mm鐘型 -
Electrolytic coloring technology of brownish - red thin film for cold - rolling aluminum alloy
不同潤滑條件下高純鋁冷軋織構的模擬 -
The analysis results indicate that the correlative influence factors to the technological capabilities of electronic solders include the composition and purity and chemical uniformity of solder alloy, the composition and properties of mother materials and their clean level on the surface, the surface tension of liquid state solders, the temperature and atmosphere in soldering and the activity of flux, the chemical composition and structure and properties of the surface film of melting solders, and so on
分析表明：相關的影響因素主要包括合金的組成、純度和化學均勻性；母材的成分、性質和表面的潔凈度；液態焊料的表面張力；釬焊溫度、氣氛、助焊劑的活性；液態焊料表面膜的組成、結構和性能等。 -
The other was to research new li - al solid solution alloy material and use it as anode in lithium battery. by the trace alloy component, aluminum, doping in lithium metal, it was hoped to improve the sei film stability of lithium / electrolyte interface and consequentially enhance the performances of lithium anode. meanwhile, different form the previously studied lial alloy that had very high content of aluminum, such alloy should not decrease the mass specific energy and electrochemical potential of lithium electrode
方法二:研究新型鋰鋁固溶體合金材料並將其應用於鋰二次電池中，通過微量合金成份鋁的摻雜提高鋰電極/電解質界面sei膜的穩定性，進而提高鋰負極性能;而該合金不會像以往高鋁含量的鋰鋁合金那樣降低鋰電極的質量比能量和電化學反應電勢。 -
Diamond - like carbon gradient film on ti6a14v alloy substrate have been prepared by means of plasma source ion implanted - ion beam enhanced deposition ( psii - ibed ). for potential applications as artificial joint materials and artificial cardiac valve materials, its trobological performance and hemocompatibility has also been evaluated in the present ph. d. thesis
本研究採用等離子源離子注入?離子束增強沉積技術（ psii - ibed ）制備了鈦合金基類金剛石梯度薄膜材料，對類金剛石梯度薄膜這一新型人工關節材料和人工心臟瓣膜材料的生物摩擦學性能和血液相容性進行了研究和評價，研究了摩擦磨損對材料血液相容性的影響。 -
Its specialized in producing and researching the following series of products : audience chair series, machine cabinet series ; tape base and file cabinet series : stage series, elevators and moveable chart series ; aluminum alloy box series and other products specially designed for indust and other products specially designed for industry of film and television
專業研製生產以下系列產品：觀眾席座椅系列機櫃系列磁帶庫檔案櫃系列：舞臺系列升降機移動車系列鋁合金箱系列及其它專為影視業設計的產品。 -
The friction and wear behavior of dlc gradient film on tj6a14v alloy substrate sliding against ultra - high molecular weight polyethylene was investigated by comparing with that of ti6a14v alloy against the same counterpart under the same testing conditions
研究了dlc梯度薄膜材料與uhmwpe組成的摩擦副的生物摩擦學性能，探討了摩擦磨損機理。 ti6a14v基dlc梯度薄膜材料具有較好的減摩特性和耐磨損特性。 -
C. y. fu, c. y. su, 2004, “ thin film alloy material with the design of optic reflection and semi - transmission ”, us patent, serial no. : 435540
傅正陽、蘇程裕， 2003 ， 「兼具光學反射及半穿透設計之薄膜合金材料」 ，專利申請中，日本申請案號2003 - 134135 。 -
This paper determines the technological process, bath formularizstion and experimental parameter of electroless multicomponent cobalt based soft magnetic film with rare earth elements joined such as co - ni - b - re and co - fe - b - re by the means of perpendicular experiment and regression analysis. this paper also studies the active mechanism of rare earth elements, ultrasonic irradiation and magnetic field on the plating process, chemical component, surface configuration, microstructure and properties of electroless multicomponent cobalt based soft magnetic film in the way of examining in the component, microstructure and properties of such alloy
本文採用正交實驗和回歸分析的方法，確定了稀土化學沉積co - ni - b - re 、 co - fe - b - re多元鈷基軟磁薄膜的工藝流程、鍍液配方和實驗參數，並通過對合金鍍層的成分含量測定、形貌結構分析和力學磁學性能評估，研究了稀土元素、超聲波、磁場介入化學沉積多元鈷基軟磁薄膜工藝后，對合金成分、結構和性能的作用機制。 -
This article reviewed the current status and evolution of unconventional co - deposition mechanisms in zn - based alloy, analysed various standpoints, such as film adsorption mechanism, electrochemical dynamics mechanism, not enough potential depositional mechanism, the effects of ionic. soft and rigid acidity, quantum chemical explanation and interphase effect mechanism, and compared each advantage and deficiency, respectivly ; it could be advantageous to more studies regards to unconventional co - deposition mechanisms in zn - based alloy
摘要綜述了鋅基合金異常共沉積的機理研究進展情況，通過對膜吸附機理、電化學機理、欠電勢沉積機理、離子軟硬度的影響、量子化學解釋和界面作用機理等各種不同觀點的介紹和分析，總結了各自的優勢和不足，為鋅基合金異常共沉積的機理進一步研究提供了幫助。 -
Conclusion : tialn film coating may have a good potential to increase the biocompatibility of base metal alloy substrate
結論：氮化鋁鈦薄膜具有良好且可增加卑金屬合金基材表面生物相容性的潛能。 -
However, when x is 0. 36, phase separation will occur at 800. the intense ultraviolet photoluminescence ( pl ) from mgxzn1 - xo alloy thin film was observed at room temperature. with increasing the contant of mg2 + ion in the film, the peak position is blue - shifted to higher energy side
從x射線衍射的結果中還可以看到， x = 0 . 36的合金薄膜是一種亞穩態，當熱處理溫度在800以下時它是纖鋅礦結構，而在800以上時就出現了分相。 -
The gmr effect has became a international researching hotspot after the discovery of gmr effect of fe / cr multilayers. people found that multilayers formed by ferromagnetic metal of transition family and nonmagnetic metal or by alloy film and nonmagnetic metal will take on gmr effect. the value of gmr of co / cu multilayers is the biggest which can reach 65 % under room temperature
繼fe / cr多層膜巨磁電阻效應發現以後，巨磁電阻效應已成為國際研究的熱點，人們發現過渡族鐵磁金屬或合金薄膜與非磁性金屬構成多層膜后均可呈現巨磁電阻效應，其中以co / cu多層膜的gmr值最高，室溫巨磁電阻效應可達65 % 。 -
The widely used mg alloy zm5 is chose as the original alloy. on the surface of the molten alloy, a layer of protective film with dense structure is formed by the addition of la, ce or mischmetal. the film prevents the penetration of oxygen and volatilization of mg vapor, and then prevents the zm5 alloy from oxidation and burning
針對目前廣泛應用的zm5鎂合金，通過添加稀土鑭、鈰和混合稀土，在鎂合金液面上形成一層結構緻密並且具有耐久性的保護膜，阻止氧氣的進一步侵入和鎂蒸氣的向外揮發，不再產生鎂的劇烈氧化燃燒現象。 -
Effect of energy density on composition and properties of blue ceramic decorative film on ld31 alloy by pecc
陶瓷裝飾膜層成分及性能的影響 -
The phytic acid has the function of complexing with metal. it easily forms a protection film of single molecular on the metal surface to obscure the contact of oxygen with the metal and prevent magnesium alloy from corrosion in the process of electroplating
添加劑植酸與金屬配合后，易在金屬表面形成一層緻密的單分子保護膜，能有效地阻止氧氣與金屬基體接觸，從而可以防止鎂合金基體在電鍍過程中的腐蝕。 -
By differential scanning calorimetry ( dsc ), respectively. without any supplementary method, a ti - rich alloy target ( ti - 48at % ni ) were used to enrich ti content in films during sputtering. as the first step, tini thin film is deposited on a glass substrate by sputtering, and annealed at 600
採用絲材冷軋法，制備了75 m 、 90 m兩種厚度的tini形狀記憶薄膜，示差掃描量熱（ dsc ）法測得其馬氏體逆相變峰值溫度分別為35 、 109 ，在濺射工藝中，採用富ti的tini合金靶（ ti - 48at ni ）而不是其它成分補償措施，來增加tini薄膜中的ti含量。 -
Compared with different inducing methods by lots of experiments, a simple and effective inducing method is confirmed, the opimal technological conditions and formula about the soluton of electroless deposition ni - p alloy are also obtaned. the influence of different technological parameters on the deposition rate is studied. analyzed the pefformance of ni - p alloy on the differen substfates and its corresponding tricture, the result is shown tha the electroless plating nickel process can obtained the ni - p alloy film having brightuess - integrity sdse, strong binding energy and high rigidity at the temperatur about 350wt00oc, the electroless plating nickel film would trallsform from amorphous to crystal state
本文通過大量實驗，對幾種誘發材料與過程進行分析，研究確定了簡便有效的誘發方法，以及與之相匹配的化學鍍ni - p合金溶液優化配方和工藝條件，討論了各工藝參數對鍍速的影響，並對銅及黃銅基體上得到的ni - p沉積層進行了性能和結構分析，得到外觀光亮完整、結合力強、硬度高的鍍層。
分享友人