aqueous solution polymerization 中文意思是什麼

aqueous solution polymerization 解釋
水溶液聚合
  • aqueous : adj. 1. 水的；水樣的；水多的。2. 水成的。
  • solution : n. 1. 溶解；溶液，溶體，溶劑。2. （補輪胎用的）橡膠水；〈美國〉藥水。3. 解決，解答 （of; for; to）; 解釋；（數學等的）解法，解式。4. 免除，解除。5. 【醫學】消散，消退。
  • polymerization : 聚合酌
  1. Section one : preparation of polyacrylic acid / montmorillonite ( paa / mmt ) water absorbent hybrids by aqueous solution intercalated polymerization as montmorillonite is easily dispersed in water uniformly, the polyacrylic acid / montmorillonite ( paa / mmt ) was prepared by simple aqueous solution intercalated polymerization

    並利用紅外（ ft - ir ） 、 x ?射線衍射（ xrd ）對產品進行了表徵，結果證明此材料為嵌入型插層復合物。
  2. The study conducted research on the following four fields : firstly, the characteristics of the interfacial polymerization system of piperazine aqueous solution / trimesoyl hexane solution were systematically investigated. the results show that at a certain molar ratio between the two monomers, piperazine and trimesoyl, at the two phase interface, a dense functional layer of ultra low pressure, high permeating flux and high salt rejection formed by controlling the time of interfacial polymerization, such as the composite membrane ( i ), the concentration in water phase is 0. 4 %, and 0. 1 % in organic phase, and the polymerization time is 1 minute

    本文主要進行了四個方面的研究，首先系統分析和研究了哌嗪水溶液均苯三甲酰氯正己烷溶液界面聚合體系特徵、界面聚合反應中各影響因素對膜性能的影響等，結果發現，當界面處兩相單體（哌嗪和酰氯）分子摩爾比為某一比值時，通過控制界面聚合時間（有機相處理時間） ，可以形成超低壓高通量高脫鹽的緻密功能層，如復合膜（ ） ，水相濃度為0 . 4 ，有機相濃度為0 . 1 ，聚合時間1min 。
  3. The results indicated that montmorillonite was intercalated by polyacrylic acid molecular. section two : preparation of polyacrylic acid / acrylamide / montmorillonite ( paa / am / mmt ) water absorbent hybrid by aqueous solution intercalated polymerization high water absorbent polyacrylate copolymer was prepared by aqueous solution intercalated copolymerization. in this reaction, the monomers were the partially neutralized acrylic acid ( aa ) and acryl amide ( am ) ; the cross - linking agent was diacryl ethylene ( egda )

    第二節溶液插層共聚制備聚丙烯酸鹽/丙烯酰胺/膨潤土雜化吸水材料及其性能研究首次利用溶液插層共聚制備了二丙烯酰基乙二醇酯（ egda ）交聯的聚丙烯酸鹽/丙烯酰胺/膨潤土（ paa / am / mmt ）雜化吸水材料。
  4. After interfacial polymerization, the module was filled with a 10 % ( wt. % ) aqueous trimethylamine solution and kept for 24 hours to convert the chloromethylated groups into cationic quaternary ammonium groups

    當界面聚合反應完成後，將膜浸入濃度為10的三甲胺溶液鄭州大學碩士學位論文中，通過化學修飾將其氯甲基基團轉化成陽離子季胺鹽基團。
  5. Performance and synthesis methods of perfluoroalkyl vinyl ether, non - aqueous solution polymerization and aqueous solution polymerization processes of tetrafluoroethylene - perfluoroalkyl vinyl ether copolymer are reviewed. polymerization methods of ethylene - tetrafluoroethylene copolymer are introduced

    摘要介紹了全氟代烷基乙烯基醚的物性和合成方法；敘述了四氟乙烯與全氟代烷基乙烯基醚共聚物非水溶液、水溶液聚合工藝。介紹了乙烯四氟乙烯共聚物的聚合方法。
  6. In this paper, the copolymer of am 、 aa and amptac was synthesized in aqueous solution through radical polymerization. its function as water shut off agent was studied, comparing that of anionic polyacrylamide

    以丙烯酰胺、丙烯酸和2 -丙烯酰亞胺基- 2 -甲基丙基三甲基氯化銨為原料，以水作溶劑，選用氧化-還原引發體系，合成了一種新型兩性聚合物堵水劑，並與陰離子聚丙烯酰胺對比評價了其堵水性能。
分享友人
分享到 Line

分享到臉書