band compensation 中文意思是什麼

band compensation 解釋
頻帶補償
  • band : n 1 帶,繩;帶形物;箍;箍條;嵌條;鑲邊;鋸條; 〈pl 〉 (法官等的)寬領帶。2 束縛,羈絆;義務;...
  • compensation : n 賠償;補償(金);報酬 (for);〈美國〉薪水,工資 (for); 【機械工程】補整;【造船】補強。com...
  1. The system exhibits fast response for the load current disturbance and the system always operates at discontinuous conduction current mode so that no slope compensation is required and high efficiency will be achieved when driving 4 leds. the design and analysis of sub - block circuits are provide in the thesis where band gap reference, oscillator, current sensing and over current protection, led load current

    本文完成了各個單元電路的分析與設計,著重分析了帶隙基準源、振蕩器、采樣和過流保護、負載led電流控制和開負載保護五個子電路,對其餘子電路也作了簡要分析。
  2. The clues and techniques to improve the resolution of data processing are 1 ) removing the affection of near surface factors on data acquisition, including static correction and noise eliminating technique etc, 2 ) broadening the frequency band of pre - stack seismic data, including amplitude compensation and pre - stack deconvolution etc, 3 ) improving s / n ratio of high frequency and weak reflection signals through multiple coverage with high precision velocity analysis, residual static correction and high - order nmo, raising " dead line of high frequency reflection ", and 4 ) identifying post stack effective reflection frequency band, enhancing dominant frequency and so on

    主要包括:消除近地表因素對資料採集的影響,包括靜校正和噪音壓制技術等;疊前拓寬地震資料領帶,包括振幅補償和疊前反褶積技術等;藉助高精度速度分析、剩餘靜校正和高次項nmo技術,通過多次覆蓋疊加,消除資料中隨機噪聲干擾、提高資料信噪比,尤其是高頻端反射信息的信噪比,改善高頻反射和弱反射信號信噪比,提高「高頻反射死亡線」 ;疊後有限反射頗帶識別、抬高優勢頻率等。
  3. Theory analyze of base - band shaping filter is delivered and adaptive compensation of imperfections in modulators are discussed

    對方案中基帶成形濾波、調制誤差自適應補償技術進行輸入理論分析。
  4. Realization of the wide - band shaping filter in baseband is carefully analyzed, and then a low - cost realization method is brought forward. furthermore, through shaping filters, i / q route self - synchronization and compensation and revise of the nonlinearity and the imbalance of amplitude and phase of the modulation circuits are advanced

    分析了基帶寬帶數字成形濾波器的實現難點,提出了低代價的實現方法,並利用成形濾波器解決了調制端i / q自動同步,調制電路的各種非線性和幅相不平衡的補償校正等問題。
  5. The frequency band extension with time base jitter is also studied by simulation. the results show that the compensation of time jitter can reduce the error of signal and then increase the accuracy of frequency band extension

    對時基抖動的頻帶展寬技術的模擬結果表明,通過擴展的概率密度法對時基抖動的補償,可以減小信號的誤差,因而提高頻帶展寬的精度。
  6. The time base drift deduced by the change of temperature is discussed particularly and the compensation method of it is analyzed. finally, we also studied frequency band extension under time base distortion condition by simulation. the results show that the compensation of time base distortion can reduce the error of signal and then increase the accuracy of frequency band extension

    首先,介紹時基失真的相關概念及其對測量信號的影響;其次,對時基失真特性測量的不同方法進行了理論分析和比較,並對分析信號法進行了模擬研究;再次,對時基失真的補償方法進行分析和模擬研究;並專門對溫度變化引起的時基漂移及其補償方法進行了簡要分析;最後,對時基失真條件下的頻帶展寬技術的模擬表明時基失真的補償可以減小信號的誤差,因而提高頻帶展寬的精度。
  7. Effect of error auto - compensation and error of the extremely narrow - band interference filter in dwdm system

    Dwdm極窄帶干涉濾光片的誤差與自動補償效應
  8. At the same time, the possibility of using nonlinear optics in widening the detecting wave band of hartmann - shack wavefront sensor is exploringly discussed. adaptive optics guarantees the beam quality of laser projecting system. beam cleanup, atmospheric turbulence compensation and correction of any disturbance and fabrication error in the light way are required to promise a near diffraction beam, but normal adaptive optics system can only correction one of them

    自適應光學進行光束大氣傳輸波前畸變校正時,要求系統必須能進行光束凈化和校正大氣湍流造成的波前畸變,並且能夠同時有效地克服發射系統製造誤差、重力變形以及光路內部氣體擾動的影響,得到接近衍射極限的輸出激光光束。
  9. Then, after the structure and characteristic of awg is described in brief, we put emphasis on the deduce of the dispersion equation of ufbgs in the vicinity of its reflection band gap ( rbg ) in light of coupling theory. in terms of this equation, the dispersion compensation of the optical signal in every channel in the wdm system, which has eight channels, is calculated and analyzed theoretically. during the course, some important parameters of ufbgs in the compensator are computed

    在簡要敘述了陣列波導光柵的結構及其特性后,著重從光纖光柵耦合波理論導出了均勻光纖光柵在反射帶隙( rbg )外附近的色散特性方程,並根據這一特性方程,對8通路的wdm系統中各分亡巴八碩士學位論文tinv坯1 : e 』 sthe狠波光信號的色散補償進行了數值計算與分析,由此確定補償器中各均勻光纖光柵的相關參數。
  10. The new standpoint that ip - iq detecting method based on three - phase three - wire system can be directly used in three - phase four - wire system is presented and proved. generalized harmful currents compensation based on multilevel converter and multi - band hysteresis pulse width modulation with timer are presented

    提出並證明了基於三相三線制系統的ip - iq檢測法可直接用於不平衡三相四線制系統有害電流的檢測,無需事先剔除零序電流的新觀點。
  11. A double - pass erbium - doped fiber based broadband ase source by utilizing c - band ase compensation

    補償的雙通摻鉺光纖寬帶光源
  12. The structure and character of deformable mirror were analyzed, and the conflict between the deformation band and the pitch of deformable cells was pointed out. the " two - time compensation " wave - front correct mode was introduced to settle that conflict. the method for allocating wave - front aberration and designing static corrector was found, and the " two - time compensation " wave - front correct mode was validated by simulation

    分析了變形鏡的結構特點,初步給出了變形鏡本身驅動單元數與校正量之間的制約關系;引入「二次補償」波前校正方案,解決了變形鏡校正量有限與高功率固體激光系統波前誤差起伏量大的矛盾,建立了波前校正對象優化分配、靜態校正器優化設計等細節過程所需要的方法,通過模擬模擬驗證了「二次補償」波前校正方案對于降低變形鏡校正量要求和放寬光學元件加工精度的作用; 5
分享友人