amorphous content 中文意思是什麼

amorphous content 解釋
非晶區含量
  • amorphous : 玻璃態的
  • content : n 1 容積,容量,含量,【數學】容度;收容量。2 【哲學】內容 (opp form);要旨,真意。3 〈pl 〉內...
  1. A reasonable mechanism of the concentric ring like patterns on the surface of phbv spherulite was given first. the segregation of hv content between cystal and amorphous parts was observed and the phenomena caused were discussed

    首次對phbv球晶表面觀察到的同心圓環條紋的成因作了合理解釋,揭開了這一現象形成的本質。
  2. The results indicate that ( a ) before heat treatment, with the increasing of substrate temperatures, content of lower valency ( tij + ) decreases, the stoichiometric proportion of o / ti in all samples is about 2 ; the films have amorphous incompact columnar fiber structure, and with the increasing of substrate temperature, the size of columnar fiber increases ; the films have good hyalescence in visible range and great absorbability at the wavelength of 350nm ; optical constants of the films are calculated from the transmittance spectrums in visible range by mathematical analysis of the orders of interference, the results show that the refractive ind

    研究結果表明, ( a )熱處理前,隨著基片溫度的增加,薄膜中的低價氧化鈦含量逐漸減少,化學計量比趨于o ti = 2 ;薄膜具有非晶態不緻密的柱狀纖維結構,柱狀纖維的尺寸隨基片溫度的升高而增加;薄膜在可見光范圍內透明,在波長為35onzn時嚴重吸收,利用干涉級次法分析了薄膜的光學常數,結果表明,薄膜的折射率隨基片溫度的升高而增加,根據計算結果得到了tioz薄膜在不同基片溫度下的折射率色散曲線。
  3. The result shows that with the addition of rare earth elements, ultrasonic irradiation and magnetic field, the chemical component, surface configuration, microstructure and properties of electroless co - ni - b and co - fe - b alloy changes remarkably. such kind of change can be described as the followings. firstly the depositing speed of electroless alloy bath is raised while the polarizability and cathodic overpotential are reduced ; secondly the surface quality of the alloy coating and adhesion of the coating and matrix are improved ; thirdly in the coatings the content of the elements in the transient group increases, but the content of cobalt decreased ; fourthly the amorphous structure is transformed to microcrystal structure and polycrystal structure ; fifthly the microhardness and wear resistance of the coating are enhanced ; sixthly coercitive force is reduced, and magnetoconductivity of the coating is increased ; lastly the magnetic intensity of the coating increases with the addition of energy and light rare earth elements such as ce, la and decreases with the addition of heavy rare earth elements such as y. on the other side, when the alloy coatings passes through the heat treatment under the temperature of 250 or 500, their properties will change

    結果顯示化學沉積co - ni - b 、 co - fe - b工藝在稀土元素( ce 、 la 、 y 、 dy ) 、能量(超聲波、磁場)介入后,沉積過程、合金成分、鍍層形貌結構和性能都有顯著變化,表現在:鍍液的陰極極化過電位和極化度降低,沉積速度提高;鍍層的結合力、表面質量改善;鍍層中過渡族元素的含量增加,輕元素硼的含量降低,同時證實了稀土元素與過渡族元素共沉積的可能性;鍍層的顯微結構由非晶態向微晶和多晶態轉變;鍍層的顯微硬度與耐磨性提高,力學性能優化;鍍層的矯頑力降低;磁導率提高;鍍層的磁化強度在能量(超聲波、磁場)和輕稀土元素ce 、 la介入后提高,重稀土元素y介入后降低。
  4. The influence of depositing condition on the depositing rate and the structure of the films were studied by the aid of tem and xrd. when the temperature ( ts < 450, ta < 800 ) is low, the structure of the samples is still amorphous. the majority content of the sample is sio 90 by the aid of xps

    利用雙離子束濺射沉積技術,通過共濺射方法制備了si - sio _ 2薄膜,研究了沉積時間、工作氣壓p _ ( ar ) 、基片溫度等對沉積速率的影響,用tem和xrd分析了樣品的結構。
  5. With plating time going on, the nano - polycrystal gathering grows in two dimensions, and the new nano - polycrystal layer appears simultaneously on the formerly formed nano - polycrystal surface. because the boundary and defect densities in quenched and tempered 45 steel is higher than those in annealed steel, the nano - polycrystal gatherings formed at its surface at the beginning of electro - deposition are more concentrated, and then their size is smaller. the microstructure of the ni - p alloy coating has closed relation with its phosphorus content with the increase of phosphorus content, the microstructure of coating turns from nano - crystalline to the amorphous

    隨著施鍍時間的延長,納米晶聚晶體在橫向二維生長的同時,在納米晶聚晶體的表面上也進行著三維方向的新的一層聚晶體的生長;在調質態45鋼表面,由於其具有比較高的晶界和缺陷密度,因此在沉積初期,納米晶聚晶體的成核密度也較大,從而在二維方向聚晶體的尺度較小,鍍層沉積初期表現為緻密細小的鱗片狀組織。
  6. The fourier transform infrared ( ftir ) spectrum is an effective technology for studying the hydrogen content ( ch ) and the silicon - hydrogen bonding configuration ( si - hn ) of hudrogenated amorphous silicon ( a - si : h ) films. in the paper, ch and si - hn of a - si : h films, fabricated at different ratio of h2 / sih4 by microwave electron cyclotron resonance plasma chemical vapor ( wmecr cvd ) method, have been obtained by analyzing their ftir spectra that are treated by baseline fitting and gaussian function fitting. the effects of ratio of h2 / sih4 on ch and si - hn are studied

    Fourier紅外透射( ftir )譜是研究氫化非晶硅( a - si : h )薄膜中氫含量( c _ h )及硅-氫鍵合模式( si - h _ n )最有效的手段,對于微波等離子體化學氣相沉積( mwecrcvd )方法在不同h _ 2 sih _ 4稀釋比下制備出的氫化非晶硅薄膜,我們通過紅外透射光譜的基線擬合、高斯擬合分析,得出了薄膜中的氫含量,硅氫鍵合方式及其組分,並分析了這些參數隨h _ 2 sih _ 4稀釋比變化的規律。
  7. Abstract : the influence of re - addition way and sintering temperature on such physical and chemical characteristics as the ability of enameling glaze has been investigated in this paper. and the research has shown that the structure of glaze will be transformed from amorphous state into crystalline state and the grains will be refined while the sintering temperature and re content are increased

    文摘:本文研究了在瓷釉中加入稀土的方式、燒結溫度對瓷釉的塗搪性等物理性能以及化學性能的影響,並發現,隨著燒結溫度和稀土含量的增加,瓷層結構由非晶態向晶態轉變,晶粒細化。
  8. The formation process and mechanism are investigated : the adding of n ( ch2ch2oh ) 3 promoted the dissociation of cf3cooh in the starting solution and some non - volatile, fluorine containing intermediates can be remained after tray - drying of the solution. during the following heat - treatment process, the intermediates decomposed and further react with the rest amorphous calcium phosphate, leading to the final formation of fha or fa phase. the fluorine content in the fha phase obtained could be tailored by the content of cf3cooh added.

    發現cf _ 3cooh只有在加入n ( ch _ 2ch _ 2oh ) _ 3的條件下才能形成fha相和fa相,其機理是:在溶液中加入n ( ch _ 2ch _ 2oh ) _ 3能夠促進溶液中cf _ 3cooh的離解,形成無揮發性的含氟過渡化合物,溶液快速乾燥后的中間產物中仍能保留過渡性的含氟化合物,在隨后的熱處理過程中,過渡化合物分解並與非晶態的鈣磷酸鹽反應最終生成fha相或fa相。
分享友人