auto abstract 中文意思是什麼

auto abstract 解釋
自動抄錄
  • auto : n. (pl. autos) 〈美口〉汽車。vi. 坐汽車。
  • abstract : adj 1 抽象的 (opp concrete); 理論上的 (opp applied); 觀念的,空想的 (opp practical)。2 難解...
  1. Abstract : based on the electronic focus technology development of state - of - the - art, the paper suggested a complete apparatus s cheme ofauto - focus based on sspd ( self - scanned photodiode array ) and 8098 singl e chipprocessor, giving out a focus criterion algorithm based on image high freq uencystatistics. the function of auto - focus of both reflected and transparent o pticalmicroscope was realized. meanwhile some corresponding problems such as sta bility of lightsource, step motor driving etc. were also discussed, which greatly improved the accuracy andreliability of the system

    文摘:在介紹與分析了國內外電子調焦系統的技術發展與現狀的基礎上,提出了一種基於sspd (自掃描光電二極體列陣)與8098單片微處理器自動調焦的整體技術方案,給出了基於圖像高頻成分統計的聚焦判識演算法,在此基礎上實現了反射式與透射式光學顯微鏡的自動調焦,同時對系統的可靠性有關的其它相關問題如光源穩定性、步進電機驅動等問題也進行了討論。
  2. Abstract : this paper introduces a sort of automobile thermometer testing system using plc. the system has overcome the disadvantages of the traditional methods and realized the auto - testing of the automobile thermometer

    文摘:提出了一種基於plc的汽車發動機水溫表壽命檢測系統,克服了傳統檢測方法的諸多缺點,實現了水溫表檢測的自動化操作。
  3. Abstract : the air / fuel ratio control scheme in common use of boiler auto - burning system is introduced summary. two kinds of scheme improved to obtain the best air / fuel ratio and to raise dynamic characteristic are analyzed in particular. further how to correct measures on air / fuel ratio when changing boiler load and fuel composition is proposed and analyzed

    文摘:對鍋爐自動燃燒系統中空氣/燃料比控制的常用方案進行了簡要介紹,著重分析了兩種為獲取最佳空氣/燃料比和提高控制系統動態特性而採取的改進方案,並針對鍋爐負荷變化和燃料特性改變對燃燒狀況的影響,進一步對空氣/燃料比的修正措施進行了分析與探討,提出了綜合修正方案。
  4. Abstract : the auto electric top window is mainly divided into crescent glasses, overshadow, driving motor, gear, sliding screw , ecu and relay. thi s paper analyses the working principle of opening, closing, oblique rise and fall an d the control process of electric control system are introduced

    文摘:汽車電動車頂(天窗)主要由月牙形玻璃、遮陽板、驅動電動機及齒輪、滑動螺桿、 ecu及繼電器等組成,分析了車頂玻璃打開、關閉、斜升、斜降等動作的工作原理,介紹了電子控制系統的控制過程。
  5. Abstract : according to the deformation or fracture caused by uneven loads on the structural connection, the smart structure with sensible and regulative functions has been proposed to be used in bolt groups. the smart structure is constituted with the auto - even - load connecting component made of the shape memory alloy material. the mechanical behavior of the auto - even - load component in the bolt groups is analyszed. its auto - even - load and the regulative principle to prevent the fracture are also studied

    文摘:本文針對結構聯接受力不均易產生變形或破裂等問題,提出了在螺栓組中加裝由形狀記憶合金材料製作的自動均載傳力件構成具有感知和調節功能的智能結構,並對螺栓組聯接加裝均載傳力件后的均載防斷功能進行了力學特性分析,特別是對螺栓組傳力件自動均載和防斷的調節原理進行了研究,最後進行了實驗驗證。
  6. Abstract : this paper introduces the application of the single plate computer on the intell igent - controlled cooling system of the auto engines and its working principles are expounded

    文摘:介紹了單片機在汽車發動機智能控製冷卻系統中的應用,並闡述了智能控制的工作原理。
  7. Abstract : introduced the design, function and feature of the system about fire auto - alarm and fire fighting blocking, using computer intelligence technology, it was built up at the distribution message and control theory

    文摘:介紹了建立在分散式信息與控制理論基礎上的計算機智能化火災報警及消防聯動系統的設計、功能及特點。
  8. Abstract : according to analysing on the feature of auto - parts sell computer - aided management system, a computer - aided management system for auto - parts sell is set up

    文摘:根據汽車配件銷售的特點和要求,對建立計算機輔助管理系統進行了設計分析,形成了汽車配件銷售的計算機輔助管理系統.該系統在實用中獲得滿意效果
  9. Abstract : this paper introduces a way to measure the wear mosa ic content of lubrication oil in auto transmission system gear device by a new type of magnetic resistance sensor, the wear degree of gear device in transmissio n system can be monitored in this way

    文摘:論述了通過一種新型磁阻式傳感器測量汽車傳動系統齒輪裝置潤滑油中的磨損顆粒含量的方法,以達到在線監測傳動系統齒輪裝置磨損程度的目的。
  10. Abstract : the working principle, parameter calculation and software design of fault diagnosis of abs wheel - speed sensor for auto are introduced in this paper. the circuit design is tested to be correct and meet the design requirements

    文摘:介紹汽車abs輪速傳感器故障診斷電路的工作原理、參數計算和軟體設計,經實車模擬故障檢驗,證明該電路設計正確,達到了設計的要求。
  11. Abstract : this chapter discusses the main problems of the cd - ni battery operating in substation , and introduces the technique project of microcomputer auto - charge and discharge , and illuminates its applying foreground

    文摘:本文討論了變電所中鎘鎳電池在運行中存在的主要問題,介紹了採用微電腦自動充放電技術方案,說明了該技術的推廣前景。
  12. Abstract : the deicing performance of auto air condition is very important for driving and traffic safety. this paper discusses the application of the cfd method in our automobile in deicing simulation, and introduces how we modify the deicing duct and get a good result

    摘要:汽車空調除霜性能對汽車駕駛和交通安全非常重要,本文利用cfd方法對某型汽車的除霜性能進行了分析,並對除霜風道進行了改進,最終得到了滿足設計要求的除霜系統。
  13. Abstract : this article touches on the changes on auto - control lines to start electrical motors using compensators, which reduces losses due to short - circuit during start - up and improves economic benefits

    文摘:本文介紹用補償器起動電機的自動控制線路的改造,減少電機因起動短路造成損失,提高經濟效益。
  14. Abstract : electricity meters auto - transcription system are developed for improving the electric power measure devices and power consumption management

    文摘:為提高電能計量儀表裝置水平和用電管理服務水平,需研製電能表自動抄表系統。
  15. Abstract : aimming at the common accident of microcomputer detecting control system, this thesis presents several effective ways of software antijamming, and researches on improper system reset and system auto - resume

    文摘:針對微機測控系統常見的干擾故障,介紹了幾種有效的軟體抗干擾方法,並對非正常復位、系統故障自恢復等問題進行了研究
  16. Abstract : through a series of experiments, methods for design of non - auto high voltage calibration of the goniometer detector of arl 8680 x - ray fluorescence spectrometer were proposed

    文摘:通過實驗,介紹如何設計x熒光光譜儀中測角儀檢測器的非自動高壓校正的方法。
  17. Abstract : the three - way emission control technology and the principle of auto exhaust cat alytic converter are introduced. this article indicates some new requires in the auto materials and manufacture techniques after using catalytic converter

    文摘:介紹了汽車尾氣三元催化凈化技術及凈化器的主要工作原理,著重指出了三元催化凈化技術及凈化器的出現給汽車材料和製造技術上帶來的一些新要求,提出了清潔環保性能是今後汽車發展的重要方向。
  18. Abstract : this paper first discusses the optimum method of feature choice in the fuzzy recognition of tank under the condition of different noise source interference. then, through quantitative analysis of the peak features of power spectrum and auto - correlation spectrum, it analyzes and contracts the recognition effects of tank under the condition of multi - source interference. finally, it gives the profitable results

    文摘:對不同聲源干擾條件下坦克識別的特徵優選方法進行了深入的研究和探討,在此基礎上,通過雙譜譜峰特徵的定量分析,對多源干擾時的坦克識別效果進行了分析對比,得出了有益的結論。
  19. Abstract : the thesis discusses the causes of measurement errors in auto - capactity measuring instrument circuit and introduces several effective methods to minimize measurement errors

    文摘:本文就自動電容測量儀電路造成測量誤差的原因進行了討論,同時介紹了減小測量誤差的幾種有效方法。
  20. Abstract : this paper introduces the working pinciples of the electro - economizer, in which either alternating or direct current voltage can be input with the adaption to the operating coils of contactor, steady direct current is output, and voltage auto - converting is absorbed and kept withno contacting point

    文摘:論述了與交流接觸器操作線圈適配的交直流輸入(操作)電壓通用,恆直流輸出,吸合與保持電壓無觸點自動轉換節電器的工作原理。
分享友人