ar-sintering 中文意思是什麼

ar-sintering 解釋
氬氣保護燒結
  • ar : 1 account receivable 應收賬。2 annual return 年度報告。3 all risks 【保險】綜合險。4 〈拉丁語〉 a...
  1. Sintering time ranges from 3 to 10 hours, and sintering temperature ranges from 160ctc to 1900 ?, under an ar. protection of 1. 0 atm

    在1 . 0atm的ar氣保護下進行燒結，選用的燒結時間從3小時到10小時，燒結溫度由1600到1900 。
  2. It is found that we can more easily obtain the good behavior material under the conditions of 600 sintering temperature 、 ar / h2 inertia atmosphere, after testing the influence of the different sintering temperature and inertia atmosphere during the reactions to the performance of lifepo4

    通過測試不同合成溫度和不同的焙燒氣氛條件對磷酸亞鐵鋰性能的影響，得出結論:採用600合成溫度、在ar / h2混合氣體保護下更有利於合成性能良好的磷酸亞鐵鋰。
  3. Based on analyzing sintering and infiltration processes, the effect of infiltration temperature on microstructure and properties of the material was studied when the ratio of w - cr, the porosity of green compact and the sintering process of w - cr skeleton were fixed. the differences of microstructure and properties of the composites with different composition were investigated by same sintering and infiltration processes. the composites were prepared in h2, n2, ar and vacuum conditions respectively

    基於對wcr cu復合材料的燒結和熔滲過程的分析，研究了cr - w配比、壓坯緊實率、骨架燒結工藝相同的情況下，不同熔滲溫度對材料的組織形貌和性能的影響；研究了燒結-熔滲工藝相同的情況下，不同配比對材料組織和性能的影響；研究了h _ 2 、 n _ 2 、 ar和真空四種燒結氣氛下材料組織和性能的變化。
  4. To micrometer sic powder, pressed compacts were made under 750 mpa pressure with sintering time ranging from 4 to 7h and sintering temperature ranging from 1600 to 1800 @, but to nanometer sic powder, pressed compacts are made under1000 mpa pressure with sintering temperature being 1600 ? and sintering time ranging from 4 to 5h. howerver, all compacts were sintered under an ar protection of 1. 0 atm pressure

    對于微米粉末，壓坯在750mpa壓力下壓製成型，燒結溫度為1600 1800 ，燒結時間為4 7h ；而對于納米碳化硅粉末，壓坯在1000mpa壓力下壓製成型，燒結溫度為1600 ，燒結時間為4 5h ，所有壓坯都在1 . 0atm的ar
分享友人
分享到 Line

分享到臉書