amplitude-noise 中文意思是什麼
amplitude-noise
解釋
幅度雜音-
Noise immunity is the maximum amplitude of noise.
抗擾度是最大的噪聲幅值。 -
In designing analogic circuit, we adopt programmable filter max262 to meet the system ' s command. after the step, we can make the signal ' s frequency width is wider and noise level is lower. to make the signal ' s amplitude to meet the analogic to digital device ' s command, we adopt the max551 to finish the gain control
在模擬電路部分，採用可編程濾波器max262 ，這樣就滿足了該數據採集裝置所採集的信號的頻率范圍較寬以及具有較低的噪聲水平的要求，為了使采樣到的信號的幅度滿足後面a d轉換器的要求，採用max551對采樣到的信號進行調理（增益控制） 。 -
Thirdly, a unified colored - noise approximation is applied to calculate the steady state distributions of the dispersive optical bistability when the fluctuations in the amplitude and phase of the incident field are considered as colored noise
色散光學雙穩系統是本文研究的第三種光學模型。當入射光中的強度漲落和位相漲落分別看作色噪聲時，我們用統一色噪聲近似得到它們的定態強度分佈。 -
The major job is manufactured a transmitter, which has three upmixer channels. its function is to up convert the signals from c - band to ka - band. the input local oscillator is provided by a low frequency crystal oscillator which has a good performance of phase noise, through 512 times multiply to ka band. this sysetem is used in the laboratory as transmitter source of the fuze, for the multidimensional objects in practise, which lead to the complexity of the reflect signal, so the amplitude, frequency and the phase of the transmit signals both have a key role in dealing with the reflection signals. therefore, this system requires for both the coherence of the single channel ’ s amplitude, phase and multi channels
本文的主要工作是應用戶要求製作一具有三發射通道的上變頻系統，可以將c波段的微波信號上變頻到ka波段的毫米波信號。系統的本振輸入基頻由一相位噪聲非常好的低頻率晶振提供，經過512次的倍頻放大至ka波段。本系統作為實驗室中引信的發射源，由於目標反射信號具有時變的多維性，反射信號變得極為復雜，在信號處理時，不僅信號幅值、頻率有決定意義而且相位關系也很有決定意義。 -
Traditional static crosstalk identification methods identify crosstalk targets only using coupling capacitance and noise amplitude information, which lead to the pessimistic results and induce a long time to ic design convergence
摘要傳統的靜態串擾噪聲識別演算法只驗證耦合電容和噪聲幅值信息，沒有考慮噪聲寬度對電路邏輯功能的影響，所以給出的結果過于保守，導致設計收斂的時間被延長。 -
To suppress the clutter, noise and detect target, we adopt several advanced sp methods such as pulse compression, mti, mtd, cfar, amplitude - comparison angle measurement and ambiguity resolution, of which we emphase the algorithms of cfar and ambiguity resolution. two cfar algorithms, cell - averaging cfar ( ca - cfar ) and ordered
為了抑制雜波、噪聲和檢測目標，採用了脈沖壓縮、動目標顯示、動目標檢測、恆虛警、單脈沖比幅測角和解模糊等較先進的雷達信號處理技術，並採用了多模式分通道處理方式。 -
The clues and techniques to improve the resolution of data processing are 1 ) removing the affection of near surface factors on data acquisition, including static correction and noise eliminating technique etc, 2 ) broadening the frequency band of pre - stack seismic data, including amplitude compensation and pre - stack deconvolution etc, 3 ) improving s / n ratio of high frequency and weak reflection signals through multiple coverage with high precision velocity analysis, residual static correction and high - order nmo, raising " dead line of high frequency reflection ", and 4 ) identifying post stack effective reflection frequency band, enhancing dominant frequency and so on
主要包括：消除近地表因素對資料採集的影響，包括靜校正和噪音壓制技術等；疊前拓寬地震資料領帶，包括振幅補償和疊前反褶積技術等；藉助高精度速度分析、剩餘靜校正和高次項nmo技術，通過多次覆蓋疊加，消除資料中隨機噪聲干擾、提高資料信噪比，尤其是高頻端反射信息的信噪比，改善高頻反射和弱反射信號信噪比，提高「高頻反射死亡線」 ；疊後有限反射頗帶識別、抬高優勢頻率等。 -
After analyzed the basic principle of optimized noise reduction on tyre pattern, summarized three approaches to noise reduction. the first is trying to reduce size of single block or socket to reduce noise amplitude on time domain, the second is to adjust stripes sorting order and their interlace value to avoid noise - made by every single block - peak values on time domain overlayed and the last is to adjust ratio of blocks and sockets, ratio of stripe interval and stripe sorting order to avoid noise periodical distribution and abnormal high peak values in some frequency strip
論文第四章分析了輪胎花紋優化降噪的基本原理，總結出三條降噪途徑：在允許范圍內盡量減小單個塊或槽的大小、刻刀槽軟化花紋塊來減小噪聲時域波幅度；調整節距排列順序、花紋條之間的錯位值，使各發聲單元發出的聲壓時域波形的同向峰值錯開，避免同向峰值疊加；調整花紋塊和槽比例、節距比例、節距排列順序，盡量避免周期性分佈，使輪胎所發出的噪聲趨于白噪化，避免某些頻段的異常高峰值。 -
Then by the method of computer simulation, the following jamming patterns are made quantitative analysis, radio - frequency noise jamming, continuous single tune jamming, continuous noise amplitude - modulated jamming, relayed frequency shift jamming, and the key factor which affect the quality of these jamming patterns
然後在此基礎上，通過計算機模擬分析，定量地討論了射頻噪聲干擾、連續正弦波干擾、轉發移頻脈沖干擾以及影響它們干擾品質的因素，並以壓制系數為衡量標準，進行了干擾效能分析。 -
Because the noise that affects radio signals is partly, but not completely, manifested in amplitude variations, wideband fm receivers are inherently less sensitive to noise
因為影響到無線電信號的噪音只是部分的，而不是整體出現于波幅變化中，調頻寬頻的接收器自身對噪音不夠敏感。 -
Simultatly, based on the vaviaction of seismic signal - noise ratio, the anthor use the funtion singular method in the seismic data procesy and put forward the wavelet amplitude singular exponentid method and the wavelet power spectrum singular exponential for the fractued density detection
與此同時，將函數奇異性分析的思想引到地震信號處理中來，針對地震信號信噪比的高低，提出小波振幅奇異性指數法和小波功率譜奇異性指數法的裂縫密度檢測方法。 -
The content of this paper consis of noise attenuation, amplitude compsation, deconvolution and retraced processing flows etc. this theme will illustrate some aimed processing in practice
處理攻關實例:渤海灣a區塊，館陶以下為200一900米的火成巖沉積，由於火成巖的屏蔽作用，長期以來，火成巖以下地層得不到好的反射。 -
We modulate the amplitude of the continuous single tune jamming by noise and produce the continuous noise - modulated jamming. this kind of jamming is effective to pc radar including linear frequency - modulated radar and bi - phase coded radar
在對單頻正弦波進行噪聲調幅后形成的噪聲調幅干擾對線性調頻雷達和二相編碼雷達都是有效干擾，其干擾特性和射頻噪聲干擾類似。 -
Smooth order amplitude variance was expressed by using state equation, and measurement error and noise were expressed by adopting observed equation
狀態方程表示了階比幅值的平滑變化，觀測方程表示了測量誤差和噪聲。 -
The reasons focusing only on ray travel times are " noise tolerance could be enhanced and the sensitivity to the environment model mismatch may be reduced by neglecting amplitude information ; phase ambiguity is eliminated by employing the group delay of arriving wave packets ; travel times are pseudo - linear functions of sound speed profiles of the medium, and the perturbation of ray travel time is much smaller than sound pressure ' s
之所以選擇聲傳播時間的原因是：噪聲容限可以得到提高，並且傳播時間的計算可以不考慮聲壓的信息，從而降低了對環境模型失配的敏感性；相位的起伏也可通過到達包絡的群延時來消除；傳播時間是介質聲速分佈的偽線性函數並且傳播時間的起伏遠小於聲壓的起伏。 -
Fiber lasers are very sensitive to environmental perturbations such as temperature fluctuations and mechanical vibrations due to their relatively long cavity length when the external environment changing. the cavity drifting produceing the phase noise and amplitude noise, this can cause the output pulse unstablely
但由於主動鎖模光纖激光器腔內有較長的光纖，而光纖的長度極易因外界環境的影響而發生漂移，因而調制頻率和腔長很難保持匹配。 -
In order to analyze the rotation noise further, a new method for measuring the amplitude and phase of each harmonic component of periodic signal mixtures is established based on the morlet transform and fourier transform in theory, which will provide scientific warranty for reducing noise of disk mill
為了進一步分析爪式粉碎機的旋轉噪聲，理論上利用morlet小波變換結合fourier變換對旋轉噪聲各次諧波成分的振幅和初相位的提取，作了初步探討。 -
Ds signal is twice modulated with the rapid pseudorandom noise sequence and the carrier. so it appears cyclostationary. in the field of spectral correlation, ds signals appears its characteristic as fallows : for the amplitude of spectral correlation, the information of carrier frequency and pn code rate are contained on the spectrum frequency equal to zero sheet, and also the pn code rate is contained on the sheet of spectrum frequency equal to carrier frequency ; for the phase of spectral correlation, the information of carrier initial phase is contained on the sheet of cyclic frequency equal to double carrier frequency
Ds信號是經過高速偽隨機序列和正弦載波二次調制的寬帶信號，因此具有周期平穩特性，它在譜相關域表現為:幅頻特性在譜頻率等於零截面切片上包含了載頻和偽碼速率信息特徵，在譜頻率等於載頻截面切片上包含了偽碼速率信息特徵;相頻特性在循環頻率等於兩倍載頻截面切片上包含了載波初相信息特徵。 -
Rc and other relaxation oscillators just will not do since amplitude noise in whatever circuit functions as a comparator will appear as phase noise on the output signal
Rc諧振器以及其它一些張弛振蕩器不能滿足要求，這是因為它們的核心是電壓比較器，需要利用電壓信號的波動（噪聲）來獲得穩定的輸出，這種波動就構成了時鐘的抖動。 -
First please make sure the useful signal has very good snr before you input it to amplifiers chain, then you can calculate how much gain and nf you need to get the targeted signal amplitude and noise level, based on this you can choose the right components to design amplifiers chain
后才將其輸入放大器鏈，接著計算獲得目標信號振幅和噪聲水平所需的增益與nf的大小，最後根據這些數據選擇合適的器件設計放大器鏈路。
分享友人