bottom flow 中文意思是什麼
bottom flow
解釋
底流-
A test analysis of open canal bottom coefficient of roughness anticlimax on turbulent velocity of flow and intensity of turbulence influence
明渠渠底糙率突減對紊流流速及紊動強度影響的試驗分析 -
Some researchers have made study on this subject, such as the generation and evolution of frazil ice, shore ice, bottom ice, ice cover and ice jam, the resistance of freeze - up river, flow capacity and variation of water stage
國內外一些學者通過原型觀測，試驗和數值模擬的方法對水內冰，岸冰，底冰，冰蓋和冰塞的生成和演變，封凍河道的阻力、過流能力和水位變化等有關問題進行了研究。 -
For a time, surface and subsurface current are in opposite directions ; flow is seaward at the surface and landward near the bottom
在一個時期，表層和次表層的水流方向相反；表層水流向外海方向流動，靠近底層的水流則向陸地方向流動。 -
For a time, surface and subsurface currents are in opposite directions ; flow is seaward at the surface and landward nearthe bottom
譯為:有一個時期，表層和次表層的水流方向相反，表層水流向外海方向流動，靠近底層的水流則向陸地方向流動。 -
Sulfide further accumulates where depressions in the bottom of the sill interfere with the flow system and act as natural riffles.
巖床底上如有陷穴，就起到天然溜槽的作用，干擾了巖流體系，使硫化進一步堆積。 -
In different in terne die travel, the metal flow characterize in warm extrusion forming processes and the affection for the flow of metal stage which made by the difference between the blank bottom altitude and the axial direction limiting size in warm extrusion forming technique have been analysed we have gotten the equivalent strain field and the velocity field and other field variable that the blank in different in terne die travel and the die travel - load curve. at the same time, we have analyzed the contributing factor for the oil pump stator forming process optimized and achieve thereasonable die parameter for the war m extrusion forming finally, the optimized technics parameters were used into pilot production, then the qualified oil pump stator forging were produced, the analog results were compared with those of pilot production
論文具體分析研究了不同成形工藝過程中金屬流動的特點，並對不同凸模行程下溫擠成形過程中的金屬流動特點、坯料連皮厚度（底部高度）與溫擠壓成形工藝中的軸向界限尺寸的差值對金屬變形階段的影響進行了分析，獲得了坯料在不同凸模行程下的等效應變場、速度場等場變量及凸模行程-載荷曲線，同時對油泵定子成形過程的影響因素等進行了分析，優化並獲得了合理的溫擠成形工藝及模具參數。最後，利用模擬優化獲得的各項工藝參數進行生產實驗，得到實際生產出的合格油泵定子件，並將模擬結果與生產實驗結果進行比較。 -
What ' s more, we put forward some experienced formulas on the basis of the cortical analysis. the result of the research show that by installing diffluent piers with low ridge, we can eliminate the root of oscillatiny water jump, perfect the energy dissipation effect of water jump, also, we can improve the flow condition of down - stream. the fact that the main flow of down - stream is in the middle, not only effectively lower the speed of the bottom flow in the ridge rear, alleviate the erosion to the river bed, but also avoid the heavy wave resulted from the main flow in the surface, thus improve the surface wave of down - stream obviously. we can work out the body style parameters of diffluent piers with low ridge according to the project flow condition and experience formulas, and then reckon the down - stream surface wave condition for the protected building of the down - stream bank
研究結果表明：設置低坎分流墩后，消除了擺動水躍水舌擺動的根源，提高了水躍的消能效果，改善了下游水流流態。下游水體的主流在中部，既有效的降低了坎后水流底流速，減輕水流對河床的沖刷，又避免了主流位於表面導致波浪過大的結果，下游的水面波浪明顯得到削減。依據經驗公式，可根據工程水流條件設計出低坎分流墩的體型參數，進而估算出下游沿程的水面波浪，為下游岸邊的砌護提供依據。 -
The flow behavior of resin, water outlet structure at bottom of the mixed bed, water inlet position of hydraulic transportation, water intake ratio, and pneumatic transportation etc. have been analysed, giving out optimal selection of them combined with reality in the field
對樹脂的流動性能、混床底部出水結構、水力輸送進水位置、進水比例以及氣力輸送等進行了分析，並結合實際給出了最佳選擇。 -
Compared with measured data, this equation can describe the sediment concentration distribution better both in main flow region and near - bottom region
與實測資料對比表明，該公式能更好地描述包含主流區與近底流區在內的泥沙含量分佈規律。 -
Drop line vertically down and read flow rate from bottom of chart
沿著垂直線向下，從圖表底部讀出流量。 -
In order to solve the problems effectively, under the auspices of 863 plan in china, the synthesis diagnosis has been carried by means of measuring and numerical imitating the combustion chamber of refining column, and some conclusions is such as : ( 1 ) through measuring the temperature and combustion in the burning chamber of the refining column, the result shows the temperature difference on the same level is more than that in height direction, and there is a few of co in bottom of burning chamber. ( 2 ) in order to ensure normal work of flue system in lead column in the course of zinc refining, theoretic calculation and measure about the flow resistance of exhaust gas are carried through. the results of study reveal that drawing out force of chimney is inadequate, which is mainly caused by illogicality of flue construction
在研究過程中，採取了現場實測和數值模擬手段對韶關冶煉廠鋅精餾鉛塔燃燒室及排煙系統進行了綜合診斷，具體結果包括如下： （ 1 ）完成鋅精餾鉛塔燃燒室內溫度測試以及燃燒狀況的測試，結果發現：鉛塔燃燒室內水平方向的煙氣溫度並非均勻，而且其溫差比上下方向的溫差更大，以及鉛塔燃燒室尾部存在co未燃燼問題； （ 2 ）為了保證鉛塔煙氣系統的正常工作，對煙道系統的阻力進行了理論計算及測試分析，結果發現：鋅精餾鉛塔煙氣系統中煙囪抽力不夠，這主要是煙道結構不合理所造成的。 -
Effects of maintenance and raise of water level at yichang station by river bottom protection and roughness addition method and pool back - fill method in the reach from yichang to zhicheng of the changjiang river are calculated and compared by using a 2 - d flow numerical simulation method
摘要運用二維水流數值模擬方法，計算比較了在宜昌枝城的長江河段內選取重點控制河段，進行護底加糙及回填深槽對維護並抬高宜昌水位的效果。 -
The theoretical study of the recovery percent vs. water cut of thin and bottom water reservoir in luliang oilfield is based on developing its geologic and flow models, obtaining oil - thickness ratio, oil - water viscosity ratio, relative permeability curve parameter and chart of effect of bottom water toning, etc., on water - yielding pattern of the reservoir
摘要在建立了陸梁薄層底水藏地質及滲流模型基礎上，採用理論研究的方法，研究了薄層底水油藏采出程度與含水率關系式，並獲得了油厚比、油水粘度比、相滲曲線特徵參數以及底水錐進等對油藏產水規律的影響關系圖版。 -
Up - flow filtration with coarse sand media, the water intaking from the bottom layer where the particle diameters of coarse media were the widest and outputting from the surface layer where the particle diameters of coarse media were the thinnest in the single media, was studied theoretically and experimentally in this research. it solved the difficult technical problem of reverse grain filtration
本文對粗石英砂濾料上向流過濾技術進行了理論和實驗研究，在單一的濾層中待濾水循粒徑最粗的底層進，從粒徑最細的表層出，攻克了「反粒度過濾」的關鍵技術。 -
For both newtonian flow and non - newtonian flow, the vortices are generated when the waviness of the bottom profile is beyond a critical number. by increasing the waviness, a second vortex can be generated. with the increasing of reynolds number, the symmetry of the streamlines at re = 0 is destroyed and the vortices are sloped and become larger
當波形板的波動度超出臨界值，波形板壁面上的流動出現流線分離，流動中有渦生成;增大波動度，流動中出現第二個渦; re = 0 ，流線在流場中對稱分佈;雷諾數增大，流線駐點在水平方向出現位置偏移，渦的范圍增大;對于非牛頓流體，隨著剪切變稀指數的減小，渦的作用范圍減小。 -
Effects of flow patterns on changes of bottom topography in wake of square cylinder
基於高頻輪軌作用的波浪型磨損研究 -
This kind of instability bulk movement is induced by wave cyclic loading, as a result the slope of bottom bed decrease, water depth increase, and instability bulk movement has the character of subregion, regularity and head erosion, thus it will influence evolvement of region of interest landform, and change flow field and bottom stratum condition continually, so will lead to dynamic influence on structure foundation soil
這種不穩定塊體運動由波浪循環荷載誘發，其結果使底床整體坡度減緩，水深加大，而且不穩定的塊體運動具有小區域、多發性和溯源侵蝕的特點，將繼續影響著海域以後的水深地形的發展演化，並不斷改變著該區的流場與底床地層條件，對構築物地基土的穩定性產生著動態的影響。 -
Drainage domain of partial penetration gas well in bottom water reservoirs consists of the following two parts : ( 1 ) non - darcy binomial radial flow near the well ; ( 2 ) three dimensional darcy flow in areas far away from the partial penetration gas well due to bottom water drive
摘要底水打開不完善氣井的滲流是由井附近區域遵循二項式徑向流規律的非達西流動及此區域外遵循由底水驅動向不完善井三維達西流動兩部分組成。 -
A conclusion is drawn that dust pollution of coal warehouse bottom is caused by haulage wind flow, inducd wind flow and impact wave wind flow
研究發現，毛煤倉倉下粉塵污染主要是由皮帶牽引風流、落料誘導風流和空氣沖擊波風流造成的。 -
The local energy dissipation of particles caused by the resistance decreases linearly with the increase of the height in the bottom flow region
顆粒因阻力作用在就地損耗的能量e在底部流區隨高度的增加而線性減小。
分享友人