axial core 中文意思是什麼

axial core 解釋
精子軸心部
  • axial : adj. 1. 軸的。2. 成軸的。3. 軸周圍的，軸向的。adv. -ly 在軸的方向，與軸平行地。
  • core : CORE ＝Congress of Racial Equality 〈美國〉爭取種族平等大會。n 1 果心。2 （事物、問題等的）中心，...
  1. ( 3 ) by choosing core faultage of axial site in luohu fracture zone i. e. geological cross section in huangbeiling faultage f8 as geological model and utilizing finite element numerical method, change tendency of huangbeiling faultage f8 under self - weight stress and building loads is stimulated. and long - term development trend of fracture zone is also predicted, which has an important guiding meaning for works of geological disaster prevention in district of luohu jiancheng

    （ 3 ）選取羅湖斷裂帶軸部的核心斷層?黃貝嶺f8斷層地質剖面作為地質模型，利用有限元數值方法模擬了黃貝嶺f8斷層在自重應力和建築物荷載共同作用下的變化趨勢，預計出斷層帶的長期發展趨勢，這對羅湖建成區的地質災害防止工作有重要的指導意義。
  2. The axial magnetic field distribution on center surface of contact gap and contact piece are calculated when the current is at peak. it can be found that the intensity of axial magnetic field and radial magnetic field uniformity are strengthened after the iron core is put into, this helps to improve the stability of the vacuum arc

    計算了電流峰值時觸頭間隙中心平面和觸頭片上的縱向磁場分佈，可以看出加入鐵芯后縱向磁場強度和徑向磁場均勻性增強，這有利於提高真空電弧的穩定性。
  3. Predictions were made on the ductility of the joint core when shear compression ratio, reinforcement contant and axial force ratio were different

    進一步利用jap程序預測了不同剪壓比，不同配筋特徵值及不同軸壓比條件下節點區的延性變化規律。
  4. Based on measurement of strains of both horizontal stirrups in the joint core and longitudinal reinforcement passing througth the joint, in different stages, transfer mechanism and factors affacting seismic behavior of the joint, were analysed. under different shear compression ration, effect of axial force ratio on seismic behawior of the joint was also evaluated, static shear and seismic shear of the joint based on capacity design were investigated. on this basis, new governing criteria and conditions of seismic behavior of the joint were put forward

    通過對節點區水平箍筋以及貫穿節點梁、柱縱筋在不同受力階段應變的精細量測，對節點的傳力機理以及影響抗震性能的因素進行了分析研究；對不同剪壓比條件下軸壓比對節點抗震性能的影響規律進行了分析研究；對不同受力階段梁筋的粘結退化規律以及節點區的剪切變形進行了分析研究；對節點的靜力抗剪與建立在能力設計思路上的抗震抗剪問題進行了深入研究，提出了建立在新思路基礎上的節點抗震性能控制準則和控制條件。
  5. Based on the pseudo - static experimental results of nine abnormal joints, the damage process of abnormal joint is divided into four stages of original crack, entire crack, ultimate state and failure, the effect of axial force ratio, stirrup ratio and height of column section on seismic behavior of abnormal joint are discussed, the conclusion that anti - shear capacity of abnormal joint are studied in entire crack state by studying the minor core of abnormal joint is made, the calculating formula for anti - shear capacity of abnormal joint is proposed with a view to asymmetry in stirrup yield

    摘要根據9個鋼筋混凝土框架異型節點試件的擬靜力試驗結果，指出異型節點受力過程分為初裂、通裂、極限和破壞4個階段；討論了軸壓比、節點核芯配箍率、柱截面高度變化對異型節點抗剪性能的影響；提出應考慮節點核芯區箍筋屈服的不均勻性並在通裂狀態下以「小核芯」為分析單元來研究此類節點抗剪承載力的建議；最終給出了異型節點抗剪承載力的計算公式。
  6. The finite element model is built for the axial magnetic field of the cup vacuum interrupter contacts without iron core and with two kinds of iron core. the calculation and analysis of the three - dimension axial magnetic field distribution characteristic on the axial magnetic field of cup the vacuum interrupter with iron core are carried out for the first time

    對無鐵芯及兩種鐵芯結構的杯狀縱磁真空滅弧室觸頭建立了有限元模型，首次對有鐵芯的杯狀縱磁真空滅弧室進行了三維縱向磁場分佈特性的計算與分析。
  7. Axial pull - out test of core concrete of prestressed concrete pipe piles and analysis of stress at the pile end

    填芯混凝土軸拔試驗及樁端應力分析
  8. Relaxation factors are adopted. a program is produced to simulate swirling air flow in a horizontal straight pipe and compare with experiment data. the simulation prove that the modified k - model can predict the core, annular and wall regions near entrance and axial velocity far from entrance, but it ca n ' t predict tangential velocity well in weak swirling area far from entrance

    編程計算水平圓管內螺旋氣流的流動參數並與實驗數據對比，結果表明修正-湍流模型在近入口處基本上能預測出中心區、環形區和近壁區的流動特性，在遠離入口弱旋流區域對軸向速度的預測符合實際情況，但是出現對周向速度修正過大的現象。
  9. Scm as control core applied in the variable axial piston pump is introduced briefly in the paper, including structure and work principle

    摘要本文介紹了基於單片機控制的數字變量軸向柱塞泵的結構組成、工作原理，並理論推導了數字泵的輸出流量與輸入脈沖信號呈線性關系。
  10. ( 2 ) based on deterioration model of owerage bond stress of beam reinforcement accounting for effect of axial compression ration and number of displacement loops, and stress - strain relationship of the concrete in the joint core accounting for effects of both softening and confinement, the modified compression field theory was employed to simulate behavior of the joint core under loading reversals. analysis by means of the program jap on the tested specimens in this paper and those obtained from other researchers produced consistent results

    根據本文建立的考慮軸壓比和位移循環次數影響的梁筋平均粘結應力退化模型和考慮軟化效應、約束效應的核心區混凝土應力應變關系，通過在試驗中得出的節點核心區混凝土、箍筋、節點正面、背面柱筋在反復荷載下的受力特點，利用斜壓場理論模擬節點核心區在反復受力過程中的受力狀態。
  11. This paper has studied the structure of the one - sixth turn axial magnetic field of the cup vacuum interrupter with iron core and distribution of the axial magnetic field. the axial magnetic field reduces loss of radial energy of arc post plasma, and makes the arc voltage reduce

    本文著重研究了帶鐵芯的1 / 6匝杯狀縱磁真空滅弧室的結構以及縱向磁場的分佈，縱向磁場的引入降低了弧柱等離子體徑向能量損失，使電弧電壓降低。
  12. Axial load carrying core

    軸向負荷型芯
  13. This paper conducts a study of the influence of core concrete performance upon the stability factor of axially compressed medium long concrete - filled steel tube column on the basis of comparison of the axial compression test results of long column made up of common concrete filled steel tube and medium long column made up of lightweight aggregate concrete - filled steel tube, and in accordance with analysis of the constitutive relation curves between both the common and lightweight aggregate concrete

    摘要通過對鋼管普通混凝土長柱和鋼管輕集料混凝土中長柱的軸壓試驗結果的比較，結合對普通混凝土和輕集料混凝土的本構關系曲線的分析，研究了核心混凝土性能對鋼管混凝土軸壓中長柱穩定系數的影響。
  14. The calculation to the eddy current on the contact surface and axial magnetic field of contact surface and center surface of contact gap are carried out while the current is at zero. after the iron core of ring type is put in, the eddy current on the contact surface will be increased, the axial magnetic field that the eddy current creates will be also increased

    對電流過零時觸頭表面的渦流和觸頭表面及觸頭間隙中心平面上的縱向磁場進行了計算，加入圓環型鐵芯后觸頭表面的渦流增大，渦流產生的縱向磁場增大，在鐵芯中開槽后渦流的平均水平降低，縱向磁場平均值降低。
  15. The hysteresis time of the axial magnetic field in the structure without iron core when the current is at zero is shortest. after the iron core is put into, the hysteresis time will be increased greatly, but if iron core is slotted, the hysteresis time will be decreased

    最後計算了電流過零時的縱向磁場滯后時間，無鐵芯結構縱向磁場滯后時間最短，加入鐵芯后滯后時間明顯增大，在鐵芯中開槽可使滯后時間縮短。
  16. As for the limit bearing capacity formula of the concrete filled steel tube long column subjected to axial compress, we lead to the tangent modulus and the conception of metal material. the high strength core concrete is divided into two kinds of situations : single axial loading conditions and triaxial loading conditions

    在推導鋼管混凝土軸心受壓長柱臨界承載力公式時，論文利用材料的切線模量，分別推導了鋼材和混凝土的切線模量公式。對于混凝土的切線模量，本文分成單向受壓和三向受壓兩種情況考慮，並分別得出切線模量公式。
分享友人
分享到 Line

分享到臉書