blend test 中文意思是什麼
blend test
解釋
混播試驗-
The v was tested by yjy stress transducer with mvad card by the methods of recording the deformation in the wideness and thickness direction of the specimens during the tensile test. a stable auxetic polyolefin blend with the minimal value - 1. 4 was observed after repeated test
採用附有mvad通道卡的yjy型片式傳感器，記錄試樣在拉伸過程中寬度和厚度方向的形變並根據泊松比的定義進行計算，反復實驗后獲得最小值為- 1 . 4的負泊松比烯烴共混體系。 -
After reference solution has been formulated and sensitivity has been adjusted and tested according to above mentioned method ( 3 ), take appropriate amount of test sample solution and reference solution, blend samples separately ; unless otherwise specified, recording time of the former should be 2 times of retention time of chromatographic peak of main component, measure peak area of each impurity on the chromatograph chart of test sample solution, and compare with peak area of main components of reference solution, then calculate content of each impurity accordingly
同上述（ 3 ）法配製對照溶液並調節檢測靈敏度后，取供試品溶液和對照溶液適且，分別迸樣，前者的記錄時間，除另有規定外，應為主成分色譜峰保留時間的2倍，測量供試品溶液色譜圖上各雜質的峰面積並與對照溶液主成分的峰面積比較，計算雜質含量。 -
When establishing the method, according to stipulations under each type, precisely weigh ( measure ) appropriate amount of impurity reference and component reference under test to formulate solutions testing impurity calibration factor, blend samples and record chromatograph chart, calculate calibration factor of impurity according to above mentioned method ( 1 )
在建立方法時，按各品種項下的規定，精密稱（量）取雜質對照品和待測成分對照品各適量，配製測定雜質校正因子的溶液，迸樣，記錄色譜圖，按上述（ 1 ）法計算雜質的校正因子。 -
The causation of main defects is analyzed from the view of design and improvements are suggested from the structural design, such as the test and determination of basic data of pavement design, rational selection of raw materials, adopting appropriate aggregate sizes, improving blend design method, rational selecting the thickness of asphalt layer and reinforcing the binding between the asphalt pavement layer and the base layer to further improve the operational function of the asphalt pavement and reduce the occurrence of traffic accidents
通過對高速公路瀝青路面的主要病害成因從設計角度進行分析，提出應從完善路面設計基礎數據的測試與確定方法、合理選擇原材料、採用合適的礦料級配、完善配合比設計方法、合理選擇瀝青面層厚度、加強瀝青面層層間及與基層的粘結等途徑完善瀝青路面結構設計，以進一步提高瀝青路面的使用功能，減少道路交通安全事故的發生。 -
The heat - resistance properties of pvc were increased after blend shown by the relative test
Dsc 、 tga 、 dtg等熱分析表明，共混后pvc的耐熱性能得到了提高。
分享友人