beam section 中文意思是什麼

beam section 解釋
橫梁材
  • beam : n 1 梁，棟梁，桁條；（船的）橫梁。2 船幅；（動物、人的）體幅。3 （秤）桿，杠桿，（織機的）卷軸，...
  • section : n 1 （外科、解剖的）切斷；切割；切開。2 【外科】切片，【金相】磨石。3 （果子的）瓣。4 【數學】截...
  1. The thesis has summarized the development of the oblique - pull bridge, its construction technology and the importance of bridge construction control, then has introduced project general situation, and has narrated detailed regulation, organization construction, the major work and difficult part of this bridge construction control. the following is the key part of this thesis, firstly, it has introduced the experiment work of early stage, structural calculation and its theoretical result : the absolute altitude of each operating mode, the absolute altitude of building mould in each section and the absolute altitude after pouring concrete ; then, it has discussed the method and content of the line shape control of the main beam, actual absolute altitude of building mould is put forward, and it has described the method of structural stress monitoring, how to arrange measure point and collect data, and how to analyze data. it has also narrated the method of rope force detection and structural temperature inspection

    本論文在總結了斜拉橋的發展及其施工工藝，並指出了橋梁施工控制的重要性之後，簡要的介紹了工程概況，敘述了炳草崗金沙江大橋監控細則、組織機構及監控的主要工作和難點部分；論文的核心部分，在介紹了炳草崗金沙江大橋施工控制與監測工作的前期實驗工作和施工各工況標高、各節段支模標高、澆注混凝土后的標高的結構計算和其理論計算結果之後，詳細論述了主梁的標高線形控制方法和內容，實際支模標高的提出，結構應力監控的方法、布點、測讀及其對測讀數據的合理分析方法，索力檢測和結構溫度監測的方法。
  2. From the analysis, some suggestion about joint rigidity design is put forward : 1. joint initial rigidity can be enhanced within the limited range when to increase end - plate thickness ; 2. the rigidity and ultimate moment can be enhanced obviously when to adopt the beam with inclined section or to add axilla at the connections between beam and column ; 3. withm the permissive construction condition, exteriorly extended end - plate inclinedly placed is suggested to be applied firstly ; 4. when the rate of joint rigidity to beam rigidity, that is called, is less than 0. 1, the joints can be regarded as zero - rigidity joints ; on the other hand, if is more than 26, it is rigid connection joints

    採用斜截面梁並在樑柱交接處局部加腋能明顯提高節點剛度和梁的抗彎能力； 3在允許的施工條件下，應優先採用外伸式端板斜放節點，有利於提高節點剛度，進而提高節點的抗彎能力； 4節點剛度與其連接構件的剛度比值0 . 1時，可按鉸接節點設計； 26時，可按剛接節點設計。
  3. The slope at any section of the actual beam is equal to the shear at corresponding section of the conjugate beam.

    實際梁任何部位的角變等於共軛梁相對應部位的剪力。
  4. The bents supporting the four continuous 工 beam plate girders have a cross section shaped like a box.

    構架支承著四片工字型板梁，構架的截面為箱型。
  5. In the section 3, we calculated the threshold and efficiency of double resonance oscillator ( dro ) in plane wave of clbo ; we also got the efficiency curves of clbo in gaussian beam

    第三章分析和數值模擬計算了平面波雙諧振情況下clbo晶體的振蕩閾值和轉換效率曲線，同時給出了高斯光束的轉換效率曲線並與bbo晶體進行了比較。
  6. Strengthening ill geologic section road chasm side slope with prestressed achor pile grid beam

    預應力錨桿格梁加固不良地質地段路塹邊坡
  7. Determine natural frequency of the symmetrical section timoshenko deep - beam

    深梁結構固有頻率的確定
  8. Optimization design of cross section of rc frame beam

    鋼筋混凝土框架梁截面的優化確定
  9. This paper presents the structural design of the main bridge of lhasa river bridge, makes a deep - going study of the key techniques for design of the bridge, such as the reasonable span length ratio of each span of the 5 - span girder and arch hybrid structure, mechanical behaviour of the dual arch ribs, and section of the continuous girder tie beam, and also works out rigidity and stress conditions of the continuous girder tie beam and stress conditions of the concrete - filled steel tube arches of the main bridge

    摘要介紹了拉薩河特大橋主橋結構設計情況，對於五跨梁拱組合橋梁各孔跨合理的跨度比、疊拱的受力行為及連續梁系桿截面形式等設計中的關鍵性問題進行了深入的研究，給出了主橋連續梁系桿的剛度和應力情況、鋼管混凝土拱的應力情況。
  10. Error : element 16 is close to parallel with its beam section axis

    使用梁單元出現如下錯誤，是什麼原因？ ？
  11. The formula of the grid - beam section is deduced according to the displacement of the beam

    根據梁的位移，推導出確定井字梁截面的公式。
  12. Two hypothesises, different from the traditional viewpoints, about stress distribution in beam section at the connection of beam and end - plate are presented by author to determine the ultimate moment of end - plate connection

    其計算過程分為兩步： （ 1 ）計算梁受拉翼緣的極限拉力； （ 2 ）計算端板連接的極限彎矩。
  13. The work done in this paper is mainly as follows : ( 1 ) the wide beam should intrude to the wall at some length to make the flexural stress uniform along beam section width, thus make full use of the beam ' s bearing capacity and avoid the shear failure in the concrete joint. and it also prevents stress focus and concrete crack in the local shear wall

    關于寬梁與薄墻肢節點，可以得出以下幾點初步結論：寬梁應該深入墻肢一定的深度，以使寬梁截面的彎曲應力沿著梁截面寬度分佈均勻，充分發揮寬梁的抗彎能力，同時避免節點區混凝土的剪切失效，也避免剪力墻的局部因為受到的應力過大而拉裂。
  14. Elastic theory and plastic theory are adopted in the analysis of the two section composite beam. elastic theory suggests, on the condition of the same steel beam section size, the composite beam for the floorslab is suited lower flanges convertion section stiffness cuts down by 75. 1 %, elastic limit bending resistant capability cuts down by 47. 9 %, than the composite beam for the floorslab is suited on the top flange. it s conversion section stiffness is lifted 8. 0 %, elastic limit bending resistant capability is lifted 0. 20 %, than the steel beam

    彈性理論分析的結果表明，在鋼梁截面大小相同的條件下，樓板位於鋼梁下翼緣的組合梁和樓板位於鋼樑上翼緣的組合梁相比，其換算截面剛度降低75 . 1 ，梁的彈性極限抗彎承載力降低47 . 9 ，樓板位於鋼梁下翼緣的組合梁和純鋼梁相比，其換算截面剛度提高8 . 0 ，梁的彈性極限抗彎承載力提高0 . 2 。
  15. The basic theory and step of whole process analysis of reinforced concrete beam section flexural rigidity is stated, the realization program is worked out and the academic example is analyzed. 4. based on the static - state load test result of two practical projects, the application of the reinforced concrete beam system bridge structure disease examination and structure damage evaluation method is stated, and satisfaction result is gained

    1 、綜述了當前混凝土橋梁結構檢測及損傷識別的各種方法體系，並簡要評價了各方法體系的應用與不足； 2 、論述了基於靜載試驗的梁分段剛度系統識別的基本原理，編制了實現程序，並進行了數值算例分析，提出基於本原理的梁橋結構損傷識別與結構評價方法體系； 3 、闡述了鋼筋混凝土梁截面抗彎剛度全過程分析的基本原理和方法步驟，編制了實現程序，並進行了相關算例分析； 4 、結合兩片工程實例梁的靜載試驗，詳述了梁橋結構損傷識別與結構評價方法的應用過程，得到了預期的效果。
  16. Based on the experiment results, the damage form of abnormal exterior joint are summarized, characteristics of hysteresis curve are studied, the effect of stirrup ratio and height of column section and beam section on anti - shear property of abnormal joint are discussed, working mechanism of abnormal exterior joint is researched, the conclusion that the anti - crack and bearing capacity of abnormal joint are studied by analyzing the minor core of abnormal exterior joint is proposed, the basic data is provided for the design formula of abnormal joints

    根據試驗結果，總結了異型邊節點的破壞形態，研究了節點滯回曲線的特徵，討論了節點核芯配箍率、樑柱截面高度變化對異型邊節點抗剪性能的影響，分析了異型邊節點的受力機理，提出應以「小核芯」為分析單元來研究此類節點抗裂和承載力的建議，為異型節點設計公式的建立提供了基礎數據。
  17. The section loss of steel bars and degradation of bond intensity were taken into consideration in this study in order to establish the finite element model of corroded reinforced concrete beam through simulating the bond slip behavior between steel bar and reinforced concrete based on nonlinear spring element

    摘要在考慮銹蝕引起的鋼筋橫截面損失和粘結強度下降的前提下，利用非線性彈簧單元模擬銹蝕鋼筋與混凝土之間的粘結滑移性能，建立了銹蝕鋼筋混凝土梁的有限元分析模型。
  18. Finally, by the analysis of the highness of beam - bridge, the most dangerous section and the abutment cons truction of the circular hole castellated beam, the design and calculating method of the beam is given to promote the application of the beam

    最後，通過對圓孔蜂窩梁的梁橋高度、驗算截面以及支座構造措施等的分析，總結出圓孔蜂窩梁的設計計算方法，以促進這種梁的設計與應用。
  19. Based on the research to the stability variable cross - section beam, the bending defection differential equation of the variable cross - section beam in critical state of bucking is established. according to the edge condition of the structure, the differential equation is solved and bucking equation of variable cross - section beam is created. we can get the algorithm which can be used to calculate the equivalent inertia moment of the variable cross - section lattice structure when it is regarded as constant cross - section of solid web beam

    對變截面格構式構件的穩定性計算進行了初步的研究，通過建立變截面構件臨界狀態下彎曲變形的微分方程，根據變形邊界條件，得到了兩端鉸支的變截面梁失穩特徵方程，提出了幾種特殊形式的變截面格構式構件等效為等截面實腹式構件時等效慣性矩的計算方法。
  20. According to the basic theory of the cement concrete and the properties of polypropylene fiber, the calculating formulas about beam for the normal section load _ carrying capacity and rigidity and ductibility are presented based on " the design code of concrete structure " ( gb50010 - 2002 )

    參照普通砼的基本理論，結合聚丙烯纖維砼的性能特點，在《規范》的基礎上得到了單筋矩形截面梁正截面承載力、剛度和延性的計算公式，並與試驗結果對比吻合較好。
分享友人
分享到 Line

分享到臉書